4. What is the rate of heat transfer by radiation, with an unclothed person standing in a dark room whose ambient temperature is 24°C? The person has a normal skin temperature of 32°C and a surface area of 1.60 m?. The emissivity of skin is 0.95 in the infrared, where the radiation takes place.

Q: Show how it did derive or get the answer to S and R.

A: There is one material balance and one component balance. The unknowns are S and R . These will be ob...

Q: Balance Fe+KMnO4+H2SO4-->FeSO4+MnSO4+K2SO4+H2O using algebraic method

A:

Q: Pipeline that carries C3H8 propane gas at a pressure of 10 bar(abs) and a temperature of 30°C with a...

A: Let d be density of gas=17.5kg/m^3 D diameter of pipe mass flow rate =2kg/s diameter of 12 inch sche...

Q: Carbon dioxide at 200 kPa, 10°C flows at 1 kg/s in a 0.25-m2 cross-sectional area pipe. Find the vel...

A: Given data: Pressure of CO2 = 200 kPa T = 10 0C Mass flow rate = 1 kg/s Cross-sectional area of pipe...

Q: 1: In the sweetening MEROX process for kerosene the mercaptans are converted into (a) Sulpher (b) Di...

A: 9) Hydrocracking and the hydrotreating process have the same objective to break up larger feedstock ...

Q: Q4: The process shown in figure below is the dehydrogenation of propane (C3HS) to propylene (C3H6) a...

A: The conversion of propane percent given is the conversion per pass. The flow rate balance is applied...

Q: Find the principal roột of f V1- (2+ 4i)“ 5.0997 + 1.9513i 4.0777 - 1.513i 4.0997 - 1.9513i - 4.0997...

A:

Q: 1. Which of the following conditions has a negative entropy? Smelting gold at high pressure and high...

A: Given thatwe have to choose correct option in which case negative entropy. 1.As we know that for per...

Q: It was found that, Van Laar model fits the behavior of the system at temperature and pressure of 65 ...

A: Given data: Temperature = 65 0C Pressure = 101.325 kPa

Q: QUESTION 1 It is observed that a fluid has a pressure of 1 standard atm, or 101.325 kN/m3, and that ...

A: Given data: Pressure of fluid= 1 atm or 101.325 kN/m2

Q: explain all the technological steps involved in the processing of mango juice without pulp

A: All the technological steps involved -Production of mango juice without pulp

Q: When you convert a certain value of ° C to ° F, you have found out it is just simply numerically the...

A: When we convert into Degree to Fahrenheit then we have to multiply the temperature in degrees Celsiu...

Q: 4-A gas at 250 K and 15 atm has a molar volume 12 per cent smaller than that calculated from the per...

A: This question is based on thermodynamics. Data given :  Temperature , T  = 250 K Pressure , P = 15 a...

Q: 7. A food processing plant has an existing 4,550 gallon tank that they want to start a new batch che...

A: Note: Note: We are authorized to answer one question at a time, since you have not mentioned which q...

Q: The 800-N force F is applied to the vertical pole as shown. y 30° F 30° it

A: Given data: F=800 N Unit vectors in x axis i and in y axis j

Q: 04: True or False (10 Mark) 1. Solid waste comprises all the waste arising from human and animal act...

A: As Per Bartleby multiple sub-parts or True/false question Guidelines, we are supposed to answer only...

Q: Need asap show complete solution

A:

Q: 3. What missing product in each of these fission products? 235 U + 92 1 n 93 ? + 38 Sr +3n a. 235 U ...

A:

Q: 3. A gasoline can be represented by the formula C,H16. a) Write the theoretical combustion equation ...

A:

Q: Which is most likely soluble in water? O none of these O decane (C1OH22) O octane (C8H18) O CBr4 O C...

A:

Q: Explain what composite materials are and what characteristics they must have.

A:

Q: A series of solutions containing NaOH, Na 2c03 and NaHCO3, alone or in compatible combinations, were...

A:

Q: A stream of 0.2 kg/s of dry air at 45ºC and 10% relative humidity is mixed with 0.3 kg/s of dry air ...

A: Given Dry air-1 m1=0.2 kg/s T1=45℃ Realtive humidiy,φ1=10% Dry air-2 m2=0.3 kg/s T2=25℃ Absolute ...

Q: Calculate the percentage concentration if 37 g of potassium chloride are contained in a 700- mL solu...

A: Given Data: Mass of potassium chloride (KCl)= 37 g Volume of the solution= 700 ml

Q: Exercise (Given the equation) 1, A + 2B →C

A: Given equation, A+2B→→C (a) rate of reaction of different components is given by, (-rA)=-1VdNAdt(-rB...

Q: ESP. Estimate the overall width, length and height for a 99.4% ESP treating 30,000 m3/min of gas. Wi...

A: Given data: Efficiency of ESP = 99.4 % Volumetric flow rate of gas = 30,000 m3/min Collection area =...

Q: Consider a double tube heat exchanger used to cool 3000 kg/h of a solution (Cp = 0.45 Kcal/Kg oC) fr...

A: Given data: Mass flow rate of a solution = 3000 kg/h Specific heat of solution = 0.45 kcal/kg.0C Tem...

Q: below

A:

Q: Acompound effuses through a porous cylinder 2 times faster than hydrogen. What is it's molar mass?

A: Given:  Rate Gas XRate Hydrogen  = 2 We know that, Molar mass of Hydrogen = 2 g/mol  

Q: cоmpute, (3 + 3і)° )-972 + 792i O 792 – 972i O 972 + 972i O-972 – 972i

A:

Q: V2cis(135°) Simpli fy, 2+2i

A: Given the complex function, Cisθ=cosθ+isinθ Now, 2cis(135o)2+2i=2(cos(135o)+isin(135o))2+2i 2-12+i12...

Q: 3.51 WP Referring to Fig. P3.51, water contained in a piston-cylinder assembly, initially at 1.5 bar...

A: Given Initially P1=1.5bar Quality=20% Patm=1bar Water converted to saturated vapor Question figure...

Q: Engine oil flows through a 50 mm diameter tube at an average temperature of 147°C. The flow velocity...

A: Given, Diameter D    = 50 mm = 0.050 m Average temperature Tm= 147°C Velocity U= 80 cm/s = 0.80 m/s ...

Q: 12-atoms at grain boundaries are ------chemically reactive than grains .themselves • less more • equ...

A: Answering: 12), 13), 14)

Q: Example 4.2. HNO, and 8 wt% water, by mixing You are asked to make 1,000 kg of the mixed acid contai...

A:

Q: A dead weight gauge with a 1 cm diameter piston is used to measure pressure very accurately. In a pa...

A: Given Data: Mass (m)=6.45 kg Acceleration due to gravity (g)=9.82 ms-2 Diameter of the piston (D)= 1...

Q: As one of the Intern at AAMJ Chemicals Fertiliser Kedah Sdn. Bhd., you are requested by the Plant Ma...

A:

Q: Suppose a membrane separator, operating at 8 atm and 350 °F, is used to separate the H2 and CO2. Ass...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for yo...

Q: The homogeneous and irreversible reaction A - B

A:

Q: The homogeneous and irreversible reaction A → B is to be carried out isothermally in an ideal and co...

A:

Q: 1- The rate constant for the decomposition of certain substance is 1.6 × 10-6s-1. C2H;Cl (g) → C2H4 ...

A:

Q: In a turbine, there is 150 m of steam entering at the top from its outlet. It enters at 5MPa, 450°C ...

A: Given data: Properties of steam at the inlet of turbine are, P1 = 5 MPa T1 = 450 0C h1 = 4000 kJ/kg ...

Q: Q2: A chemical engineer studied the relationship between production quality and cost, the results as...

A:

Q: Isothermal tubular reactor with first order chemical reaction Problem description: In a tubular reac...

A: A first-order reaction takes place in an isothermal tubular reactor or a plug flow reactor (PFR). rA...

Q: 7. Presence of aromatics in kerosene will result in..... .... .... 8. Major constituent of lean gas ...

A:

Q: QUESTION 4 a) List two (2) types of nucleophilic substitution reaction for alkyl halide. b) State th...

A:

Q: A furnace uses natural gas which consists of hydrocarbons. The flue gas analysis is CO2 - 9.5%, O2 -...

A: The atomic ratio of hydrogen to carbon in the fuel is ratio of hydrogen atoms and carbon atoms in re...

Q: Example 9 A copper surface area , A=100 cm“, is exposed to an acid solution. After 24 hour, the loss...

A:

Q: In a multicomponent distillation process, the following components are obtained according to their v...

A: Multicomponent distillation process is based upon the relative volatility of the components present ...