4. What is the velocity of a plane that traveled from 562 miles from Detroit to Mackinaw City in 1.36hrs? 5. Using the following position vs time graph, create the corresponding velocity vs time graph. Show your work for the corresponding time intervals: 0-2.5 hrs 2.5-4 hrs 4-6 hrs Position vs Time Velocity vs. Time 10 40 30 20 -5 10 -10 1 2 3 4 5 6 1 3 4 5 6 Hours Hours Position (m) Velocity (m/hr)

4. What is the velocity of a plane that traveled from 562 miles from Detroit to Mackinaw City in 1.36hrs? 5. Using the following position vs time graph, create the corresponding velocity vs time graph. Show your work for the corresponding time intervals: 0-2.5 hrs 2.5-4 hrs 4-6 hrs Position vs Time Velocity vs. Time 10 40 30 20 -5 10 -10 1 2 3 4 5 6 1 3 4 5 6 Hours Hours Position (m) Velocity (m/hr)

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter1: Introduction: The Nature Of Science And Physics

Section: Chapter Questions

Problem 9PE: Tectonic plates are large segments of the Earth's crust that move slowly. Suppose that one such...

See similar textbooks

Similar questions

A car is traveling at a speed of 33 m/s. (a) What is its speed in kilometers per hour? (b) Is it exceeding the 90 km/h speed limit?
What is a leap second, and why w it introduced into timekeeping practices by scientists in the 1 970s?
In 1967, New Zealander Burt Munro set the world record for an Indian motorcycle, on the Bonneville Salt Flats in Utah, with a maximum speed of 183.58 mi/h. The one-way course was 5.00 mi long. Acceleration rates are often described by the time it takes to reach 60.0 mi/h from rest. If this time was 4.00 s, and BL11t accelerated at this rate until he reached his maximum speed, how long did it take Burt to complete the course?
On May 26, 1934, a streamlined, stainless steel diesel train called the Zephyr set the world's nonstop long-distance speed record for trains. Its run from Denver to Chicago took 13 hours, 4 minutes, 58 seconds, and was witnessed by more than a million people along the route. The total distance traveled was 1633.8 km. What was its average speed in km/h and m/s?
. (a) Draw an accurate graph of the speed versus time for the train Problem 24. (b) Draw an accurate graph of the distance versus time for the train in Problem 24.
(a) Refer to Table 1.3 to determine the average distance between the Earth and the Sun. Then calculate the average speed of the Earth in its orbit in kilometers per second. (b) What is this in meters per second?
The kinematic equations can describe phenomena other than motion through space and time. Suppose x represents a persons bank account balance. The units of x would be dollars (), and velocity v would give the rate at which the balance changes (in units of, for example, /month). Acceleration would give the rate at which v changes. Suppose a person begins with ten thousand dollars in the bank. Initial money management, leads to no net change in the account balance so that v0 = 0. Unfortunately, management worsens over time so that a = 2.5 102 /month2. Assuming a is constant, find the amount of time in months until the bank account is empty
What is the speed of the bird in Exercise 2.4?
A student drives the 100-mi trip back to campus after spring break and travels with an average speed of 52 mi/h for 1 hour and 30 minutes for the first part of the trip. (a) What distance was traveled during this time? (b) Traffic gets heavier, and the last part of the trip takes another half-hour. What was the average speed during this leg of the trip? (c) Find the average speed for the total trip.
(a) Use the distance and velocity data in Figure 3.64 to find the rate of expansion as a function of distance. (b) If you extrapolate back in time, how long ago would all of the galaxies have been at approximately the same position? The two parts of this problem give you some idea of how the Hubble constant for universal expansion and the time back to the Big Bang are determined, respectively. Figure 3.64 Five galaxies on a straight line, showing their distances and velocities relative to the Milky Way (MW) Galaxy. The distances are in millions of light years (Mly), where a light year is the distance light travels in one year. The velocities are nearly proportional to the distances. The sizes of the galaxies are greatly exaggerated; an average galaxy is about 0.1 MlY across.
Give an example of a device used to measure time and identify what change in that device indicates a change in time.
Suppose you drop a rock into a dark well and, using precision equipment, you measure the time for the sound of a splash to return. (a) Neglecting the time required for sound to travel up the well, calculate the distance to the water if the sound returns in 2.0000 s. (b) Now calculate the distance taking into account the time for sound to travel up the well. The speed of sound is 332.00 m/s in this well.