4. What volume, in mL of 0.197 M HCIO4 needs to be added to 187.2 mL of 0.546 M RBCIO to achieve a solution with a pH of 7.35. Note: the pkb of RBCIO is 6.47, you may assume the 5% approximation holds, and you may assume that the volumes are additive. INSTRUCTIONS: Input your answer to 4 significant digits in standard notation (example: 1.234) and DO NOT include the units.

4. What volume, in mL of 0.197 M HCIO4 needs to be added to 187.2 mL of 0.546 M RBCIO to achieve a solution with a pH of 7.35. Note: the pkb of RBCIO is 6.47, you may assume the 5% approximation holds, and you may assume that the volumes are additive. INSTRUCTIONS: Input your answer to 4 significant digits in standard notation (example: 1.234) and DO NOT include the units.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter16: Applications Of Neutralization Titrations

Section: Chapter Questions

Problem 16.40QAP

See similar textbooks

Similar questions

Calculate the volume, in milliliters, of a 0.770 M KOH solution that should be added to 5.000 g of HEPES (MW = 238.306 g/mol, pKa = 7.56) to give a pH of 7.50. KOH volume = mL
The first step in purifying the urine collected on the ISS is to treat every liter of urine with 20 mL of 1.0 M H2SO4. To simplify the calculations, lets assume that urine is water. a) What is the pH of a solution of 20. mL of 1.0 M H2SO4 added to 1.00 L water? To determine this, you can safely assume that 100% of the H2SO4 reacts to form H3O+ and HSO4- ions. Use pKa2 (1.92) to determine if any more protons are added to the solution from HSO4-.
A hypothetical weak acid, HA, was combined with NaOH in the followingproportions: 0,20 mol HA, 0,08 mol NaOH. The mixture was diluted to a totalvolume of 1,0 L and the pH was found to be 4,80. a). What is the pKa of the acid?
A solid sample of Zn1OH22 is added to 0.350 L of 0.500 Maqueous HBr. The solution that remains is still acidic. It isthen titrated with 0.500 M NaOH solution, and it takes 88.5mL of the NaOH solution to reach the equivalence point.What mass of Zn1OH22 was added to the HBr solution?
Consider the spectrophotometric pH measurement of seawater with the indicator thymol blue illustrated at the opening of this chapter. The blue form of the indicator In22 on page 202 has maximum absorbance at a wavelength of 596 nm (nanometers). The yellow form HIn2 has maximum absorbance at 435 nm. Measurements of absorbance at the two wavelengths allows us to find the ratio [In22]/[HIn2]. How would you use this measurement to find the pH?
During the titration of an HClO4solution with 0.10320M NaOH, a CHEM 3A student,Juan becamedistracted and overshot the endpoint. A fellow student Pedrosuggested that he should record the present volume of NaOH added and titrate the excess with a standard acid solution. If the original sample volume was 25.000mL, the volume of NaOH added was 28.060mL. It took 3.4700 mL of 0.10940 M HCl to back-titrate the NaOH andcalculate the molar concentration of the original HClO4solution.
Calculate the volume, in milliliters, 0.170 M NaOH that must be added to 303 mL 0.0471 M 3‑(?N‑Morpholino) propanesulfonic acid (MOPS) to give the solution a pH of7.55. The pKa of MOPS is 7.18.
To rule out metabolic acidosis in a patient's blood sample, the total carbon dioxide content should be measured (HCO3-+CO2), this was determined by acidifying the sample and measuring the volume of CO2 released. The concentration of H2CO3 was 28.5 mmol/L, the pH of the blood at 37 ℃ is 7.48 with a pka of 6.10, what is the concentration of HCO3- in mmol/L in the blood? a) 27.36b) 22.77c) 28.50d) 29.60
In following these steps . Complete the table and provide th given chemical reactions in the qualitative analaysis of Group 3 Cations. Procedure 1. Place 20 drops of each of the following aqueous solutions to separate centrifuge tubes: 0.1M Cr (NO3)3, 0.1M Al (NO3)3, 0.1M Co (NO3)2, 0.1M Zn (NO3)2, 0.1M Mn (OH)2, 0.1M Ni (NO3)2, 0.1 M Fe (NO3)3. Make each solution basic by adding few drops of 6M NH4OH. Confirm using a litmus paper. 2. Add 5 drops of freshly prepared 6M (NH4)2S to each centrifuge tube. Place the samples in thecentrifuge machine for 3 mins. After centrifuge record results. Decant the supernatant liquid of all the samples. 3. Add one drop of NH4OH in each centrifuge tubes. Add 20 drops of distilled water in eachcentrifuge tubes. Then add a few drops of 6M HCl in each solution. Place the samples in the water bath for 10 mins. After water bath, centrifuge the samples for 3 mins. 4. After centrifuge, add a few drops of 6M NH4Cl in each sample. Decant the supernatant liquid…
The pH of a 0.2L HNO2-NO2 buffer solution was determined to be 6.23. The solution was mixed with 4,.4g of HNO2. a. Considering that the pKa is 4.35, what is the approximate pH of the new solution? Show all pertinent calculations. The MW of acid = 47g/mol.
Calculate the pH of each of the following points by titrating 50 mL of 0.40M imidazole (pKa = 6.993) with 0.41M KOH. Base added volume according to the equivalence volume: 0, 10, 90, 100, 120% Tabulate and plot Vavs. pH of the previous titration in Excel.
Using the concentrations 0.100M and 0.1766M, and the pKa of 3.752, what is the theoretical pH of a buffer solution?