Answered: 40% of incident radiant energy on the…

40% of incident radiant energy on the surface of thermally transparent body is reflected back, if the transmissivity of the body be 0.15 then emissivity of the surface is–

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter11: Heat Transfer By Radiation

Section: Chapter Questions

Problem 11.37P

See similar textbooks

Related questions

Q: After sunset, radiant energy can be sensed by a person standing near a brick wall. Such walls…

A: The radiant thermal flux per square metre from a brick wall at this temperature: 526.75 W/m2

Q: Steel sheet is placed as to block the sunlight resulting in the temperature difference between the…

Q: A surface is at 200°C and is exposed to surroundings at 60°C and convicts and radiates heat to the…

Q: Example 4.3 Two concentric cylinders having diameters of 10 and 20 cm have a length of 20 cm as…

Q: Consider the radiation heat exchange inside an annuals between two very long concentric cylinders.…

A: To find: The radiation view factor. Given: The radius of outer cylinder is R0. The radius of inner…

Q: A horizontal pipe (D = 200 mm , L=180 cm) is losing 2.7 kW to surroundings by radiation, What is the…

A: As unit given in the question is for convective heat transfer coefficient and also we can not…

Q: A 25 mm diameter copper pipe is used to carry heated water, the external surface of the pipe is…

Q: . A solid metal cube, of length 7.00 cm on a side, is placed in a forge. This metal cube is then…

Q: The roof of an automobile can be thought of as a flat plate with insulated bottom surface. Solar…

Q: , electrical power consumed by the hot plate will be?

A: Given: Tr=297 K Tp=403 K D=250 mm emmisivity=0.8 To determine: The electrical power consumed

Q: Flat-plate solar collectors are often tilted up toward the sun in order to intercept a greater…

Q: Two parallel square plates having 5 mm separation with each plate having 2 m² area. One of the…

A: Given Data: The gap between the plates is, t=5 mm. The area of both the plates is, A=2 m2. The…

Q: The emissivity of iron is approximately 0.25. If an iron cube (with a side length of 0.5 m) is…

A: This question is related to heat transfer. heat transfer is due to temperature differences. the mode…

Q: sider a shed with an 8-ftx12-ft base and 4-ft height. The temperature of the outer surface of th and…

Q: A wall facing southwest has a window area of 400 fn. The window glass is 1/4 in single heat…

A: Given: Window area, A=400 ft2 The below data is taken from the standard location and period tables…

Q: Heat radiates from a small sphere suspended in a large room. The surface of the sphere of 1.5 sq.…

Q: You went to Target to buy some masks. As you walk up to the store, you notice the huge red balls in…

A: Given:Ts=17°CT∞=22.5°Cd=1 mQ=6.6 W

Q: Two parallel rectangular surfaces 1m x 2m are opposite to each other at a distance of 4 m. The…

Q: Find the percentage of reduction in heat transfer if the heater is completely covered by radiation…

Q: Consider a silicon wafer positioned in a furnace that is zone-heated on the top section and cooled…

A: Given data: Tsur,h=1200 KTsur,c=330 Kε=0.65d=0.78T∞=700 KhT=8 W/m2.Khb=4 W/m2.K Need to determine…

Q: Problem 2: A black body of total area 0.045 m² is completely enclosed in a space bounded by 5 cm…

A: As per given question Thermal conductivity =1.7 w/m°c Inner temperature=215°c Outer…

Q: A spherical vessel with inner diameter of 1m (1.1m outside diameter) contains exothermic reaction…

Q: Twa large paral el grey plates with a small gap, having net radiation exchange at the rate of 1000…

A: given data Net radiation exchange between grey parallel plate (Q) = 1000 W/m2 emissivity of each…

Q: The glass surfaces are polished, having an emissivity of 0.095. The diameters of the inner and outer…

A: The heat transfer coefficient due to radiation through the cylindrical surface from the inner to the…

Q: 2 inch OD during a visit to a plastic sheet factory 60 m long section of a horizontal steam pipe…

Q: at 800°C and 300°C exchange heat by radiation. Calculat

Q: A small, oxidized, horizontal metal tube with an OD of 0.0254 m (1 in.), 0.61 m (2 ft) long, and…

Q: An asphalt playground is heated in the sun all day; by sundown it reaches a temperature of 45degC.…

A: Emissivity (∈): It is defined as the ratio between total hemispherical emissive power of a non…

Q: Two parallel discs of 1m diameter are situated 2m apart in surroundings at a temperature of 20 oC.…

A: Write the given data with suitable variables. T∞=20 °C=20+273 (K)=293 Kd=2 mT1=500 °C=773 Kε=0.5

Q: Heat transfer problem.The internal surface area is an enclosure is 50 meter square. The surface is…

Q: A hot water heater 150 mm wide, 2 m long and 1 m hight is at a surface temperature of 50°C in the…

Q: A 1-m diameter spherical solid receives heat from a source at 160°C by radiation and transfers heat…

A: Given: Diameter of the solid sphere is 1 m. Source temperature is 160°C. Surrounding temperature is…

Q: An astronaut is at work in the service bay of a spacecraft and is surrounded by walls at -100oC. The…

A: Given data: A=3 m2T1=0+273=273KT2=-100+273=173Kε=0.05 Need to determine the rate of heat loss and…

Q: A 50W incandescent ligh bulb (spherical in shape) has a surface temperature of 140deg C when the…

Q: Two parallel Aluminum sheet plates 0.75 by 1.0 m are spaced 0.4 m apart. One plate is maintained at…

A: Consider two large parallel plates having emissivities ε1 and ε2 and surface area A1 and A2 are at…

Q: 1. The boiling temperature of water is 100 °C. If you put boiling water in a mug placed at the table…

A: As per our guidelines, experts can provide solution to only one problem in case of multiple…

Q: T.- 100 °C Vacuum T. = 20 °C Figure 1.17 Problem 1.12 Two walls facing each other are thin, very…

A: The ratio of the temperature difference between two sides of a material to the rate of heat flow per…

Q: - (5 points) A surface of area 0.5 m², emissivity 0.8, and temperature 150 C 1s placed in a large…

Q: Find the amount of heat transfer transmitted through a west window (5 m2) 6 mm clear single glass…

A: Given data as per question area of window=5m2thickness =6 mmho=22.7 wm2kassuming heat transfer on…

Q: A manufacturing factory located at 30° N latitude has a window area 35 m2 that consists of double-…

Q: An ice-skating rink is located in an indoor shopping mall with an environmental air temperature of…

A: Given data as per question Environmental temperature =220 c Surrounding wall temperature =250 c…

Q: Receiver made of copper in solar dish experiment because.1 (äbäi 1) cheaper O shining metal O good…

A: Copper has higher thermal conductivity

Q: A certain body at 20C is displayed on a top of a building during the night. The body sees nothing…

A: Given Data The temperature of the body is: Tb=23°C=296 K The temperature of the sky is: Ts=110 K…

Q: Radiation and Convection from a Steam Pipe.A horizontal oxidized steel pipe carrying steam and…

A: In heat transfer analysis, the rate of change of state is evaluated by calculating the rate of heat…

Q: 2 A solar collector wth an area of 1.5 m is installed on the rooftop of a heuse. Assume that the…

A: Given: Area of the collector (A)=1.5m2Irradiation from the sun=1000W/m2Heat transfer coeeficient…

Q: 29. Gamma radiation is bombarding an iron plate as shown in the figure. A con- vection boundary…

A: Given: "Since you have asked multiple questions, we will solve the first question for you. If you…

Concept explainers

Conduction and Convection

When energy travels from one object to another it is said to have undergone heat transfer. Heat transfer is nothing but the transfer of thermal energy or internal energy from one thing to another, like e.g., when a vessel with water, kept on top of a burner, heats up because of the flame underneath it.

Question

40% of incident radiant energy on the surface of thermally transparent body is reflected back, if the transmissivity of the body be 0.15 then emissivity of the surface is–

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Determine the power requirement of a soldering iron in which the tip is maintained at 400C. The tip is a cylinder 3 mm in diameter and 10 mm long. The surrounding air temperature is 20C, and the average convection heat transfer coefficient over the tip is 20W/m2K. The tip is highly polished initially, giving it a very low emittance.
1.13 If the outer air temperature in Problem is –2°C, calculate the convection heat transfer coefficient between the outer surface of the window and the air, assuming radiation is negligible.
Three thin sheets of polished aluminum are placed parallel to each other so that the distance between them is very small compared to the size of the sheets. If one of the outer sheets is at 280C and the other outer sheet is at 60C, calculate the temperature of the intermediate sheet and the net rate of heat flow by radiation. Convection can be ignored.
A spherical communications satellite, 2 m in diameter, is placed in orbit around the earth. The satellite generates 1000 W of internal power from a small nuclear generator. If the surface of the satellite has an emittance of 0.3, and is shaded from solar radiation by the earth, estimate its surface temperature.
1.47 A flat roof is modeled as a flat plate insulated on the bottom and placed in the sunlight. If the radiant heat that the roof receives from the sun is , the convection heat transfer coefficient between the roof and the air is 12 W/m2 K, and the air temperature is , determine the roof temperature for the following two cases: (a) Radiative heat loss to space is negligible, (b) The roof is black and radiates to space, which is assumed to be a black- body at 0 K.
A horizontal, 3-mm-thick flat-copper plate, 1-m long and 0.5-m wide, is exposed in air at 27C to radiation from the sun. If the total rate of solar radiation absorbed is 300 W and the combined radiation and convection heat transfer coefficients on the upper and lower surfaces are 20 and 15W/m2K, respectively, determine the equilibrium temperature of the plate.
1.25 A spherical vessel, 0.3 m in diameter, is located in a large room whose walls are at 27°C (see sketch). If the vessel is used to store liquid oxygen at –183°C and both the surface of the storage vessel and the walls of the room are black, calculate the rate of heat transfer by radiation to the liquid oxygen in watts and in Btu/h.
Determine the rate of radiant heat emission in watts per square meter from a blackbody at (a) 15C, (b) 600C, and (c) 5700C.
Two very large walls are at constant temperature of 463oF and 887 oF. Assuming that the walls behave like black bodies, how much heat in Btu/hr-ft2 must be removed from the colder wall in order to maintain a constant pressure (σ=0.1714x10-8 Btu/hr-ft2-R)
Heat radiates from a small sphere suspended in a large room. The surfaceof the sphere of 1.5 sq. Ft. is at a temperature of 580 °F, and the insidesurfaces of the room are at a temperature of 80 °F. Assuming the emissivity ofthe sphere surface to be 0.30, calculate the radian-heat transfer in BTU/hr.
A spherical vessel with inner diameter of 1m (1.1m outside diameter) contains exothermic reaction that generates heat at a volumetric rate of 57 kW/m3. Assuming that the vessel is exposed in a surrounding at a uniform temperature of 278K, that the vessel radiates uniformly. What is the outer surface temperature of the vessel (Ts)? Note: Consider radiation heat tranfer only and the usrface emmissivity is 0.78. Round your answer to 2 decimal places.
Two parallel rectangular black plates 0.5 m by 2.0 m are spaced 1.0 m apart. One plate is maintained at 1000 °C and the other at 2000 °C. What is the net radiant heat exchange between the two plates? show how to get the F12