#424 Please help me answer this problem. Choose the correct answer from the given choices. Put whether your answer is Option 1,2,3,or4. NOTE: Show your solutions or answers why you've got or undergone this answer. Box your final answer. Make sure your answer is in the given choices. Write only your step by step solutions and answers in a clear bondpaper. Make sure the penmanship and photos are clear and readable. Thank you.

Q: ind the normalized frequency that corresponds to a DT filter cut-off of pi/4. What normalized freque...

A:

Q: What is the noise density for a receiver with an input bandwidth of 20 MHz and an equivalent noise t...

A:

Q: Examples: 1.Consider the block diagram shown in the following figure. Let us simplify (reduce) this ...

A:

Q: Cueustion-1 AEXpress the Booleam function f(Xys2) =xZ+J2 in sum of product and produC+ of Sum prove ...

A: As per the guidelines of bartleyby if there different questions then I have to answer first question...

Q: A four-pole dc generator has a wave-wound armature containing 48 slots with eight conductors per slo...

A:

Q: 2. A 100 µF capacitor and a 3.6 k N resistor are connected in series. How long will it take for the ...

A: For a series RC circuit, the time constant is given by the formula T = RC  Substituting the value is...

Q: Discuss the different methods of measuring high d.c. voltages.  What are the limitations in each met...

A: Here different methods of measuring high dc voltage is discussed-

Q: 23. Three matched amplifiers are available to amplify a low-level signal. They have the following ch...

A: We need to find out overall noise figure .

Q: A six-pole dc machine has an armature connected as a lap winding. The armature has 32 slots with six...

A: Above question is based on DC generator, the major classification of DC generator are: Series gener...

Q: Show yc

A:

Q: نقطتان )2) Q3/(b) At Fig. below, if RD-5KΩ, RS-7KΩ, rd-20KΩ, * find ZO tV DD Rp Ve R2 Rs 4KQ 3.5KN 5...

A:

Q: The volts per turn in a 25-cycle 2400/ 230-volt transformer is 8. Calculate the maximum flux (Maxwe...

A:

Q: B. Determine the six roots of (717.925 +j126.589). Express in polar form.

A:

Q: A voltage regulator is rated at an output current of I, = 0 to 40 mA. Under no-load conditions, the ...

A:

Q: Solve for the Vrms (magnitude only) across the capacitive reactance if R2 = 1087 ohms and Xc = 2301 ...

A:  The solution is given below 

Q: c) Determine the decimal value of the Q3.2 2's complement number 110010.

A: In this question,  Find the decimal number of the 2's complement number of 110010.    

Q: Q5. Compute the total energy and average power of the signal x(t) = Sin(2t).

A: Given signal  x(t)=sin2t

Q: 4. The semi-infinite line z>0, x = 0, y = 0 contains a uniform line charge density of 15 nC/m. Deter...

A:

Q: a. Find rms power for signal shown below f(t) b. For the same signal shown below f(t), find rms powe...

A:

Q: We consider a part of an electrical circuit represented in the figure below. The direction of the cu...

A: Since you have asked multiple questions in a single request, we will be answering only the first thr...

Q: What is the total potential drop through the complete, closed loop shown below? 2 mH 4 nF 1 k 2 1. a...

A: According to KVL sum of the voltages in closed loop is zero.  Voltages can be voltage rise or voltag...

Q: )) The Nyquist Plot of a system G(s) = in a unity feedback loop (Figure 3) is shown in Figure (s+1)²...

A: Answer -

Q: Solve for the value of inductive reactance if R1 = 482 ohms, R2 = 21 ohms and L3 = 5.5 mH.

A:

Q: Find the Thevenin equivalent circuit of the circuit in Fig. 4.34 to the Practice Problem 4.9 left of...

A: Given circuit shown 

Q: difference between the characteristics and operational modes of a differential amplifier from an ope...

A: DIFFERENTIAL AMPLIFIER :-     It is the basic building block of the analog circuit. It is the input...

Q: PROBLEMS 1. A six-band resistor has a color code of Red, Blue, Violet, Green, Brown, Black. Determin...

A: This question belongs to basic electrical . It is based on the concept of calculation of resistance ...

Q: Find i1 and i2 using mesh analysis

A: In this answer we will find the values of I1 and I 2 as explained below using the concept of Mesh an...

Q: The given data to be used for getting the AVE Values is 0, 5, 10, 30, 50,  70, 50, 30, 10, 5, 0, -5,...

A:

Q: A frequency generator is set to output the equation below. The waveform is sampled at 900 Hz. Which ...

A:

Q: (a) An electrodynamic wattmeter is used to measure the electrical power in a circuit. The diagram in...

A:

Q: 9. Solve for maximum power transfer. * 2 A 4Ω ww ww 2Ω RL. 4 A b 20 V 33.33 W 23.33 W 36.67 W 40.14 ...

A:

Q: Find Vms (gen) if R1 = 496 ohms, R2 = 27 ohms and L3 = 5.2 mH. R1 VGEN 10 Vt (GEN 60 kHz L3 R2 Round...

A: In this question,  Find the rms value of the voltage Vgen  if  Peak to peak voltage= 10V We know rms...

Q: An alternatorhas 18 slots/pole and the first coil lies in slots 1 and 16. Calculate the pitch factor...

A: The solution is given below 

Q: talk about Earth's radiative budget, what happens to electromagnetic radiation as it enters Earth's ...

A: Electromagnetics Radiation electromagnetic radiation is the branch of physics which flow of energy i...

Q: Vs(N V. V.

A:

Q: What is the form factor of 169sin 377t?

A:

Q: Calculate the DC voltages and currents in the circuit. Find for the current emitter, collector curre...

A:

Q: Ideally, all atoms have the same number of protons and electrons, therefore all atoms are considered...

A: When ideally all the atoms have same number of protons and electrons

Q: +40 V kN. 1 µF 22 MQ D Vas(Th) = 5 V Vps K = 120 x 10-6 A/V² Vaso = 12.48 V 1 µF G Vị . S VGs Yos = ...

A: This is a basic problem of MOSFET The solution is given below

Q: A generator is rated 100 MW. 13.8 kV and 90% power factor. The effective resistance is 1.5 times th...

A:

Q: 6. Three capacitors, a 12 µF, a 20 µF and a 30 µF, are connected in series. What is the total capaci...

A: Given: Three capacitors are connected in series C1=12 μFC2=20 μFC3=30 μF

Q: In the circuit shown, determine the following: The equivalent reactance and its nature (inductive or...

A: The solution is given 

Q: Given is a Series-Parallel Circuit or Combination Circuit, find RT or the total resistance of the ci...

A: If Two resistors R1 and R2 are connected in series than equivalent resistance is R1 +R2.  if Two o R...

Q: Design tor: curl fuctor CF=5%. R=42 Ĉ =10k W lond Determine: Vmex Vmax sinwt @

A: Output power =Vmax2R10000=Vmax24Vmax=200V

Q: T11. Fermi energy level for p-type extrinsic semiconductors lies (a) At middle of the band gap (b) C...

A: The fermi energy lies middles between conduction band and valance band for Intrinsic semiconductor. ...

Q: 37. A windmill-powered generator and a battery work together to supply DC power to a light bulb. Cal...

A:

Q: 7. Assume that a large room has three doors and one light in the center of the room. Three lat- chin...

A:

Q: What would be the efficiency of an alternator having 2hp power output if the input voltage is 230 vo...

A:

Q: Q2. Given the circuit configuration below, Vcc=VEE=6V, R = 2kn Rc = 6kn, Re = 5kn, Rb = 0, Rw = 2002...

A: The circuit is given as Diffential voltage gainAd=α2R+RC2re+RW2

Q: 11.a. The total loss in a fiber link is 7.1 dB, the design margin is 1 dB, and the optical budget in...

A: "Since you have asked multiple question, we will solve the first question for you. If you want any s...

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.