43. Calculate the equivalent resistance R Ramsa Μα R₂-150 1458 By = 150 Με το 500 A) 15Ω Β) ΠΩ ΤΟΝ R₂-150 C) D) 6Ω 8 Ω

Q: 3. Consider an RC circuit with R = 100, C = 0.1, and Eo = 0. Suppose that the initial charge on the…

A: We need to analysis the given RC circuit .

Q: 5. In the circuit in the figure shown below with transistor parameters ß = 180 and VA=∞, design the…

A: Given the circuit, as shown below: Given β=180 and VA=∞. We need to design the bias resistors R1…

Q: Find the depth of penetration of 1 MHz wave in copper which has conductivity = 5.8* 107 mhos/m…

A: In this question we will find skin depth ....

Q: Example 07:- For the circuit shown in the figure, calculate the output voltage when 1- R1 = R2 = R3…

A: By using the concept of difference amplifier circuit we need to derive the value of output voltage…

Q: A DC shunt motor is supplied by 250-volt and 15kW at rated load, if the No-load speed r.p.m and…

A: In this question we will find the efficiency , speed and torque developed for dc shukr motor....

Q: copper coil, when connected to a 30-volt supply, initially takes a current of 3 A and has a mean…

A:

Q: For the transistor in the figure shown below, t

A:

Q: If resonant frequency, wo = 1100 rad/s, find the following: a) L in mH; b) Quality factor Q; c)…

A: In this question parallel RLC resonance is given...We have to find out L, Q factor , bandwidth…

Q: A SUBSTATION RATED 1250 KVA IS OPERATING AT FULL LOAD AT 0.8 PF LAGGING AND TO CARRY AN ADDITIONAL…

A: The substation is an electrical substation is a subsidiary station of energy technology,…

Q: 8- Inter pole winding is connected in a) series with armature c)parallel with armature 9- What are…

A:

Q: B. Answer the following: 1. Give two differences Between the characteristics of Shunt and Series…

A: Given  We need to find the difference between the shunt and series motor,self excited and seperately…

Q: A 10 kW, 250 V, dc shunt motor with an armature resistance of 0.8 Ω and a field resistance of 275 Ω…

A: DC shunt motor is known as a wound DC motor it is a self excited DC motor the field winding is…

Q: ASSIGNMENT 2 Differentiate between different insulation systems like industrial insulation system,…

A: An insulation system is indeed a classification in IEC standards depending on the amount of…

Q: BJT Emitter Follower: Draw the small-signal model for the common-collector amplifier shown below.…

A: The given amplifier is in common collector configuration because input signal is applied at base…

Q: Use superposition to find the phasor current, I, for the circuit below.

A: It is given that using the superposition theorem current I need to find out:

Q: Write the general voltage equation for a 250-Hz source whose peak voltage is 300 V.

A: In this question,  We need to Write the general voltage equation If frequency f=250-Hz source  peak…

Q: Use Germanium diode. The peak value of the input to a half wave rectifier is 40 V. The approximate…

A: We need to find out the peak value of output voltage .

Q: 91. Choose only seven for the following: 1) ******** ............of measurement is difference…

A: Given  Multiple choice questions based on measurement. Please find the below attachment for clear…

Q: Questions ??-??. Consider an ideal RLC series circuit shown in the figure below. The current in the…

A:

Q: D) ANSWER IT. А ВС э

A: To implement using NAND GATE

Q: R(s) + a s(s+ b) C(s) G(s) Figure 3(a): Uncompensated System E(s) Lead G(s) Figure 3(b): Phase Lead…

A:

Q: For the figure below shows a d.c. Two-source network; the branch currents I, and I₂ are as marked in…

A: Given: Consider the following circuit: To find:  Write using Kirchhoff's laws, two independent…

Q: 2. Find the RMS value of the voltage waveform and the average power absorbed by the 9 ohms resistor…

A: In this question we need to find a RMS value of the given voltage waveform and average power…

Q: A 20 kVA, 2000/200-V, 50 Hz transformer has a high voltage winding resistance of 0.2 2 and a leakage…

A: Resistance: It is a property of a material that resists the flow of the current.   This is denoted…

Q: In color TV chrominance signal represents Y signal and Luminance signal represents U and V signal.…

A: The value of R is 0.4 V The value of G is 0 V The value of B is 0.25 V The illuminance is given as:…

Q: 2. Find the RMS value of the voltage waveform and the average power absorbed by the 9 ohms resistor…

A: Power: It is the time rate of the change of energy. It can be absorbing or expanding and its unit is…

Q: For the circuit shown in Fig 4 find 1- Rth to the left of the terminals a-b. 2- Maximum power…

A: In this question,  We need to determine the Thevenin resistance across the terminal a and b.  Also…

Q: 5. Given the unity feedback system as shown below, where G(s) = K (s+1)(s+2)(s+3) Do the following:…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Use superposition to find the phasor current, I, for the circuit below. I j3 2 -js n 2 Ω 3/50° A…

A: In this question we need to find a current I by using superposition principal . In superposition…

Q: The AVERAGE value of a half-wave rectified voltage (in V) with a peak value of 251.57V is Add your…

A: Given: In a half wave rectifier The peak voltage, Vm=251.57 V

Q: Consider the circuit in Figure A4. (a) Explain its operation with the aid of diagrams. (b) Assume…

A: Given the circuit, as shown below: a) We need to explain its operation with the aid of diagrams.b)…

Q: 42. Construct the following circuit: 43. Develop a truth table for the circuit you just built using…

A: As per the guidelines given to us we can only provide the solution of first question in multiple…

Q: Find i for t> 0 if i(0) = 2A and v(0) = 6V. 5Ω 1000 mH 26 cos 3t V =/F +1 + >.

A: The given circuit diagram is shown below: It is given that: i0=2 Av0=6 V

Q: Q4) Find the force on a straight conductor from (0,0,1) to (0,0,3) carrying a current of 10A in az…

A: We need to find out the force on current carrying wire .

Q: 10.23. Draw the block diagrams of both the direct forms I and II simulation diagrams for the systems…

A:

Q: Find the equivalent resistance across the terminal 492 www 202 40 .892 www 202 892

A: For the above given question we need to calculate the value of equivalent resistance across the…

Q: 6 sinh t 6 cosh 51 Option 2 What is inverse Laplace for 6s s² +25 6 sin t 6 cos 5t 10 Option 1

A:

Q: 4. A receiver has 2 uncoupled tuned circuit before the mixer, each with a Q of 75. The signal…

A: For the above given question we need to calculate the value of image rejection ratio by considering…

Q: e. For a 5A CT, find the number of turns for the secondary coil to measure a 500A power line current…

A: In this question we need to find a number of turn at secondary side of CT.

Q: if we have a point charge for which Q-4* 10-16 and m- 10* 10-26 kg is moving in combined fields E=…

A: Given  Point charge,mass and its velocity vector. We need to determine the unit vector and the…

Q: What is the expression of the complex power of the reliant current source? 103 16.52 2014 2020°V 6Vx…

A:

Q: 1. Consider the LTI system with impulse response h[n] = u[n] (i) Can this system be implemented…

A:

Q: Compute the closed-loop poles. What effect does increasing the free pa- rameter Kp have on the…

A: Note: Transfer function is not given so I am considering transfer function and then finding the…

Q: An AM transmitter radiates 9 kW of power when the carrier is unmodulated an (10.125 kW when the…

A: We need to find out the modulation index and total power transmitted

Q: A parallel-plate capacitor has plates measuring 10 cm x 10 cm, spaced 1 mm apart. The dielectric is…

A:

Q: Q3/A packet of resistors bought in an electronics component shop gives the nominal resistance value…

A: Nominal value-                  The average value of resistance is called nominal value of…

Q: Using Mesh analysis, find the current through each resistor for the networks in Fig. 3. The Icootors…

A: Brief description: In the above given question they have mentioned an electrical circuit which…

Q: // For the figure below, obtain the actual value of Io. 14 6Ω www 2 V 1, 2Ω www I = 15 A 7Ω 1 η Τ 4Ω…

A: We need to find out current for given circuit

Q: op amp has Vsat = +/- 13 V, SR = 1.7 V/μs, and is used as a comparator. What is the approximate time…

A: We need to find out the time taken to transit from one state to another state

Q: 2.3. A 44/11 K JJ KV, JMVA, so Hz Single following winding distance transformer has the resistence &…

A: Given data, Voltage rating 44/11 KV KVA rating S = 1 MVA Resistance and reactance of primary side of…

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.