5 +7 Consider the sample data deviations presented as shown in the figure next. The average deviation is fond to be +1 -6 O 2 None of the choices O-2

Q: True or False: A Higher sampling frequency results in a more accurate analog signal recreation…

A: The sampling frequency is the average number of samples obtained in one second .

Q: An analog waveform w(t) is ideally sampled with a sampling frequency of 400 Hz. Find W(f) and sketch…

A:

Q: What are the advantages and disadvantages of single –supply amplifiers

A: The advantages of the single supply amplifiers are as follows: In single-supply amplifiers there is…

Q: An example of the distortion of the pulse is its separation from the fixed peak value as in the…

A: The correct answer is 1.6hz

Q: A signal with a maximum frequency component of 5 kHz is to be sampled. According to the sampling…

A: Sampling is needed to convert a signal from continuous time domain into discrete time domain. This…

Q: From the circuit of Figure 2, draw the small signal equivalent circuit. Then by taking the rd = 100…

A:

Q: Q5-A given amplifier has a 12dB noise figure and an output resistance of 1000. If the rms vale of…

A: It is given that: Noise figure=12 dBR=100Vrms=0.625 μVSNRο=13k=1.38×10-23 JK

Q: Q/ Given an Early voltage of VA 100 V, VCEQ = 8 V and ICQ = 4 mA. ro is equal to

A: In this answer we will find the value of r0 as shown below using the formula we know early voltage =…

Q: Obtain the waveform of output states Q and  ̅Q for the SR when the input condition as in figure 5 is…

A:

Q: An analog signal of maximum frequency SKHZ is sampled at a certain sampling frequency. The…

A: To reconstruct orginal signal properly signal should be sample at Nyquist frequency is fs>= 2fm

Q: Please solve fast. A silicon NPN transistor TIP29 is used in the amplifier circuit  with VCC = 10V,…

A: Let the base current of the transistor be ib

Q: Listen A base bias method is used in the following circuit. For Bpc 100, the value of collector…

A:

Q: What is the baud rate? What are some typical baud rate values for instruments.

A: In this question we have to write the baud rate definition and write some typical baud rate values…

Q: ma=Acmax-Acmin/Acmax+Acmin for the modulated signal (AM) ,ma = 0.25; Calculate Acmax, Acmin and…

A: Ac = Amplitude of carrier signal   u = modulation index .

Q: Obtain the waveform of output states Q and ̅for the SR when the input condition as in figure 5 is…

A:

Q: Draw a buck-boost converter with circuit parameters given below. Also ; a) Output Voltage b)…

A: Given data: Input Voltage,VS=50V, Duty Cycle,α=0.6, Load Resistance,RL = 10 Ω, Switching…

Q: Obtain the waveform of output states Q and ̅for the SR when the input condition as in figure 5 is…

A: Note: In the question it given SR but in figure it is given JK flip flops  so assuming the JK for…

Q: convert continuous model into discrete model base on 0.1 second sampling time and ZOH DAC.

A: We need to convert the continuous-time system into a discrete model with a sampling interval of 0.1…

Q: o o 10

A: Note : In the question it given SR but in figure it is given JK flipflop so assuming the JK for…

Q: 3. (a) Consider the following figure depicts a sampled analog signal for digital signal…

A:

Q: Calculate the harmonic distortion components for an output signal having fundamental ampli- tude of…

A: Total harmonic distortion: The total harmonic distortion (THD) is a measure of the distortion…

Q: in Operational Amplifiers and Linear Integrated Circuits: if the value of the capacitor is changed…

A: "Please note that since the type of OP-AMP circuit is not described in the question, we will assume…

Q: b. Obtain the waveform of output states Q and for the SR when the input condition as in figure 5 is…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: Draw the small signal equivalent circuit. Determine the following: Zo Zin Av (voltage gain) Ai…

A: The required parameters can be calculated by using the DC and AC analysis of the cascade amplifier.

Q: According to the Compensation Regulation, the inductive reactive power should not exceed 20% of the…

A: Given Q =20%PQ=0.2 P

Q: otal harmonic distortion (THD) index is used to determine the distortion levels of the voltage as…

A: Although total harmonic distortion is defined as the ratio of sum of power of all harmonics  to the…

Q: Derive an expression for the output resistance of the Wilson source as shown as a function of the…

A: Given circuit diagram:

Q: Another of the blocks in the diagram is labelled sample-and hold. (i) Explain the purpose and…

A: All the physical signal are analog in nature. To process such a signal using a DSP (Digital Signal…

Q: which of the following configurations has low impedance and high output impedance?   a.…

A:

Q: 4. Derive the expressions of average and rms values of output voltage of step-down/step-up chopper.

A: STEP DOWN CHOPPERS         Output voltage is less than the input voltage. The average output…

Q: Q2: For the below signal flow graph find the correct answer and verfiy why in details. The state…

A:

Q: 3. (a) Consider the following figure depicts a sampled analog signal for digital signal…

A:

Q: Example 13.2. Convert the following block diagram into its equivalent signal flow graph then find…

A: Transfer Function: Transfer function is defined as the laplace transform of output to laplace…

Q: 1. Determine the output waveform of the signal below, assume Q=0 initially. CLK

A: The digital circuits can be combinational as well as sequential circuits. The combinational circuits…

Q: b) Determine the input impedance of the transistor amplifier using the small signal equivalent model…

A: Given the amplifier circuit as shown below: i) We need to sketch the small-signal model. ii) We…

Q: for the circuit if R = 5ohm, E = 20V and the cut-off (trigger) angle is 90 degrees; Draw the…

A: Given circuit is single phase semiconverter Input is sinusoidal   Vin(rms)=23010=23 V

Q: Find: Vgsa = Vos(sat) = Small Signal Parameters (AC Parameters) A, = Vout_small_signal = Vout…

A: Given :

Q: The midrange voltage gain of a certain RC coupled amplifier is 150 and the dominant critical…

A: Given midrange voltage gain=150fcL=1 kHzfcH=1 MHz

Q: +7 Consider the sample data deviations presented as shown in the figure next. The variance is found…

A: In the question, Data deviation are given , find the variation?

Q: 29) Write the equations for small-signal ac dynamic model of buck-converter, and defive the…

A:

Q: In frequency domain enhancement, we have many types of low pass filter, mention them and explain the…

A: As a broad division there are three kinds of filter that are present and utilized in the frequency…

Q: Consider the design of a low frequency differentiator to achieve the differentiation gain K = 0.001,…

A: Given data, Highest frequency fH=1000 Hz Capacitance C=0.1 μF Frequency fb=10fh

Q: Q. No 1. For the given analog signal, follow the proper steps to convert this signal to digital…

A: Here it is given that there are 8 levels in the analog to digital converter. Hence the output of the…

Q: I need ans..... in 10 minutes please help me    If the input voltage of an amplifier is 3.46 V rms…

A:

Q: Design a boost converter with the following specifications: P. 27 W, Vo=40 V, Vin=28 V, AVJV.=2%,…

A: Dear student here I have considered that the load current is ripple free current .

Q: 4- What is the effect of increasing the sampling time (1/f;)?

A:

Q: A signal is sampled at Nyquist's rate. This will ensure that the analog signal can be recovered from…

A: According to Nyquist’s sampling theorem, a signal can be recovered from its samples without any loss…

Q: Q1: In a delta modulation process, the step size is 0.05 v and sampling rate is four times the…

A: We need to find out the amplitude of message signal