5 Assume that 6.25 x 10¹5 electrons flow past a give point in a conductor every 10 s. Calculate the curre in amperes.

Q: pole, 50Hz, 11KV, turbo generator is rated 100 MW and 0.85 power factor lagging. The machine rotor…

A: Given, P =4f =50 HzV = 11 KVP= 75 MWcosϕ = 0.85J= 9000 Kg-m2 ω =4πfP =4π×504 = 50π rad/secK  = 12Jω2…

Q: Load 1: 200 W, unity power factor Load 2: 1200 W at 0.85 power factor lagging Load 3: 400 W + J100…

A:

Q: A lead (o = 5 x 10 S/m) bar of square cross section has a hole bored along its length of 4 m so that…

A: Given data, σ=5×106 S/m l = 4 m Figure is given as,

Q: The instruction ---------- is used to exchange the content of memory location [3000], [3001] with DX…

A: Introduction - DX register - This is a data register that may be used for a variety of purposes. It…

Q: • For the following RLC circuit, obtain the transfer function V (@) / I(@) and its zeros and poles.…

A:

Q: 8.21. Find C/R for Fig. 8-71, using Equation (8.2). G₁ G₁ R H₁ H₂ Fig. 8-71 G₁ G₂

A:

Q: 73. If ICBO CBO = 1 μA, what will be the value of ICEO? Given that ß = 150. (i) 151 µA (ii) 2 µA…

A: Given, ICBO=1 μAICEO=?β=150

Q: Please answer number 3. 1. Design a circuit that has the following properties: mutes out high…

A: We need to design a circuit that has the following properties: mutes out high frequencies, allows a…

Q: Q1: Simplify the block diagram shown in Fig. (1). then obtain the closed-loop transfer functions…

A:

Q: PROBLEM: in plotting root locus, find the asymptote real-axis intercept is/are. R(S) K s(s+ 1)(s² +…

A: In this question,  We need to determine the asymptotes real axis intercept of the given system.

Q: C is 7.5 mH 12 Q2 ?For the circuit shown above, what is the maximum average power that can be…

A: In this question we need to find a maximum average power transfer to load.

Q: Find the total impedance of the circuit, total power (apparent) delivered by the current source,…

A:

Q: Note: Answer Four Questions only Q1: A three-phase balanced source voltages, operating with a 380 -V…

A: Incase of unbalanced circuit, it is not advisable to decide power factor of circuit by  considering…

Q: c) The following paragraph contains a number of errors (somewhere between 1 and 5). Rewrite this…

A: Answer- I've revised the following paragraphs to meet your needs: Nuclear reactor research(see error…

Q: E C

A:

Q: One side of a transformer has 1,800 turns while the other side has 450 turns. The high voltage side…

A:

Q: An audio power amplifier delivers a 30 volt RMS 1 kHz sine to a loudspeaker. If the loudspeaker…

A: Given data, RMS voltage Vr=20 V Impedance is given Z=7∠450

Q: 1.8 The voltage across a 1.1-kW toaster that produces a current of 10 A is: (a) 11 kV (b) 1100 V (c)…

A: Given data, Power is given as,  P=1.1 KW=1100 W

Q: 1. One millivolt is one millionth of a volt. a) True (b) False

A: One millivolt is one millionth of a volt, Select correct answer

Q: A resistor of resistance R=1000 $2 is maintained at 17 °C and it shunted by 100 µH inductor.…

A: The expression for RMS noise voltage  across inductor can be written as, VLs = Vns = sLR + sL∴ VLf…

Q: When you connect a voltmeter to read a dc voltage   a. polarity is not important b. connect the…

A: In this question,  We need to choose the correct options When you connect a voltmeter to read a dc…

Q: Find hybrid parameters for the network in figure 3 ΤΩ ΖΩ METW ΖΩ Μ Figure 3 ΤΩ 41₁ Ω

A:

Q: How can you tell that the power pumped by an alternator is directly proportional to the load angle?

A: Alternator pumped the active power into the system but it does not give guarantee to pumped reactive…

Q: Thevenin impedance of a source is 41+j61 Ohms, and the Thevenin voltage 195 + j43 V. Find the value…

A:

Q: Find the capacitance (in units of pF) of a parallel plate capacitor that is made of two parallel…

A: Given, A parallel plate capacitor with Area of plates, A=7.6×104 m2 Separation of plates, d=2.4 mm…

Q: Assuming that there are no charges in the four regions shown in the figure, which of the patterns…

A: The electric field lines originate at a positive charge and terminate at a negative charge. In…

Q: I. From the given block diagram below, find the following: a) the total output of the system. b) the…

A: Various nodes are marked with different letters inorder to decrease the simplification.

Q: Note: Answer Four Questions only Q1: A three-phase balanced source voltages, operating with a 380 -V…

A:

Q: Problem 6. Find the conductance of a conductor of resistance (a) 10 S2, (b) 5 ks and (c) 100 m2.

A: Given, Conductors of resistance, aR=10 Ωb R=5 kΩc R=100 mΩ

Q: For the circuit shown, after a long time (at t=∞), the voltage across R3 is: R1 R2 ww 1.5k Q 4.7kQ…

A:

Q: S 20V $2,4k -Vo Ivonz6m14 Vasen = 8V Vesth=6V 15m= 50ms 3m-20m 1k 610N for the cascade amplifier,…

A: Voltage gain  Input resistance  Output resistance is found. While finding output resistance previous…

Q: 3 Find the charge q(t) flowing through a device if the current is: (a) i(t) = 3 A, g(0) = 1 C (b)…

A: In this question,  We need to determine the charge q(t) flowing through device if current is given?…

Q: Hi! Please answer this thanks! 1. Define AM and draw its spectrum? 2. Give the significance of…

A: When characteristic of one signal varies with another signal is called modulation.Modulation reduces…

Q: he Thevenin impedance of a source is 7Th = 101+ j 58, while the Thevenin voltage is VTh = 264 + j365…

A:

Q: AL=7EH, BL=82H after execute ADD AL, BL the flags will be CF=AF=ZF=1 O CF=AF=ZF=0 O CF=AF=1, ZF=0 O…

A: Brief description:  For the above given question we need to calculate addition of the content of the…

Q: Q1: A three-phase balanced source voltages, operating with a 380 -V line voltage as shown in Fig. 1.…

A:

Q: B: Calculate the current and voltage drop across each element of the following circuit after switch…

A: At steady state capacitor is replaced by open circuit  and we will find voltage by voltage division…

Q: The switch in Fig.4, has been in position a for a long time. At t-0, it moves to position l…

A: In this question,  We need to determine the current in the capacitor for all time t>0. Capacitor…

Q: Filter parameters: High-pass: Design a highpass filter with no more than 3 dB of ripple in a…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Visin30 Determine the output voltage for the circuit of Fig.3 blow. Where the *frequency is 10 KHz…

A: Operational Amplifier: Op-amps  is a divided into noninverting and inverting amplifiers and it is…

Q: A 3-phase star-connected 50Hz synchronous motor draws 92.8A at 0.866 leading power factor when…

A:

Q: A three-phase balanced source voltages, operating with a 380 -V line voltage as shown in Fig. 1.…

A: Assumptions in Electrical circuits analysis  Inductor absorb reactive power and considerd as…

Q: please help 1. Design a circuit that has the following properties: mutes out high frequencies,…

A: We need to design a circuit that has the following properties: mutes out high frequencies, allows a…

Q: a. What is Vs? b. Solve for thew load impedence Z_L. c. What is the value of the load impedance when…

A:

Q: A 460VAC rated, 60 Hz, 125-Hp Three-phase induction type motor is to be connected for…

A:

Q: Modulation and Demodulation: 1. Define detection process? 2. What are the different types of…

A: Modulation and demodulation Modulation is the process of encoding information in a transmitted…

Q: :An industrial heater has a nameplate that reads Vrms 356 Hz 47 kVA 9 lagging 0.71 What is the…

A:

Q: 5. Voltage drop across 14.5 22 resistor in Fig. 2.18 is 14.5 Ω 25.5 22 60 92 www 200 V Fig. 2.18 I

A: Given circuit:

Q: Determine the current through a 4Ω resistor connected to a voltage source Vs = 24sin45t V

A: We need to find current for given voltage for given resistor .

Q: A four wire, three phase system has a balanced supply voltage of 208V. Three wattmeters are…

A: Given data,  Line voltage VL= 208 V Circuit diagram is given as,

Types of Charge Carriers

A carrier is a type of object which carries a particular thing from one point to another point. For instance, people use different vehicles from one place to another, and the vehicle carries those people and acts as a carrier.