#5 Faraday Induction which may be treated as a solenoid. Suppose the coil has a circular cross section and a radius of 0.0200 meters. Suppose there are 100,000 evenly spaced turns in the coil, which has a length of 0.100 meters. Initially, a 2.00 A current flows in the coil. An inductor is in the form of a long cylindrical coil, a. What is the magnetic field in the interior of the solenoid? b. In part (a), what is the magnetic flux through each coil of the solenoid?

#5 Faraday Induction which may be treated as a solenoid. Suppose the coil has a circular cross section and a radius of 0.0200 meters. Suppose there are 100,000 evenly spaced turns in the coil, which has a length of 0.100 meters. Initially, a 2.00 A current flows in the coil. An inductor is in the form of a long cylindrical coil, a. What is the magnetic field in the interior of the solenoid? b. In part (a), what is the magnetic flux through each coil of the solenoid?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter20: Induced Voltages And Inductance

Section: Chapter Questions

Problem 5P

See similar textbooks

Similar questions

Noting that the magnetic field lines of a bar magnet resemble the electric field lines of a pair of equal and opposite charges, do you expect the magnetic field to rapidly decrease in strength with distance from the magnet? Is this consistent with your experience with magnets?
The force on the rectangular loop of wire in the magnetic field in Figure 22.56 can be used to measure field strength. The field is uniform, and the plane of the loop is perpendicular to the field. (a) What is the direction of the magnetic force on the loop? Justify the claim that the forces on the sides of the loop are equal and opposite, independent at how much of the loop is in the field and do not affect the net force on the loop. (b) If a current of 5.00 A is used, what is the force per tesla on the 20.0-cm-wide loop? Figure 22.56 A rectangular loop of wire carrying a current is perpendicular to a magnetic field. The field is uniform in the region shown and is zero outside that region.
Unreasonable Results A surveyor 100 m from a long straight 200-kV DC power line suspects that its magnetic field may equal that of the Earth and affect compass readings. (a) Calculate the current in the wire needed to create a 5.00105T field at this distance. (b) What is unreasonable about this result? (c) Which assumption or premise is responsible?
Is the Earth's magnetic field parallel to the ground at all locations? If not, where is it parallel to the surface? Is its strength the same at all locations? If not, where is it greatest?
(a) Aircraft sometimes acquire small static charges. Suppose a supersonic jet has a 0.500C charge and ?ies due west at a speed of 660 m/s ever the Earth’s south magnetic pole, where the 8.00105T magnetic field points straight up. What are the direction and the magnitude of the magnetic force on the plane? (b) Discuss whether the value obtained in part (a) implies this is a significant or negligible effect.
You intend to move a rectangular loop of wire into a region of uniform magnetic field at a given speed so as to induce an emf in the loop. The plane of the loop must remain perpendicular to the magnetic field lines. In which orientation should you hold the loop while you move it into the region with the magnetic field to generate the largest emf? (a) with the long dimension of the loop parallel to the velocity vector (b) with the short dimension of the loop parallel to the velocity vector (c) either way because the emf is the same regardless of orientation
A magnetized sewing needle has a magnetic moment of 9.70 mA m2. At its location, the Earths magnetic field is 55.0 T northward at 48.0 below the horizontal. Identify the orientations of the needle that represent (a) the minimum potential energy and (b) the maximum potential energy of the needlefield system. (c) How much work must be done on the system to move the needle from the minimum to the maximum potential energy orientation?
A patient with a pacemaker is mistakenly being scanned for an MRI image. A 10. 0-cm-long section of pacemaker wire moves at a speed of 10.0 cm/s perpendicular to the MRI unit’s magnetic field and a 20.0-mV Hall voltage is induced. What is the magnetic field strength?
The magnetic field through a circular loop of radius 10.0 cm varies with time as shown in the accompanying figure. The field is perpendicular to the loop. Assuming cylindrical symmetry with respect to the central axis of the loop, plot tire induced electric field in the loop as a function of time.
The rod shown in the accompanying figure is moving through a uniform magnetic field of strength B=0.50T with a constant velocity of magnitude v=8.0m/s . What is the potential difference between the ends of the rod? Which end of the rod is at a higher potential? B
Integrated Concepts The Tethered Satellite discussed in this module is producing 5.00 kV, and a current of 10.0 A flows. (a) What magnetic drag force does this produce if the system is moving at 7.80 km/s? (b) How much kinetic energy is removed from the system in 1.00 h, neglecting any change in attitude or velocity during that time? (c) What is the change in velocity if the mass of the system is 100,000 kg? (d) Discuss the long term consequences (say, a week-long mission) on the space shuttle’s orbit, noting what effect a decrease in velocity has and assessing the magnitude of the effect.
The magnetic field at all points within the cylindrical region whose cross-section is indicated in the accompanying figure starts at 1.0 T and decreases uniformly to zero in 20 s. What is the electric field (both magnitude and direction) as a function of r, the distance from the geometric center of the region?