5) The deflecting torque of an ammeter varies as the square of the current flowing through it. If a current of 10 A produces a deflection of 90°, what deflection would occur for a current of 5 A when the instrument is (a) spring controlled and (b) gravity controlled? [Ans. (a) 22.5°, (b) 14.5°]

5) The deflecting torque of an ammeter varies as the square of the current flowing through it. If a current of 10 A produces a deflection of 90°, what deflection would occur for a current of 5 A when the instrument is (a) spring controlled and (b) gravity controlled? [Ans. (a) 22.5°, (b) 14.5°]

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter10: Contactors, Relays, And Overloads

Section: Chapter Questions

Problem 32RQ

See similar textbooks

Related questions

Q: riefly explain environmental issues in regard to thermal power plants

A: A thermal power station is a power plant with a steam-driven primary mover. Water is heated, then…

Q: A440V,22.5-hp,50Hz,3-phase,4-pole,star-connectedinductionmotorhasthefollowing impedances in ohms per…

Q: For an op-amp having a slew rate SR = 8 V/ms, what is the maximum closed-loop voltage gain that can…

A: We need to find gain for opamp

Q: What is the cut–off frequency of an op-amp if the unity-gain frequency is 2.8 MHz and the open-loop…

A: Given, An Op-Amp has, Unity-gain frequency (fu) = 2.8 MHz The open loop gain (Ao) = 200,000

Q: Determine the current, voltage and power dissipated by each of the 6 resisters in the following…

Q: A magnetic ring (relative permittivity = 800) has a mean radius of 10 cm and a cross sectional area…

Q: Using the drain characteristic of Fig. a. What is the value of ra for VGS = -1 v? b. What is the…

A: The drain characteristics are plotted between VDS and ID of the FET or MOSFET.

Q: A 3Ø, 2000KW, 480V A-connected alternator is short-circuited and is operated at rated speed to…

A: Given data, No. of phase(ϕ)=3 Power(P3ϕ)=2000kW Voltage(VLL)=480V Rated Current(Isc)=P3ϕ3×VLL

Q: Find the state space representation of the transfer function 8s+7 st+s*t 553+ ||

A: In this question we need to find a State space representation of the given transfer function

Q: ENGR 17L- Lab 11- Methods of Analysis (DC) At Home Exercises Exercise 1 a) Construct the network of…

Q: (a) Explain on the AM Single Sideband Full Carrier (SSBFC) and compare to Double Side Band Full…

A: In this question, We need to explain the carrier power and sideband power of the Single Sideband…

Q: Interpret the circuit by answering the guide questions, this is a simple power supply with full-wave…

A: The Conversion of one type of current into other type is called rectification. This includes…

Q: The reliability of the pumping station as a whole and of its individual components must be…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: In a balanced A-Y circuit, Vab = 240/15° and Zy = (12 + j15) N. Calculate the line currents. Answer:…

A: Given data, VAB = 240∠15° VZY = (12+J15)Ω

Q: Question 4: What are the charge on and the potential difference across each capacitor in the figure…

A: We need to find out the voltage across capacitor and charge on capacitor

Q: How much is IE with 5mA for Ic and 120µA for IB? O 125 mA O 5.120 mA O 5.120 mico Amps 120.5 mA

A: Given: Collector current, IC=5 mA Base current, IB=120 μA=0.120 mA Emitter current, IE=?

Q: Q2) Find the Fourier transform of the signal shown in figure 2. x(t) 2A -A/2 A/2 Figure 2 A: your…

A: We need to find out Fourier transform of given signal

Q: Voltammetry is an analytical techniques that based on measurement of current as a function of…

Q: Develop a Transfer Function C(s)/R(s) from the following block diagram shown in Figure Q3. H;(s)…

Q: A series circuit consisting of 20 ohm resistance and 20 mH inductance is connected across a 220…

A: The solution is given below

Q: Which are the advantages of an open-loop system 1. Accurate response II. Less time for maintenance…

Q: The signal with the am module is given below. what is modulation index

Q: X1(s) For the system of Figure Q4, find the transfer function G(s) F(s) -x() K2 = 5 N/m - x×(1) K1 =…

Q: 3. Given the circuit 0.21, 5 k IV 2 kl 2 A Solve I, using the superposition theorem.

A: In this question, We need to determine the current IX using the super position theorems. Here 2…

Q: 13) Simplify the following Boolean function F, together with the don't-care conditions d, and then…

A: We need to simplify the given Boolean function

Q: Question (4): x'(t) = y(t) – 3x(t) + 3, y'(t) = 2x(t) – 4y(t) + 8 x(0) = 12, y(0) = 15 | %3D

A: Given case is of unilateral Laplace transform. Formula for unilateral laplace…

Q: Determine the magnitude of gm for a JFET with Ipss =12 mA and Vp = -7 Vat the following de bias…

A: NOTE :- As per our company policy, only FIRST 3 sub-parts of a Question can be answered at a time,…

Q: Finally assume that the electrical circuit will be working through a PLC unit, state and justify how…

A: In this solution, the importance of industrial automation using PLC is discussed, which will improve…

Q: For the following network, find the value of load resistance RỊ for maximum power to RL. R1 R3 6Ω…

Q: A voltage v= 222sin(377t+60o) is applied accross a circuit having an inductance of 0.1H. What is the…

A: Here the concept of rms value, peak value of the sinusoidal voltage wave is discussed.

Q: For the following network, find the value of load resistance RỊ for maximum power to RL. R1 R3 6Ω…

Q: H.W. Use a 25-mH inductor to design a high-pass filter circuit having a cutoff frequency of 80…

A: We need to design a high pass filter for given specifications .

Q: Find the effective value of the resultant current which carries simultaneously a direct current of…

A: Current: A flow of electrical charge carriers, generally electrons or electron-deficient atoms, is…

Q: Refer to Figure 9. Find the complete response v and then i for t> 0 in the circuit.

Q: 12) Simplify the following Boolean functions: (а)* F(A, В, С, D) П(1,3,5, 7, 13, 15) (b) F(A, В, С,…

A: We need to find out simplified Boolean expression of given function

Q: For an AM DSBFC wave with an unmodulated carrier voltage of 18V and a load resistance of 50Ω. If the…

Q: For the circuit shown, a) To the coil of a henry, measure its internal resistance and the value of…

Q: FIND i(t),t>0 2 k 6k i(t) 4 k ZV 100 F

Q: What is the rms ac fault current

A: FAULT CURRENT :The fault current is the electrical current that travels across a circuit during an…

Q: Hiw 2 fint the RAB in fig. 2 kn A. 9kn 9kn 3kn 사

Q: The maximum and minimum stresses in the dielectric of a single core cable are 40 KV/cm (rms) and 10…

Q: Si +12 Vo IR Vo red 680 Compute for the voltage drop across the Silicon diode in the circuit shown.…

A: The solution is given below

Q: FEEDBACK AND CONTROL SYSTEMS Instructions: • Write the GIVEN with their respective symbols and…

Q: A series circuit consisting of 40ohm resistance and 20microfarad capacitance is connected to a 220V…

A: Voltage drop: This is the loss of voltage in the circuit. The loss occurs due to the circuit…

Q: Review questions (7.1) Find the value of Vo if the Rx= 80K2. How large Rx be to avoid saturation if…

A: We need to find out output for given circuit and resistance value for given output

Q: If X(e") = ei 3 ; | ®|<1 = 0 ; 1< 0< T, Find x(n) and plot.

Q: Determine the magnitude of gm for a JFET with Ipss =12 mA and Vp = -7 Vat the following de bias…

A: As per the guidelines of bartleyby I need to Answer first three subparts only so kindly repost other…

Q: 1. Inquire about the operational and geometric definitions of capacitance C. [C = = ε0 , please…

A: The Capacitor is a passive circuit element. It can store electrical charge in it. The capacitors…

Q: Consider the circuit below. At t= 0 the switch is opened. Find the inductor current, i(t), for t> 0.…

A: The solution is given below

Q: 2) Fill in the blanks with a letter corresponding to the pole placement plot below; arrows indicate…

Question

100%

5) The deflecting torque of an ammeter varies as the square of the current flowing through it. If a current of 10
A produces a deflection of 90°, what deflection would occur for a current of 5 A when the instrument is (a)
spring controlled and (b) gravity controlled?
[Ans. (a) 22.5°, (b) 14.5°]

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

SOLVE AND SHOW YOUR COMPLETE SOLUTION. ANSWERS SHOULD BE IN TWO DECIMAL PLACES. The armature of a two-pole dc machine has 30 slots, each slot has 4 conductors each. during its operation, only 75% of the conductors are directly under the pole. each pole measures 2 inches by 3 inches and produces ten million maxwells of flux. the armature core is 12 inches in length and 3.5 inches in diameter. the total resistance of the winding is 2 ohms. e) Determine the total torque exerted by the armature core in ft - lb if the winding is simplex lap winding.
While discussing armature testing: Technician A says to test for shorts, place the ohmmeter leads on a commutator segment and armature shaft. Technician B says that continuity should exist between the commutator and the armature shaft. Who is correct?
THE ARMATURE OF A 4-POLE, 128 SLOTS SHUNT GEN. IS LAP WOUND WITH FOUR CONDUCTORS PER SLOT. THE FLUX PER POLE IS 50 mWb. THE ARMATURE AND SHUNT FIELD RESISTANCES ARE 0.04 OHM AND 50 OHMS RESPECTIVELY. DETERMINE THE SPEED OF THE MACHINE WHEN SUPPLYING 400 A AT A TERMINAL VOLTAGE OF 250V.
A shunt generator delivers 195 Amp of terminal of voltage 250Volts. The armature resistance and shuntfield resistance are 0.02 ohm and 50 ohms respectively. The iron and friction losses equal to 950 Watts.The overall efficiency is?
A 4 poles lap wound, DC machine has 728 active conductors running at 1800 rpm. The flux per pole is 30 mWb. The armature current is 120A, what is the electromagnetic power developed in the armature in kW?
Discuss the operation of non-contact torque measuring instruments
The current in a conductor on the armature of a dc motor is 300A. The flux under the poles is 850uWb. The area per pole is 700mm^2. The length of the conductor on the armature is 642 mm. Calculate the force exerted on the conductor
From this graph, if I change the value of the Ifl current what will happen to the torque and speed . Please answer the question with the drawing
PLEASE ANSWER IT NOW, I NEED THE ANSWER Find the total external armature current of a dc machine which has thefollowing specifications: 120 armature slots; 6 conductor per slot; 9300lines per cm2 flux density; armature diameter of 28 inch ; 14 incharmature axial length ; 4 armature parallel path ; the pole span 72 % ofthe armature surface and the torque developed by the armature 1500 lb-ft.
What is armature reaction proportional to?
SOLVE AND SHOW YOUR COMPLETE SOLUTION. ANSWERS SHOULD BE IN TWO DECIMAL PLACES. The armature of a two-pole dc machine has 30 slots, each slot has 4 conductors each. during its operation, only 75% of the conductors are directly under the pole. each pole measures 2 inches by 3 inches and produces ten million maxwells of flux. the armature core is 12 inches in length and 3.5 inches in diameter. the total resistance of the winding is 2 ohms. b) determine the total generated voltage if the armature is running at 1000 rpm and its winding is simplex lap connected.
SOLVE AND SHOW YOUR COMPLETE SOLUTION. ANSWERS SHOULD BE IN TWO DECIMAL PLACES. The armature of a two-pole dc machine has 30 slots, each slot has 4 conductors each. during its operation, only 75% of the conductors are directly under the pole. each pole measures 2 inches by 3 inches and produces ten million maxwells of flux. the armature core is 12 inches in length and 3.5 inches in diameter. the total resistance of the winding is 2 ohms. d) determine the total force tending to rotate the armature core in lbs, if the winding is simplex lap connected.