5. A human being has an average venous blood pressure of 12 mm Hg (Hg = mercury). The density of Hg (mercury) is 13,530 kg/m3. How high does a saline bag have to be raised to just barelyequal to that of the blood in the vein) of saline through a line and needle inserted into a person's vein? The density of saline is 1020enable the flow (that is, the pressure of the saline at the needlekg/m3.

The pressure of the blood vessel in Pascals can be determined as,

5. A human being has an average venous blood pressure of 12 mm Hg (Hg = mercury). The density of Hg (mercury) is 13,530 kg/m3. How high does a saline bag have to be raised to just barely enable the flow (that is, the pressure of the saline at the needle is equal to that of the blood in the vein) of saline through a line and needle inserted into a person's vein? The density of saline is 1020 kg/m3.

5. A human being has an average venous blood pressure of 12 mm Hg (Hg = mercury). The density of Hg (mercury) is 13,530 kg/m3. How high does a saline bag have to be raised to just barely enable the flow (that is, the pressure of the saline at the needle is equal to that of the blood in the vein) of saline through a line and needle inserted into a person's vein? The density of saline is 1020 kg/m3.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

1. A water vessel was designed to go 149 miles underwater, with the surrounding fluid having a density of 1,030,000 g/m^3. What is the pressure difference between the outside and inside of the wall?
4. Assuming standard condition, what is the altitude in ft where the density is 0.001845 slug/ft3?
A submarine is traveling at a depth of ‘95’ kilometers in the ocean, where the gagepressure is 840 Kg(f)/cm2 . The density and bulk modulus of elasticity of water at the top surface of the ocean are 1025 kg/m3 and 24000 kg(f)/cm2 respectively. Find the following:(i) What will be the density of water at the depth of 2.0 kilometers?(ii) What will be specific volume and change of volume at that depth?(iii) What is the pressure at the top surface of the submarine? How much will bechanged in pressure if submarine change direction from North to East?
A ship with vertical sides near the water line, weighs 40 MN and draws 6.7 m in salt water (specific gravity = 1.026). Discharge of 2 MN of water ballast decreases the draft to 6.4 m. What would be the draft d of the ship in fresh water?
thi 40 A vertical sluice gate (4m) wide and (3m) deep contains water on both of its sides. On the upstream side, the water is (6m) deep and on the downstream side it is (2.5m) deep from the bottom of the sluice. What is the resultant pressure force on the gate and the position of this resultant force from the hinge
Given the sketch shown below, the diameter of the plunger Dp = 8 cm. The Ram diameter is Dr = 48 cm. The efficiency is 100%, the stroke of the plunger is 18 cm. The ram has to raise a load F2 = 2kN. Find: A) the force f1 exerted on the plunger. B) the number of strokes needed to raise the load given above by a distance of 10 cm. C) the volume of oil pumped if the load moves by 20 cm ( using plunger force in a ) D) what will be the new diameter of the ram piston if the new load force is 16 times the force exerted in the plunger the diameter of the plunger is kept to 8 cm.
the force acting on a spring at any displacement is undeformed length is equivalent to the product of the amount of displacement (s) and k. what is k?
The fuel gage for a gasoline tank in a car reads proportional to its bottom gage.The tank is 35cm deep and theSpecific gravity of gasoline is 0.68.a) What is the gage reading when the tank is filled with gasoline?b)If the tank is accidentally contaminated with 3cm of water,how many cm of air remains on top of the tank when the gage reads "FULL"?
Water flows through a horizontal pipe of cross sectional of 20 cm2. At one section, the cross sectional area is 4 cm2. the pressure difference is 29.4 psi. How many cubic meters of water will flow out of the pipe in 1 min?
A closed tank contains 0.610 m of mercury ( specific gravity = 13.6 ), 524 m of water, 2.438 m of oil ( specific gravity = 0.75 ) and an air space of 1 m above the oil. If the pressure at the bottom of the tank is 276 kPa, what should be the reading of the gage in the top of the tank?
Subject: Fluid Mechanics/Hydraulics 1.) If the specific volume of a certain gas is 0.5203 m3/kg, what is its specific weight in N/m3. 2.) What is the difference in pressure in kPa between the inside and outside of a bubble having a diameter of 0.081 inches if it's equivalent to an air-water interface having a surface tension of 0.045 lb/ft?
Kindly supply all questions neatly thank you A closed tank whose bottom is 18 inches in diameter is filled with three liquids: 12 inches of carbon tetrachloride (SG=1.59), 4 inches of water and 2 inches of syrup (SG=1.31). The air chamber in the tank is pressurized at 9 psi. Illustrate the problem before solving a. Determine the pressure at the interface of water and syrup. b. Determine the difference in pressure between the interface of water and syrup and the interface of carbon tetrachloride and syrup c. Compute the hydrostatic pressure (in psi) acting at the bottom of the tank d. Apply the PANEL EQUATIONS to determine the magnitude, direction and location of the total hydrostatic force acting at the bottom of the tank. .