#5. As part of a new seal hunting stategy, on a balmy –5.00 °C day I drill a circular holein the sea ice that has a radius of 0.402 m. I take the drilled block of sea ice and leave it outon the ice. When I come back later that evening the temperature has dropped to –29.0 °C.What will be the area of the top of the block of sea ice (ignoring any new ice formation)?Note that the coefficent of linear expansion for sea ice is 45.0 × 10–6

Write the expression of the final area. ∆A=2αAi∆T

Answered: #5. As part of a new seal hunting…

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter16: Temperature And The Kinetic Theory Of Gases

Section: Chapter Questions

Problem 12P

See similar textbooks

Similar questions

Calculate the rate of heat conduction out of the human body, assuming that the core internal temperature is 37.0 , the skin temperature is 34.0 , the thickness of the fatty tissues between the core and the skin averages 1.00 cm, and the surface area is 1.40 m2.
How much stress is cleated in a steel beam if its temperature changes from 15 to 40 but it cannot expand? For steel, the Young's modulus Y=210109N/m2 from Stress, Strain, and Elastic Modulus (http://cnx.org/content/m58342/latest/#fs-id1163713086230). (Ignore the change in area resulting from the expansion.)
On a nice winter day at the South Pole, the temperature rises to 60°F. What is the approximate temperature in degrees Celsius?
Why does rubbing alcohol evaporate much more rapidly than water at STP (standard temperature and pressure)?
What is the density of water vapor in g/m3 on a hot dry day in me desert when the temperature is 40.0C and the relative humidity 15 6.00%?
- (a) Compute the amount of heat needed to raise the temperature of 1 kg of water from its freezing point to its normal boiling point. (b) How does your answer to (a) compare to the amount of heat needed to convert 1 kg of water at 100° C to steam at 100°C?
One easy way to reduce heating (and cooling) costs is to add extra insulation in the attic of a house. Suppose the house already had 15 cm of fiberglass insulation in the attic and in all the exterior surfaces. If you added an extra 8.0 cm of fiberglass to the attic, then by what percentage would the heating cost of the house drop? Take the single story house to be of dimensions 10 m by 15 m by 3.0 m. Ignore air infiltration and heat loss through windows and doors.
An underground gasoline tank can hold 1.00 103 gallons of gasoline at 52.0F. If the tank is being filled on a day when the outdoor temperature (and the gasoline in a tanker truck) is 95.0F, how many gallons from the truck can be poured into the tank? Assume the temperature of the gasoline quickly cools from 95.0F to 52.0F upon entering the tank.
4. One end of a 40 cm metal rod 2.0 cm2 in cross section is in a steam bath while the other end is embedded in ice. It is observed that 13.3 grams of ice melted in 15 minutes from the heat conducted by the rod. What is the thermal conductivity of the rod. 5. What will be the rise in temperature in 30 minutes of a block of copper of 500-gram mass if it is joined to a cylindrical copper rod 20 cm long and 3.0 mm in diameter when a temperature difference of 80 degree Celsius is maintained between ends of the rod? The thermal conductivity of copper is 1.02 cal/cm2-sec-°C/cm (neglect heat losses).
Week 4 #20 A stainless steel saucepan, with a base that is made of 0.180-cm-thick steel (κ = 46.0 W/(m·K)) fused to a 0.150 cm thickness of copper (κ = 401 W/(m·K)), sits on a ceramic heating element at 220°C. The diameter of the pan is 18.0 cm, and it contains boiling water at 100.00°C. If the copper-clad bottom is touching the heat source, at what rate will the water evaporate from the pan? Latent heat of vaporization (Lv) for water is 2256 J/g. Enter your answer in three decimal points. _____g/s
Bebang owns a 130-mm-thick concrete brick table top that has an area of 10,000,000 mm^2 and a 0.750-cm-thick glass plate that has an area of 20,000 cm^2. Assuming the same temperature difference across each, what is the ratio of the rate of heat conduction through the plate with respect to the rate of heat conduction through the table top? Use Table 10.1(given below) for the value of Thermal Conductivity k.
Consider a 260-m2 black roof on a night when the roof’s temperature is 27.5°C and the surrounding temperature is 12.5°C. The emissivity of the roof is 0.900. At what net rate does heat radiate, in kilowatts, from the roof?

SEE MORE QUESTIONS

Recommended textbooks for you

Principles of Physics: A Calculus-Based Text

Physics

ISBN:

9781133104261

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

University Physics Volume 2

Physics

ISBN:

9781938168161

Author:

OpenStax

Publisher:

OpenStax

College Physics

Physics

ISBN:

9781938168000

Author:

Paul Peter Urone, Roger Hinrichs

Publisher:

OpenStax College

Principles of Physics: A Calculus-Based Text

Physics

ISBN:

9781133104261

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

University Physics Volume 2

Physics

ISBN:

9781938168161

Author:

OpenStax

Publisher:

OpenStax

College Physics

Physics

ISBN:

9781938168000

Author:

Paul Peter Urone, Roger Hinrichs

Publisher:

OpenStax College

Inquiry into Physics

Physics

ISBN:

9781337515863

Author:

Ostdiek

Publisher:

Cengage

College Physics

Physics

ISBN:

9781285737027

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS