answer number 5 asapp 1. If the pressure at a point in the ocean is 75 kPa, what is the pressure 27 meters below thispoint?2. If the pressure in the air space above an oil (s = 0.80) surface in a closed tank is 120 kPaabsolute, what is the gage pressure 2 m below the surface?3.Find the absolute pressure in kPa at a depth of 10 m below the free surface of Oil of sp. gr. 0.80if the barometric reading is 760 mmHg.4.If atmospheric pressure is 97.75kPa and the gage attached to the tank reads 188 mmHg vacuum,find the absolute pressure within the tank.5. In the figure shown, if the atmospheric pressure is 101.03 kPa and the absolute at the bottomof the tank is 3 kPa, what is the specific gravity olive Oil?SAE Oil, s= 0.89WaterOlive, s= ?..Mercury, s= 13.61.5 m+2.5 m2.9 m+0.4 m

5) It is given that: Pb=3 kPaPatm=101.03 kPa

Answered: 5. In the figure shown, if the…

5. In the figure shown, if the atmospheric pressure is 101.03 kPa and the absolute at the bottom of the tank is 3 kPa, what is the specific gravity olive Oil?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

In a spherical electrode system, gas material with the most favorable arrangement in terms of puncture resistance, outer radius r2 = 3.2 cm, puncture field strength Ed=75kV/cm and dielectric constant Ergas=1 is used. According to this;a) Calculate the inner radius of the electrode and the puncture voltage of the system according to the geometrical characteristics of the most suitable arrangement in terms of puncture resistance.b) Draw the puncture curve in the p-Emax plane for a voltage of U=40kV provided the outer radius is kept constant and indicate the boundaries of the inner sphere radii on the curve.c) Briefly interpret the electrode system in terms of discharge events in the geometric characteristics of p=0.8, p=1.8 and p=5 on the puncture curve.
On a square wireframe with side length a in empty space, there is a linear charge density ρl.Calculate the value of the potential V = ke · ρl · A [Volt] at h = 5 · a height on the strut exiting the center of this square frame.Find the numerical value of the value of A?
Please answer and write neatly. (Show your complete solution.) Volume charge density is located in free space as ρν = 2e−1000r nC/m3for 0 < r < 1 mm, and ρν = 0elsewhere.(a) Find the total charge enclosed by the spherical surface r = 1 mm.(b) By using Gauss’s law, calculate the value of Dr on the surface r = 1 mm.
In a dielectric material medium with relative dielectric constant & varepsilon; Er = 3, the load of 5 micro cloum is uniformly distributed over the sphere with radius R = 1m. Accordingly, which of the following is the expression of electric field in the sphere.
Since the potential of a perfect conducting sphere with a radius of 3.5 cm in empty space is 10 V, calculate the value of the potentials at a distance of 13.3 cm from the center of the sphere as Volts in ke.
In a study of the properties of an aqueous solution of Th(NO3)4 by A. Apelblat, D. Azoulay, and A. Sahar (J. Chem. Soc. Faraday Trans., I, 1618, (1973)), a freezing-point depression of 0.0703 K was observed for an aqueous solution of molality 9.6 mmol kg−1. What is the apparent number of ions per formula unit?
On a square wireframe with side length a in empty space, there is a linear charge density ρl. Calculate the value of the potential V = ke · ρl · A [Volt] at the height h = 6 ·a on the strut exiting the center of this square frame. Find the numerical value of the value of A?
A 10-cm-long thin glass rod uniformly charged to 7.00 nC and a 10-cm-long thin plastic rod uniformly charged to -7.00 nC are placed side by side, 3.90 cm apart. What are the electric field strengths E1 to E3 at distances 1.0 cm, 2.0 cm, and 3.0 cm, from the glass rod along the line connecting the midpoints of the two rods? a) electric field strenght E1 B) electric field strenght E2 C) electric field strenght E3
Find the relative permittivity of the dielectric material present in a parallel-platecapacitor if: (a) S = 0.12 m/, d = 80 μm, V = 12 volt, and the capacitor contains1 ?? of energy; (b)The stored energy density is 100 ?/?/, V = 200 volt, and ? =45 ??; (c) ? = 200 ??/? and ?# = 20 ??/?/.
Calculate drift current density in 1.5 mm long slab of intrinsic Si at room temperature under applied voltage 10V? Assume carrier mobility of 1100 cm2 V-1 s-1. ..
In a concentric spherical electrode system with an outer sphere radius of 20 cm (constant) and a rupture voltage of 150kV, the rupture field strength of the insulator in between is constant at 30kV / cm. Determine the limits of the inner sphere radius required to apply 100 kV to the system and interpret the discharge events occurring in the system on the puncture curve for r1 = 2 cm, 9 cm, 17 cm values.
A sharp-edge orifice 5 cm diameter in the vertical side of a large tank discharges under a head of 5 m. if c = 0.98 cc = 0.62, determine: a) The diameter of jet at vena contracta, b) The velocity of jet at vena contracta, and c) The discharge in m/s.