5. (Post Test 2 material) For the following circuit with v, (t) = 10 cos (1000t + 5°), determine %3D (a) the average power absorbed by the resistor, (b) the reactive power associated with the capacitor, (c) the apparent power associated with the inductor, (d) the complex power supplied by the source. 100 10 mH Vs 20 uF

5. (Post Test 2 material) For the following circuit with v, (t) = 10 cos (1000t + 5°), determine %3D (a) the average power absorbed by the resistor, (b) the reactive power associated with the capacitor, (c) the apparent power associated with the inductor, (d) the complex power supplied by the source. 100 10 mH Vs 20 uF

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 2PP: Assume that the current flow through the resistor, IR, is 15 A; the current flow through the...

See similar textbooks

Similar questions

A 25V, 2.5kHz supply is connected to a network comprising a variable capacitor in parallel with a coil of resistance 250 ohms and inductance 80 mH. Determine, for the condition when the supply current is a minimum the capacitance of the capacitor the dynamic impedance the supply current the upper half-power frequency the value of the circuit impedance at the -3dB frequencies
A SERIES RC CIRCUIT TAKES A CURRENT WHOSE EQUATION Is 2 sin (754t+40) AMPERE. WHEN CONNECTED TO A SOURCE OF EMF HAVING THE EQUATION e = 340sin 754 VOLTS. CALCULATE, (A) THE VALUE OF Z, R, AND XC, (B) CAPACITANCE, AND (C) AVERAGE POWER.
A coil of inductance 318.3 mH and neg[1]ligible resistance is connected in series with a 200 resistor to a 240V, 50 Hz supply. Calculate (a) the inductive reactance of the coil, (b) the impedance of the circuit, (c) the current in the circuit, (d) the p.d. across each component, and (e) the circuit phase angle
A resistor'R' with resistance value of 24 ohm, an inductor 'L' with inductance 20mH, and a capacitor 'C' with capacitance 50 micro Farrad are connected in series with a AC voltage v(t) where v(t) = 50 cos (2 vt + 30 degrees) v. Determine the current i(t) and total impedance if the frequency f is i. 60 Hz ii. 400Hz
A 40 Ω resistor and a 50 μ F capacitor are connected in series and supplied with analternating voltage v = 283 sin 314 t. The supply is switched on at the instant when the voltageis zero. Determine the expression for the instantaneous current at time t.
A source whose voltage is ? (?) = 50√2 cos (?? + 30 °) ? supplies a load of impedance ? = (4 + ?3) Ω. We want to know: a) the active, reactive and apparent power consumed by the load. b) the power of a capacitor that must be installed in parallel with the load to raise its power factor to 0.97 delayed.
A coil of inductance 318.3 mH and negligible resistance is connected in series with a 200 ohm resistor to a 240V, 50 Hz supply. Calculate the inductive reactance of the coil, the impedance of the circuit, the current in the circuit, the p.d. across each component, and the circuit phase angle.
A 40 Ω resistor, a 200 μF capacitor and a 269 mH inductor are connected in series across a voltage source represented by: V = 163.34 sin(100t) volts Determine the following: A.) The rms value of current is A. (a) 0.75 (b) 1.5 (c) 2.5 (d) 3.5 B.) The total impedance of the circuit is ohms. a.) 46.19 b.) 54.37 c.) 65.15 d.) 32.65 C.) The real power supplied is watts (a) 144.35 (b) 125 (c) 175.25 (d) 250 D.) The power factor of the circuit is . (a) 0.707 lagging (b) 0.866 leading (c) 0.6 leading (d) 0.5 lagging
Two coils of inductance ?1 = 1.16 mH, ?2 = 2 mH are connected in series. Find the total energy stored when the steady current is 2 Amp?
five infinite-impedance volunteers,calibrated to read rms values,are connected as shown below. let R= 200, L=0.400H,C=6.0 Mf, and V=30.0 v. what's the reading of the voltmeter's V1,V2,V3,V4 and V5 if W= 200 rad/s
A capacitor of 3.18 microfarads is connected in parallel with a resistance of 2000 ohms. The combination is further connected in series with an inductance of 795 mH and resistance of 100 ohms across a supply given by e=400 sin + 80 sin(3wt + 60O). Assume w = 314 rad/sec, determine the rms value of the total current.
The feeder is to be used with an antenna for which an inductive reactance is measured as j60 Ohms at 1.7 MHz. The resistive part of the antenna’s impedance is measured as 80 Ohms. Using the online impedance matching calculator, design a suitable impedance-matching network for each of the two cables if the coaxial cable has a characteristic impedance of 75 Ohms and the twin lead cable has a characteristic impedance of 300 Ohms, so that the inductance is in the longitudinal branch, while the capacitor is in the transversal branch of the impedance matching network. Do not round the resulting values.