Q1/ Determine the value of the capacitance, C for the circuit shown in Fig.(1) The network function that represents this circuit is ( 69.6 H(o)=; v₁(1) V. (@) V₁ (0) 1+j 1kQ 1+ j 4 ΚΩ Fig. (1) 55.7 %(t) -

Q1/ Determine the value of the capacitance, C for the circuit shown in Fig.(1) The network function that represents this circuit is ( 69.6 H(o)=; v₁(1) V. (@) V₁ (0) 1+j 1kQ 1+ j 4 ΚΩ Fig. (1) 55.7 %(t) -

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 2PP: Assume that the voltage drop across the resistor, ER, is 78 V, that the voltage drop across the...

See similar textbooks

Related questions

Q: 3. Given k=-0.4x10^-3 A/V^2 and ID(on)=3mA with VGS (on)-4V, determine VT a. 0.333V b. 1.261V c.…

A: It is given that: VGSon=4VIDon=3mAk=-0.4×10-3AV2

Q: A solenoid coil has a resistance of 30 Ohms and an inductance of 0.5H. If the current flowing…

A: This question belongs to circuit theory . It is based on the concept of impedance of coil . Problem…

Q: 3/ Find the impedance parameters for the network shown below V₁ 125 Ω 50 Ω 75 ΩΙ V₂

A: Given circuit :

Q: what are connecting according device types to there layers

A: Networking devices are devices which requires communication between the hardware and the software…

Q: Determine the current supplied by each voltage source (8 V ,12 V). using uperposition theorem in…

Q: Q3] find the current of the resistance 2492 if the value of the source is:V1= 2.6sin(100rt- 58) volt…

Q: ( 2 Find the total resistance between the point A and B of the flowing figure(a)? 402 A-W- A D Lim

Q: a. What direction does the magnetic field point (cw or ccw) and what is its approximate magnitude…

Q: An impedance coil having a resistance of 20 ohms and all face of connected in parallel with a 0.4-uf…

A: The circuit can be draw

Q: A solenoid coil has a resistance of 30 Ohms and an inductance of 0.5H. If the current flowing…

A: In this question, We need to determine the voltage V and phase difference between voltage and…

Q: find transfer function YS/RS for this blok diagram

Q: Fill-in Questions: 1. The forward voltage across a silicon diode in a normally working circuit is V.…

A: Diode: Diode is basically a p-n junction device which has the property of conducting current in only…

Q: 8 A 10 transformer 3300/400v has the following details R₁ =0.75-2 R₂=0,011-2 x₁ = 3.60 x₂ = 0.04552…

Q: I marks): Obtain the transfer function Y(s)/U(s) of the system defined by 8-698-8- y = [11] LL

Q: 1. Knowing that carrierfrequency=10MHz and Δfpeak=20kHz Find, using Bessel plots and Carson's rule,…

A: According to the question, the carrier frequency=10MHz and Δfpeak=20kHz Find, using Bessel plots and…

Q: specifications. Determine and comment on the computational and storage requirements.

A: we will compute the required computational and storage requirements with the help of detailed block…

Q: Find the Current Io. In figure (2). Чта 2mA IT Ika I2 I kn Iy 2ks m Io lkn. Is Fig.2 ) 6V Elkr 16 MA

A: The circuit given as

Q: 1: a. State the names of the architectures model used in microprocessor and microcontrollers…

A: An microprocessor is an small computer that performs arithmetic logic, functions of a computer…

Q: 033 Consdier the following Control System Diagram: a) Where are the Open Loop poles of the system?…

A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.

Q: 2. Dip-coating process is one of the methods for electrode surface modification.

A: Answer : True The above statement is correct.

Q: Q4/ Evaluate the state space expression for the below circuit if the output is the current through…

Q: A 20,000-cycle source is connected to a series and a 0.266-uf capacitor. An impedance coil, whose…

A: Resonance:-At resonance condition, XL& XC cancel the effect of each other and circuit become…

Q: 245 kohms 275 kohms 265 kohms VBB 255 kohms yu The transistor of following figure in Si diode: The…

Q: Determine if the following system are causal or not a.y(n) = x(2n) b.y(n) = 3x(n) - 4 x(n − 1) -

A: Given data, a) y(n)=x2n b) yn=3xn-4xn-1

Q: Question 3 A C o • 100 Ω A RL Figure 22 For the circuit in Figure 22, the Thevenin equivalent…

Q: What is the maximum amount of power that can be transferred to the resistor Ry, from the rest of the…

A: Given circuit,

Q: Calculate the maximum range of a radar system which operates at 3 cm with a peak pulse power of 600…

A: Given :minimum detectable signal power Smin = 10-13 WEffective cross section area of antennaAe = 5…

Q: There are 5 wires (circled numbers) used to implement the following logic circuit. There is a fault…

A: Given figure,

Q: I have been asked to analyse the practical application of transducers and actuators in an industrial…

A: Please find your answer below.

Q: 20 V- 1³ 3 A Fig-4- www 10 Ω www • 25 Ω 6Ω Find the Norton's equivalent circuit for the network…

A: Given circuit :

Q: Find the Current Io. In figure (2). 4mA 2mA II, Ika wm 12₂ I kn Iy 2km m 4 Io lkn. Is 6V Ik 6mA

Q: 3. When x[n] is one of DFT basis functions, its DFT will be all zero except only one coefficient.…

A: A discrete time signal represents the value at the instant of time where the signal is defined by…

Q: A 1500-kVA, 6.6 kV, three-phase, star-connected synchronous generator has a resistance of 0.5…

A: Given: A 1500-kVA, 6.6 kV, three-phase, a star-connected synchronous generator has a resistance of…

Q: Q6/ Determine the values of the capacitance, C1, and of the resistances, R1 and R2 for the circuit…

Q: Q3] find the current of the resistance 2422 if the value of the source is:V1= 2.6sin(100nt- 58) volt…

Q: [t) 16.39 16.5. мее 1 H 292 i(t) 0.5

Q: Also, what range of values of K1 will the system be stable? (__<K1<__) And find the value pf K1…

A: Given: The system shown has G1s=1s3+10s2+24s To find: (a) Determine the value of K2 for which the…

Q: A 10-hp, 4 pole, 25Hz, 3-phase induction motor is taking 9100 watts from the line. Core loss is 290…

A: Given data, Frequency f=25Hz No. of poles P=4 Input power Pi=9100W Core loss Pc=290W Stator copper…

Q: 1. For a RLC circuit shown in Fig.1. calculate (i) total impedance (ii) total resistance (iii) total…

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part…

Q: The nature of the graph between the speed and field current of DC shunt motor is O Linear O Straight…

A: In this question we will find relation between speed and field current of dc shunt motor...

Q: A 3-Phase 10Kva, 400 V, 50Hz star connected alternator supplies a rated load at 0.8 power factor…

Q: Nature of the response (Undamped, Underdamped, Overdamped, Critically damped) S+5 G(s) = (s + 10)²

Q: 6. Three equal capacitors of 3000μF are connected in series, then the equivalent capacitance Ceq.is…

A: Given, Three equal capacitors are connected in series. Capacitance of each capacitor, C=3000 μF

Q: (a) For an electron mobility of 500 cm²/V·s, calculate the time between collisions. (Take mn = m0 in…

A: It is given that: μ=500 cm2V.sE=100Vcm

Q: Findir Using fouriar series (1) 1 Plot the amplitude spectrum 2 Determine the total Power 3 Find the…

Q: A 30 MVA, three-phase, wye-connected, 60 Hz, 13.8 kV synchronous alternator has negligible stator…

Q: The Second Law of Thermodynamics is about the quality of energy. True O False

A: Given: Second law of thermodynamics

Q: There are 6 × 10 small picture elements in a video each having 8 distinguishable 4 equiprobable…

A: Given data, Number of picture elements = 60 Number of levels = 4 ×8 = 32 Rate of frames = 20 /s…

Q: 16.0 S (S²+45+4) Find the la place

Q: A three-phase star-connected, 50-Hz generator has 48 coils per phase and a flux per pole of 0.1 Wb.…

A: Note: Since nothing is specified, so we will consider full pitch coil with pitch factor kc=1. One…

Concept explainers

Sinusoids And Phasors

Sinusoids are defined as the mathematical waveforms that are used to describe the nature of periodic oscillations.

Circuit Theory

Electric circuits are a network that comprises of a closed-loop, which helps in providing a return path for the current through a switch. When the switch is activated, the load operates, and the current accepts a path to finish the circuit at a low potential level from the opposing high potential level. Electric circuits theory is a linear analysis that helps in establishing a linear relation of voltage and current for R (resistance), L (inductance), and C (capacitance).

Question

Q1/ Determine the value of the capacitance, C for the circuit shown in Fig. (1)
The network function that represents this circuit is
H(o)=
1+ j
V. (@)
V₁ (0) 1+j
69.6
55.7
w
1 ks
4 KS2
I
+
Fig. (1)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The current in the 20 mH inductor is 10 cos(10,000t + 30°)mA.Calculate (a) the inductive reactance; (b) the impedance of the inductor;(c) the phasor voltage V; and (d) the steady-state expression for v(t)
A 50ft transmission line is used for a microwave system. Aportion of the transmission line is found to have an inductanceof 0.5 mH, a capacitance of 1000 uF, 1000Ω resistance and 1uSconductance. Find the characteristic impedance of the trans lineassuming at Low frequency application.
Using the diagram capacitor circuit and values provided, find ZC1, Z T, i, VR1, and Vc1
The voltage across the terminals of the 5μF capacitor is 30 cos (4000t + 25°) V. Calculate (a) the capacitive reactance; (b) the impedance of the capacitor; (c) the phasor current I; and (d) the steady-state expression for i (t). 5 μF + v i
If the roots of the characteristic equation are -3,0 then the system is _________________________. Marginally stable Conditionally stable Stable Unstable
1.3 A coaxial cylindrical capacitor is to be designed with an effective length of 10 cm. The capacitor is expected to have a capacitance of 100 pF and to operate at 11 kV, 1000 kHz. Determine the required thickness if the required insulating material is Polytetrafluoroethylene (P.T.F.E.), &r= 2.0, Eb = 250 kV/cm. Allow a factor of safety of 4 and take to = 8.85x10-1² F/m.
In the given circuit, consider M = 1 H. Determine the energy stored in the coupled inductors at t = 2 s. The energy stored in the coupled inductors is J
The voltage pulse applied to the 100 mH inductor shown is 0 for t<0. and is given by the expression v(t)=20te−10t V for t>0. Also assume i=0 for t≤0. Sketch the voltage as a function of time.
Answer the following questions based on the C–V curve for a MOS capacitor shownin Fig. 5–39. The area of the capacitor is 10^4 µm^2.
The current in a 20 mH inductor is known to be i=40 mA,t≤0; i=A1e−10,000t+A2e−40.000tA,t≥0. The voltage across the inductor (passive sign convention) is 28 V at t=0. 1. Find the expression for the voltage across the inductor for t>0. 2. Find the time, greater than zero, when the power at the terminals of the inductor is zero.
A 30 μF capacitor is connected in parallel with a coil of inductance 50 mH andunknown resistance R across a 120 V, 50 Hz supply. If the circuit has an overallpower factor of unity, find (a) the value of R, (b) the current in the coil, and (c)the supply current.
Let Vs=530tᶾ v, leg t >0 and iL (0) = 1 A, in the circuit shown, at t=0.2s, determine the values of the energy stored in the capacitor and the coil. The circuit is in the attached image.