Answered: 5. Show the connection of two op-amp…

5. Show the connection of two op-amp stages using an LM358 IC to provide outputs that are 15 and - 30 times larger than the input. Use a feedback resistor, Rp = 150 kN, in all stages.

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter11: Thermostats, Pressure Switches, And Other Electric Control Devices

Section: Chapter Questions

Problem 23RQ

See similar textbooks

Related questions

Q: What must the voltage at the inverting input of the op- amp be? What is the voltage drop across Rin?…

Q: The inverting OP-AMP shown in the figure has an open loop gain of 100. The closed loop gain VV, is…

A: Referring to the given circuit, the negative terminal of the op-amp is known as the inverting…

Q: Figure Q2(a) shows an amplifier system with the given input voltage waveform Vin and the…

Q: 3. Inverting Amplifier is a normal OP-Amp in which the output is given as feedback with a feedback…

Q: For a given opamp circuit, the value of CMRR is 40 dB. If the differential gain is Ad=105, then what…

A: For a op-amp circuit

Q: (i) Derive an expression for the differentiator using op-amp. (ii) Design a circuit to perform…

A: Introduction: The first order derivative of the input signal is the output signal of a…

Q: c) Design a non-inverting Schmitt trigger circuit with an upper trigger point UTP = 3.1V and lower…

A: Since you have posted multiple different question. we will solve the first question for you. To get…

Q: Why is it that you need the higher feedback resistance (Rf) to observe saturation? (simple answer!)

A: need of the higher feedback resistance (Rf) to observe saturation:

Q: Sketch the transfer characteristics of OP-AMP with input offset voltage equal to 4 mV.

A: Let op-amp is ideal, so gain will be infinite input offset voltage Vi/o=±4 mV

Q: Q1: design an inverting op-amp circuit to form the weighted sum Vo = -(vị + 4v2) .choose the values…

A: The solution is given below

Q: 5. If the feedback/input resistor ratio of An op-amp feedback amplifier is [your CGPA] with 1.7 V…

Q: When an op-amp is used as a comparator (as in the air-conditioning controller example), it must…

A: Op - Amp stands for operational Amplifier it is device through which we amplify signals and also…

Q: Show the connection of two op-amp stages using an LM358 IC to provide outputs that are -25 and 40…

A: The required circuit can be designed by cascading inverting and non-inverting amplifiers. The…

Q: View Sign Window Help Home Tools Some practice ques x UNIVERSITY OF UL 就,可日ea 自Q G.4 (a) For the…

Q: 4. What is the voltage gain of an inverting op-amp in which the feedback resistor has a value of…

A: Given data, An inverting op-amp in which Rf=7000 ΩRin=1500 Ω

Q: The question: From this figure of the instrumentation amplifier, derive the CMRR of this circuit.…

A: Although instrumental amplifier is designed to reject any amount of common mode signal . so , V0…

Q: For the ideal op-amp in Figure. ,it has negative feedback. Find VA,i,'and uo. +10V VA

A: An ideal op amp has equal voltage on inverting and non inverting terminals. The voltage on…

Q: 1- Mention any two non linear applications of op-amp.

A: As per the guidelines, we supposed to answer one question at a time so please ask other questions…

Q: 180%- 日2 在會Q 回☆ 6 @ 213 (b) For the comparator circuit shown below, a sinusoidal input signal with…

Q: A non-inverting op-amp circuit has the open loop gain of 104 and the resistances R1 = 2k Ω and R2 =…

A: Non Inverting Op-amp

Q: Q-3: Discuss about the cross-over distortion in push-pull class B power amplifier. Draw the proper…

A: Class B Push-Pull Amplifier :It comprises two transistors, one transistor (Q1) works in the positive…

Q: w the connection of three combination op-amp stages ( Parallel and series connection) using an LM348…

A: Gain of 1st stage is +110.Which means, op-amp in 1st stage must be non-inverting amplifier. Given:…

Q: Homework: For the comparator circuit shown below sketch the Hysteresis Curve showing Transfer…

Q: 1) What is the Barkhausen criterion, i.e. what is the loop gain magnitude and a. phase criteria for…

Q: When 100 V and 20 V are applied to the non inverting and the inverting terminal of open loop an…

A: For an open-loop operational amplifier, if Ad and Ac represents the differential gain and…

Q: A measurement of open loop gain of op-amp at very low frequency shows it to be 86 dB; and at 100…

Q: 1- Mention any two non linear applications of op- amp.

A: As per the guidelines, we supposed to answer one question at a time so please ask other questions…

Q: Theoretical Calculations: 5. Name five other application for op- amp, sketch their circuit and their…

A: Application of op-amp: (1) Op-amp uses for Scale changer. (2) Op-amp use as integrator. (3) Op-amp…

Q: Q2/Explan the method to compensation of bias current, offset voltage,Offset current and maximum…

A: Q2. Offset voltage will usually introduce minor faults in any op-amp circuit. Unlike the advantages…

Q: Explain with the help of proper diagram and necessary derivation, How Op-Amp can be used as…

A: Inverting amplifier: When the output of the operational amplifier is connected to the inverting (-)…

Q: Which op-amp network is commonly used to reduce the effect of noise on comparator circuits (Schmitt…

A: The solution is given below

Q: Sketch the transfer characteristics of OP-AMP with input offset voltage equal to 4mV

A: Let Op amp is ideal, so gain will be infinite Input offset voltage Vio = +- 4mV

Q: P13.78. Derive an expression for the voltage gain of each circuit below, assuming ideal op-amps.

Q: 2. Interpret the applications of op-Amp based on the ideal And Practical op-Amp characteristics

A: The application of op-amp based on ideal characteristics are as follows: 1- It is used in data…

Q: gain of 10 is required from a noninverting constant-multiplier op-amp circuit. If the input resistor…

A: We need to find out the value of feedback resistance for given amplifier

Q: Draw the circuit diagram of the basic noninverting amplifier configuration. Give an expression for…

A: In an ideal op-amp, voltage at inverting and non-inverting terminals are equal. and current is zero.…

Q: A appropriate op-amp circuit with a gain of +100 is required for the ultrasonic device. Create a…

Q: For the summing Op-Amp, find the output voltage Vout?

A: Op-amp may be used to perform the summing operation of several input signals in inverting and…

Q: Design a collector-feedback circuit using with Vcc = 5 V, Ic = 10 mA, and VCE =1.5 V. %3D

A: The design-based problem may have multiple answers. It varies based on designers and their…

Q: 10. What is the use of the compensation capacitor in op-amp?

A: The solution is provided in the following section.

Q: Q2/B)- Show the connection of three combination op-amp stages ( Parallel and series connection)…

A: Gain of 1st stage is +110 It means op-amp in 1st stage must be non-inverting amplifier.…

Q: 4. (a) Determine the input and output impedances of the amplifier in Figure - 2. The op-amp…

A: Zin = 1.2 MohmZout = 120 ohmAOL = 150000

Q: Show the connection of an LM124 quad op-amp as a three-stage amplifier with gains of -10, +25, and…

A: Given data: A three-stage amplifier has gains of -10, +25, and +20. Feedback resistor, Rf=470 kΩ for…

Q: draw the block diagram of op-Amp

A: The general Op-amp has four stage and the all the four stages in order are given below: Dual input…

Q: Determine the closed-loop voltage gain of the circuit shown in the figure assuming an ideal op amp

A: For ideal opamp voltage at inverting terminal is same as voltage at non inverting terminal. For…

Question

5. Show the connection of two op-amp stages using an LM358 IC to provide outputs that are 15
and – 30 times larger than the input. Use a feedback resistor, Rp = 150 kN, in all stages.
152 Volt

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In the op amp model above, open-loop gain is 106 and Vcc=12V. Suppose the inverting-input voltage is vn=90μV and the output voltage vo=5V. What is the noninverting input voltage vp (in micro-volts)?
What value of open-loop gain is guaranteed for the OP-27 op amp over the full temperature range with a load resistance of at least 2 kΩ?
An inverting op – amplifier stage is designed with an input resistance of 5 KΩ and feedback resistance of 10 KΩ. The load resistance is 100 Ω with DC gain of 5x10^4 . The output internal resistance is 500 Ω while the input impedance is infinity, assuming an input voltage of 1.5 volts, calculate the following ?a) The AC gain ?b) The output voltage ?c) The looking back resistance ?
Calculate the total offset voltage for the circuit shown below for op-amp specification values of input offset values, VIO=3.5 mV and IIO=73 nA with RF=20000 ohm and Rin=3000 ohm.
What must the voltage at the inverting input of the op-amp be? What is the voltage drop across Rin? What is the input current, iin, through Rin? What is the output voltage vout?
Given a inverting op-amp with Vin= 1Vpk,1kHz and Rin=1kΩ , Rf=2kΩ, VEE=-5V, VCC= 5V, Explain the output waveform, voltage gain, and it's phase of the circuit.
In the op amp model above, open-loop gain is 105 and Vcc=12V. Suppose the inverting-input voltage is vn=44μV and the noninverting input voltage vp=284μV. What is the op-amp’s output voltage vo (in volts)?
An op-amp circuit has a desired closed-loop voltage gain of 10. If the input resistor to the inverting input has a resistance value of 1 kilo-ohm, what value of the feedback resistor must be connected?
The op amp as shown has an offset voltage of +5 mV and the feedback resistor has a value of 1.05R instead of R. What are the offset and gain errors of this DAC?
Answer the following questions a) What assumption do we make for an ideal op - amp? b) Explain what slew rate is why it is important characteristic for an op amp.
Given a inverting op-amp with Vin= 1Vpk,1kHz and Rin=1kΩ , Rf=10kΩ, VEE=-5V, VCC= 5V, Explain the output waveform, voltage gain, and it's phase.
a) What is an Op-Amp, and how is it used? b) What is the equivalent circuit model for an op-amp? c) What is negative feedback, and why is it used in Op Amp Circuits?