Answered: 5. Write an assembly language program…

5. Write an assembly language program to convert an 8-bit binary data to BCD. The binary data is stored in 4200H. Store the hundred's digit in 4251H. store the ten's and unit's digits in 4250H

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter22: Sequence Control

Section: Chapter Questions

Problem 6SQ: Draw a symbol for a solid-state logic element AND.

See similar textbooks

Related questions

Q: The current that varies sinusoidally with time. Blank 1

A: Current is defined as rate of flow of electron in a conductor.

Q: A three-phase, 60-Hz, 500-kV transmission line has an inductance of 1.0424 mH/Km per phase and a…

Q: The numerical values for the voltages and the currents in the circuit of Fig. P1.9 is given in the…

A: Given:

Q: Calculate the decibel voltage gain for Ay value of 80 VN • A 75.1 dB • в. 38.1 dB е с 80 dB D-38.1…

A: We need to find out voltage gain in dB for given gain.

Q: R(s) = = = S G(s) s+3 s+4 C(s)

Q: 7. What is the purpose of the delta-wye transform as applied to resistor networks? Give an example…

A: Solution 7- Start-delta conversion- For star connection of resistance as Ra Rb and Rc- Now it can…

Q: VS 15 V A R1 · 2 ΚΩ R4 1 ΚΩ ww R2 3 ΚΩ R3 1 ΚΩ B 00 R5 • 2 ΚΩ Figure 2: Wheatstone bridge circuit…

A: Wheatstone bridge: It is the device that is used for the accurate measurement of unknown resistances…

Q: Illustrate the basic circuit of the permanent magnet motor

A: Permanent Magnet DC motor: These DC motors are the motors with poles built of permanent magnet. The…

Q: What is short-circuiting? State one factor/ condition that can lead to it. Name a device in the…

Q: A 10/3 Type NM copper used for an electric dryer branch circuit ampacity = maximum fuse or…

Q: The voltage gain of a common collector transistor is ********************* less than 1 O O more than…

A: Given:

Q: An audio signal 10sin 2π(2000t) amplitude modulates a carrier 20sin 2π(200000t). i) Sketch the…

Q: For double sideband (DSB) signal a) Write the time domain equation XDSB(t). b) Write the frequency…

Q: O-A 400 V. 15 kW, 4 pole, 50 Hz, Y-connected induction motor has full load slip of 4%. The output…

A: Given- Y-connected induction motor- Voltage V=400 V, Power P=15 kW, No. of poles p'=4, frequency…

Q: 1. A 4-pole duplex wound armature has 240 slots and 6 conductors per slot. Determine its speed if…

Q: The circuit which is used to add a positive or negative de voltage to the input waveform is called…

A: It is given that: The circuit which is used to add a positive or negative dc voltage to the input…

Q: 3. Find the energy of the signal x(t) 2sin(t) лt

Q: A 120 resistor must carry a maximum current of 25 mA. Its rating should be at least A. 4.8 W B. 150…

A: Given, Resistance, R=120 Ω. Maximum current, Imax=25 mA.

Q: For the following circuit if the secondary voltage of the transformer is 25V rms, the PIV of the…

Q: Find the angular velocity of a waveform with a frequency of a. 100 Hz. b. 0.25 kHz.

A: a) Given, Frequency, f=100 Hz.

Q: Q4 Determine the voltage Vin the circuit 2Ω 2Ω 10 V +1 1Ω + 1Ω<V ΤΩ

A: Given data, Circuit diagram is given as,

Q: A 120 resistor must carry a maximum current of 25 mA. Its rating should be at least A. 4.8 W B. 150…

A: In this question, Resistance R= 120 ohm and current I= 25mA We need to choose the correct option…

Q: Choose the best answer for the following multiple-choice: For the log-distance path loss model, the…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: 3. Determine all the mesh currents using mesh analysis. Show simplified equations and complete…

A: The given circuit diagram is shown below:

Q: 3. Determine all the mesh currents using mesh analysis. Show simplified equations and complete…

Q: 5. The signal operations shown in the figure below are designed to produce the output (1) - from the…

A: Given: A communication system block diagram with z(t)=200sinc(100t)cos(1000πt)x(t)=400sinc(200t)…

Q: 12. How you use voltage readings to determine whether a power system is three phases ? 13. The…

Q: What is the dc output voltage of an unfiltered half-wave rectifier whose ? peak output voltage is…

A: To find the dc output voltage of half - wave rectifier whose peak output voltage is 9.8 v

Q: 3. A three-stage amplifier has an input stage with noise ratio (NF) = 4 dB and power gain (PG) =…

Q: 5. In a DC generator, the iron losses at 1000 rpm are 10 kW at a given field current. At a speed of…

Q: 19. Gate A has tPLH = tPHL = 6 ns. Gate B has tPLH = tPHL = 10 ns. Which gate can be operated at a…

A: Given,For Gate A-tPHL=tPLH=6 nsFor Gate B-tPHL=tPLH=10 ns

Q: A de generator has 4 poles and runs at 1,750 rpm. The winding is of a type that provides four…

Q: A 4-ohm resistor is connected to a 12-volt battery. What current does it have flowing through it? R=…

A: Given- Resistor = 4 ohm Battery source battery = 12 Volts To find- Current through it=?

Q: What is the peak output voltage during negative cycle? choose answer here; -5.7 V 0 V -5.0 V…

A: A

Q: 6. Draw the Wheatstone bridge circuit diagram and explain how it can be used to measure an unknown…

Q: 16V +1 ΖΩ ell 4H

A: Given circuit:

Q: Find the value of k in the network in Fig. P2.129 such that the power supplied by the 7-A source is…

Q: is often referred to as a(n) A pure semiconductor intrinsic semiconductor O extrinsic semiconductor…

A: A pure semiconductor is also referred to as a intrinsic semiconductor.

Q: 2) y[n]-y [n-2] = 2x[n]-x [n=2] y[n] = 2x [n] -x [n-2] + 1/2y [h=2] h[n] =2&[n] -[n-2] + 1/2 h [n-1]…

A: As instructed we will solve the above question in the same pattern as it is shown in the example…

Q: 7. a. Determine V₁, I₁, Iz, and I for the network Fig. 2.186 if R₂ = 1802. Rs 20 V 10 IR 220 22 Vz =…

A: We need to find out the voltage, current for given circuit. For the given voltage regulated circuit…

Q: Each R is 10 ohms. Find R T and IT. 60V+

Q: Rea 12 Ω 12 Ω Find the equivalent resistance Req in the network in Figure. 12 Ω 12 Ω 12 Ω 12 Ω

Q: 2. Using source transformation, find ix. 50 M 105 Hix RASTA 2A BUTTE 1641 100V (+) DO NOT Report…

A: We need to find out the current for given circuit . We will do source transformation for given…

Q: The figure below shows a circuit that consists of two BJTS. Both transistors Q1 and Q2 are…

A: Solution !!

Q: Determine the voltage across the diode in Figure below, assuming silicon diode +il SV www 10 8V O 7V…

A: To find the voltage across the silicon diode in the given circuit

Q: 2-1 Measure and record the values of Ra, Rb, Rc, and V (the power supply voltage) = Blue 2-2.…

A: Given- Voltage, Vt = 5 Volts Value of resistance- Ra = 984 ohm Rb = 21850 Rc = 12920 To find- Rt =?…

Q: +1 16V (+ ww 202 type your answer... The circuit above is in DC steady state. What is the value of…

Q: Correct the equation VxE=0 for time varying field with necessary derivation.

A: This is a problem of electromagnetism. The detailed solution is given in the next step

Q: Q1) Design 4-8 decoder using 2-4 decoders.

A: Design of 4-8 decoder using 2-4 decoders: Let the inputs of 4-8 decoder be A,B,C and D. Let 'E' be…

Q: If a microprocessor can perform 4 million instructions per second, how many nanoseconds are required…

Question

5. Write an assembly language program to convert an 8-bit binary data to
BCD. The binary data is stored in 4200H. Store the hundred's digit in 4251H.
store the ten's and unit's digits in 4250H

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Discuss how the modern works with the aim of a diagram Compute the decimals values for the following binary digits 11101, 11111, 01010, 10101, 21212 NB. No plagiarism
Determine decimal values of the signed binary numbers expressed in 2’s compliment a. 01010110 b. 10101010 c. 11010111 d. 010010010
What are the decimal values of the following 8-bit binary fractions? (a) 0.01100001(b) 0.10001000.
To convert from binary to an octal numbering systems, we easily group each ___ binary digits (or bits) and write them as they equivalent to an octal. 3 2 4 8
What is the decimal number equivalent of the largest binary number that can be obtained with 9 bits? a. 512 b. 511 c. 1024 d. 1023
Convert decimal number 54.3125 to fixed point binary notation. How many bits are needed? Suppose there are only 8 bits available. What is the numerical error?
Add signed binary numbers (+5) and (-12). Use 8 bits to represent your numbers.
Find the sum of all the digits in 1/1/2003 and then do the tollowing:(a) Convert the sum into 32-bit binary.(b) Convert the sum into 32-bit, IEEE-754 single precision floating point format.For example, if your date of birth is 15-8-2001, then the sum of its digits would be 17. You should convert it into 32-bit binary and single precision floating point formats.
Convert the decimal number 27.315 to binary. and Calculate the binary equivalent of 2/3 to eight places after the binary point. Then convert the binary equivalent back to decimal and see if you get the same result.
Perform the indicated arithmetic on the following signed 2’s complement binary numbers. a) 01011011 + 11100101 b) 01001 - 01110 c) 1111 + 1100 Note: The answer should show the 2’s complement binary result; also indicate if each result is positive or negative or overflowed (by writing “positive”, “negative” or “overflow” next to the binary answer) and then follow with the decimal value of the result if there was no overflow. Do not extend (add any additional length) to these representations, but rather use a binary number word size equal to those found in each problem statement.
Determine the logic required to decode the binary number 1011 by producing a HIGH level on the output.
Design a circuit with logic gates that tell us if a number less than 10, codedin binary, it is either prime (1) or not (0). Minimum up to 16 combinations.True tableII. Boolean functionIII. Simplification procedure by any of the methods