5.7 0.25 0.5 t(ms) -5.7

Q: Q5: Write the Difference Equation for the following sampled system, and solve it: x[n] 0.2 + yln]…

A: First we will find z domain transfer function , then we will take inverse z transform to find out…

Q: 5) The equation used to calculate the Current gain in decibels is: a) 20 log |Ai| b) 10 log |Ap| c)…

A: to represent gain in decibles we apply log to the gain multiplied by 20 but for power we multiply…

Q: Q4) A black and white television picture may be viewed as consisting of approximately 3x10 elements…

A: The solution is given below

Q: Give the circuit of 4 bit switched capacitor DAC.

A: DAC circuit convert digital data in to equivalent analog data. A ADC circuit convert analog data in…

Q: A Hartley Oscillator circuit that has two individual inductors of 0.5 mH each, are designed to…

A: This question belongs to analog electronics . It is based on the concept of Hartley oscillator . It…

Q: A transistor whose forward current transfer ratio (Beta) is 100. What will be the value of the base…

A:

Q: 1) We have a low pass analog signal of 6kHz. If we send the analog signal, we need a channel…

A: Analog to digital conversion done using PCM  Channel Bandwidth required for pcm is Rb  Rb is bit…

Q: A communication system has five stages, with gains and attenuations of 12, 245, 68, 231, and 9 dB.…

A:

Q: Short channel MOSFET has Vt = 0.4 V, Cox 1.6µF/cm, EL=D 0.6V, L= 130 nm, vsat = 8x10° cm/sec and…

A: Lets determine Vd sat=Vgs-VtEcLVgs-Vt+EcLVin=Vgs=1.8Vout=Vds=0.6=1.8-0.40.61.8-0.4+0.6Vd sat=0.42Vd…

Q: An AM receiver has 3 cascaded RF amplifiers arranged such that the IFRR successively increased by…

A:

Q: Consider the digital circuit shown below - Compute the value of Y if A=1, B=1, and C=1.

A: ANSWER:- Y=1

Q: Several high-fidelity audio channels having fm = 15kHz are to be transmitted via binary PCM with 1=…

A: Find the detailed solution in below images

Q: Calculate the bandwidth of a system that has a capacity of 60.4 kbps with a signal to noise ratio of…

A: Given  Channel capacity, C = 60.4 kbps  Signal to noise ratio, SNR = 250 Then find bandwidth of the…

Q: there are the answers i just need the procedure

A: Pinch-off point: V­D increased to a point that charge Qn(y) in the inversion layer at y=L, number of…

Q: If an audio transformer which has an impedance ratio of 40:1 is used to match the output of a power…

A:

Q: Assume the following values for an ADC, with a 8-Bit input: • Clock Frequency = 2 MHz • VT = 0.1 mV…

A: Given Data, Number of bits (N)=8 bit Voltage (Vfs)=5.12V Voltage (VT)=0.1mV Frequency clock…

Q: Design a VCO circuit that will produce a square wave output at 2.6 kHz.

A:

Q: A channel is termed noise free if its entropy 'a posteriori' is zero. Select one: O True O False

A: Channel capacity is the nothing but maximum amount of mutual information in the channel . Mutual…

Q: 2. The Advanced Mobile Phone System (AMPS) uses two bands. The first band of 824 to 849 MHz is used…

A: The advanced mobile phone system uses two bands and they are,1. For sending - 824 MHz to 849 MHz2.…

Q: For the cascaded amplifier shown below, determine the output voltage V,. Show the details of your…

A:

Q: If the input voltage 32VP.P and f=50HZ, sketch the output of the circuit shown below. 10kA TD D. 10k…

A: NOTE: "Since you have asked a multiple question, we will solve first question for you. If you want…

Q: A transistor amplifier connected in CE mode has a = 0.9 and I = 10 mA, compute the values of base…

A: We have an transistor amplifier connected in CE mode with,  α = 0.9 IE = 10 mA = 10 * 10-3 A   And…

Q: Design a Bipolar Junction Transistor amplifier that has an input of 400mVpp at 3kHz and has an…

A: The amplifier circuit can be designed as Small-signal modeling of the amplifier

Q: Solve the le (Emitter current) of the given circuit. Vcc=20 V 1.37 MA 1.02 MA 6.22 MA www 220 ΚΩΙ 56…

A: We need to find out the emitter current for given circuit

Q: 1- Discuss active high when s and R are one

A: According to the question we have to discuss active high S and R are one.

Q: Obtain the parameter H12

A: An electrical circuit is represented by two port network. It has an input port and an output port.…

Q: If you are to design a phase-shift oscillator, what are the factors (enumerate) that you need to…

A: If you are to design a phase-shift oscillator, what are the factors (enumerate) that you need to…

Q: Q1] A CD audio laser- disk system has a frequency bandwidth of 20 Hz to 20 KHz. What is the minimum…

A: Given: Fmin=20 HZ Fmax=20 KHZ Nyquist Sampling Rate Fs>=2Fm

Q: Determine the range of gain K for stability (theoretically) R(s) C(s) s +1 K s+5 ² (s + 2)

A:

Q: consider the following input/output table: P Q RS 1 1 1. 1 1. 1 1. 1 1. 1. 0 0 00 draw a circuit…

A:

Q: Q.1 For the circuit shown, calculate the A, and the C, that required to obtain 1.77KHZ lower…

A: Given the circuit: We need to find Av and also to find the value of C2 to otain lower critical…

Q: In the following CE amplifier with the following values given: A) Calculate the appropriate…

A: This question is from "Advance Analog Electronics". Under which we are going study about the hybrid…

Q: Q5: Write the Difference Equation for the following sampled system, and solve it: 0.2 ylm) 0.4 0.4…

A: z-transform is a linear transformation from the discrete-time domain into the complex z-domain.…

Q: Q4) A black and white television picture may be viewed as consisting of approximately 3x10° elements…

A:

Q: a) Calculate the input SNR of an amplifier in dB if its output SNR is 10.23 dB and the Noise Ratio…

A: Signal to Noise Ratio- Signal to Noise Ratio- It is a measure utilized in science and engineering…

Q: 1.1. Assume the following values for the ADC clock frequency = 1 MHz; VT= 0.1 mV; DAC has F.S.…

A: The digital output can be calculated by using the resolution of ADC and the reference voltage.

Q: hich of the following are the gain and time constant of the given electrical system, with the input…

A:

Q: Problem #5 – A PLL synthesizer is designed to produce any frequency from 44 MHz to 45 MHz in 25 kHz…

A: Given frequency range of PLL synthesizer is 44MHz to 45MHz. A frequency synthesizer allows the…

Q: Q4: Design a car alarm system that gives a continuous beep for 23 seconds every time the car door is…

A:

Q: A channel is termed noise free if its entropy 'a posteriori' is greater than zero. Select one: O…

A: A channel is termed noise free if its entropy a posteriori is greater than zero this statement is…

Q: Regarding to the Wien bridge oscillator, Design the electronic circuit of an oscillator using 22KΩ…

A:

Q: Find the conddition on K to make the system stable. s"+ 2s+ 35² +2s+ k =0

A: Routh Hurwitz  necessary but not sufficient  condition for stability is a)The coefficient of all…

Q: n measurement system, encoder is an example for digital output signal. Select one: O True O False

A: In measurement system encoders act as position measuring sensors. They measure the angular position…

Q: A device has an output bit rate of 512 kbits/s. Design a digital modulation scheme for the device if…

A: According to the question, we need to design a digital modulation scheme for which  Bit rate=512 k…

Q: A radio receiver consists of an RF amplifier, a mixer and an IF amplifier with the following…

A: According to the question, for the given communication system, we need to find a) Calculate the…