50 µF 70 μF 60 μF 20 µF " 120 μF Respuesta: 40 μF.

Q: Using the Routh-Hurwitz criterion, find the value range of K to get a stable system having a…

A: Introduction Routh-Hurvitz Criterion: The Routh-Hurvitz Criterion is used to determine the stability…

Q: Please Must Show Given Questions in Design for 11KW Motor .  A15 kW, 440 V, 4-pole, 50 Hz, 3-phase…

A: I have written this solution as handwritten solution. Hope you find your solution clearly.

Q: CONVERT TO SFG

A:

Q: In the circuit given below, R = 20 2. Using nodal analysis, find vo and io in the given circuit. 96V…

A: I have written this solution as handwritten solution. Hope you find your solution clearly.

Q: Use the node voltage method to find the voltage, V, across the 3 A current source. 18 Ω + 8 V O OF…

A:

Q: For the circuit shown find the impedance phase angle Z (in degrees) i = 0.02 sin(157t + 40) V=2547.4…

A: We need to find out the phase of impedance.

Q: Obtain numerical values for the two mesh currents i, and is in the circuit shown in Fig. 4.61. SV…

A: Introduction: Mesh current: Mesh…

Q: Exercise 7: Let x(t) = sin² (10nt). Find the additive combination for x(t), and then plot its…

A: To find an additive combination in the form of x(t):

Q: 5 = 14 2k 3k 4k 13 A a) habel b) KVL 8. c) KCh d) Set of equations

A: All the loop currents and node voltage s are labled.

Q: Problem 3: Calculate the Y-parameters matrix for the circuit shown below: 652 3Ω 692 ww 352

A: Introduction Y-parameters The Y-parameter matrix can be used for modeling and analysis of various…

Q: A potential difference of V = 58.0 V is applied across a circuit with capacitances C1 = 4.7 nF, C2 =…

A:

Q: P 3.4-11+ Determine the values of the resistances R₁ and R₂ for the circuit shown in Figure P…

A: The given circuit is shown below,

Q: -1 Figure P1.5-9 0 1 1 t (a) Determine and carefully sketch the original signal x(t). (b) Determine…

A:

Q: Given a block diagram for a mechanical system as shown below: R(S) + Gl Find transfer function. T(s)…

A:

Q: What are the problems that may encounter in real-time monitoring and control of microgrids for…

A: We need to tell about what are the problems that may encounter in real-time monitoring and control…

Q: It doesn't look like you accounted for the current 2A going into V3/6. Please review and fix any…

A: In the given above solution first two parts are correct.last part some corrections is done it is…

Q: Find the current that passes through the 12 resistor. A D 352 www 6V E www F 192 www 292 392 www 9V…

A:

Q: Q1/ For the circuit shown if the supply frequency is 50 Hz A- Find the Mesh equations B- Calculate…

A: Given the circuit,

Q: A unity feedback system has the following G(s) G(s) = 8² +8+2 Find the closed loop system

A: Given data, In a unity feedback system, Gs=ss2+s+2. Feedback transfer function, Hs=1

Q: (a) The control input is the elevator deflection angle u(t) = 8(t). Define the output as y(t) = 0…

A: Solution of question (1): The given linear time-invariant ODE is y...+0.74y..+0.92y=1.2u.+0.18u. The…

Q: Complete the timing diagrams to document the behavior of a D-latch and a D-flip-flop.

A: The latch is a device that changes its output during the level trigger of the clock whereas the…

Q: Consider the circuit below. b R1 w R₂ R3 mi R5 R7 wit RG R42 RS # /= 8A, /₁ = 2.2A, V4 = 37.2V, and…

A: Note: Current in series circuit remain same but voltage change based on resistance. Voltage in the…

Q: Across a 230 V, 60 Hz power supply is a 15 Ω non-inductive resistor. Find the equation  of the…

A: We need to find out the current through given resistor.

Q: Determine the phase difference between the two waves v_1 (t)=10 sin( 377t-30)V v_2 (t)=10 sin(…

A: Given data: v1(t)=10sin(377t-30)Vv2(t)=10sin(377t+90)V

Q: An inverting amplifier has an input resistance of 2 k. Determine the feedback resistance needed to…

A: Given data, An imverting amplifier has, Input resistance, R1=2 kΩ Voltage gain, Av=100

Q: 1) 2) 90 (± 4 +50 V 18v 52 3V -i ia J.s Find i + 30 V₂ 2 Find V₁ = ¿₁ کو 2 = i₂=

A: Note: Current in series circuit remain same but voltage change based on resistance. Voltage in the…

Q: The solution looks incorrect. For node voltage 3 analysis it should be in respect to node 3 not node…

A:

Q: (c) A DC motor, which is supplied by a 30 V DC power source, is operating at a constant motor speed…

A: Current drawn by the motor =Terminal voltage-Back emfArmature resistance. Power output = Back emf×…

Q: For the circuit shown find the impedance phase angle Z (in degrees) i = 0.02 sin(157t +40) V=2547.4…

A:

Q: : For the antenna array shown below, Estimate the distance between each two elements (in A scale) if…

A: Antenna Array:

Q: 12V 100 ΚΩ 12 ΚΩ ww 47 ΚΩ Μ 12 mA 10 ΚΩ HI a

A:

Q: R Apply the principle of voltage division to find the voltage Vbc in the circuit below. 12V d 12-22…

A: Note: Current in series circuit remain same but voltage change based on resistance. Voltage in the…

Q: find the voltage gain V₁/V; and input resistance for circuits a, b, c, and d. Q6 Assuming ideal op…

A: It is given that:

Q: i=I sin(Ⓡt + ;) V = V sin(cot+) N he voltage signal has an amplitude of V= 58.8 and its phase angle…

A:

Q: In Fig.4 is shown feedback control system with the following transfer functions:Ge(s) = K; G(s) = 1…

A:

Q: 3. Calculate the directional derivative of f(x, y, z)= x²yz in the direction of at (1,-1, 1).

A:

Q: 7. What kind of issues can be met during implementation of PLC (Programmable Logical Controller) and…

A: Introduction PLC: PLC stands for Programmable Logic Controller, and it is a type of computing system…

Q: A 3-phase 100 kVA, 2300 volts, 60 Hz, 4-pole wye connected alternator having a synchronous impedance…

A: Given Data, 3 phase  100 KVA, VL=2300 Vf=60 HzZ=1.2+j20 ΩPout=34.5 kwPower ffactor=0.866 laggingY…

Q: The dimensional equivalence of the quantity "momentu OMLT! Ob-L²T² OC MLT ○ MLT¹ in terms of the…

A: Note:   Momentum = Mass× VelocityVelocity=DisplacementTime

Q: For the circuit below the input voltage is V1(t) = 12 cos(4t) V. Determine the current flowing…

A: Introduction Series RLC circuit: A series RLC circuit is a type of electrical circuit that consists…

Q: 1. The voltage u (t) = 12 cos (377t + 20°) V is applied to a 20-mH inductor, find the phasor…

A: In this question We need to determine the current in the phasor.  We know current I = V/Z Inductive…

Q: Given the NE555 timer IC and a 9 V supply, design a circuit to generate a continuously running…

A: NE555 Timer IC:

Q: S+2 2 s² +9' 5. T(s)=- 3. For each of the transfer functions shown below: (a) plot the locations of…

A:

Q: Given below the implementation of 3-input function f using two two-input LUTS. By dragging and…

A: Given: In this question, the given details are, Given below the implementation of 3-input function f…

Q: 1- In a buck DC/DC converter: V₁ = 100 V, R= 8M, D= ton = 0.8, f == 20000 Hz, L = 200 µÍ, Find: a)…

A: Types of Converter   DC-DC Converter (Chopper) DC AC Converter (Inverter) AC-DC Converter…

Q: 2. Consider the following circuit: a) What does Req, equal? b) What does Reqz equal? Req1 2 ΚΩ Μ × 6…

A: We need to find out the equivalent resistance for given circuit.

Q: The boolean expression F(X, Y, Z) = X Y+Y'. Z is O in simplest SoP form O in simplest PoS form O in…

A: Given, The boolean expression is, FX,Y,Z=X·Y+Y'·Z

Q: Find the Laplace transform of f(t)= t'e cos(3t)

A: Given the function, ft=t2e-2xcos3t

Q: A 220 V, 60 Hz circuit draws a current of 11 A with a power factor of 0.8 lagging. Find the…

A: V=Voltagef=FrequencyI=CurrentZ=VIZ=R+jXR=Z cosϕX=Z sinϕ

Q: A unity feedback system has the following G(s) G(s) = 2 s+3 Use the LaPlace Transform to calculate…

A: Given, A unity feedback system has, Gs=2s+3. Hs=1. Input is unit step function, rt=ut.

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.