50 kN 3 m 3 m 50 kN 3m E 4m 60 kN 90 kN 3 m 3 m 90 kN 3m

Q: The top width and the depth of flow in a triangular channel were measured as 4 m and 1 m,…

A:

Q: 28. A plate (2 m x 2 m), 0.25 mm distant apart from a fixed plate, moves at 40 cm/s and rec force of…

A: F=1N Velocity of plate=40cm/s Area of plate=2*2=4m2 to find dynamic viscosity

Q: How did the romans influence the world when it comes to road building construction? 2. Would you…

A: Roman roads were the earliest roads and the road with proper camber for drainage purpose and they…

Q: A tape was suspended in four spans under a pull of 14.78 kg and mean temperature of 14°C. Each span…

A:

Q: Which concrete is expected to have more compact skeleton or denser, between concrete containing only…

A: To determine the which one of the aggregate will produced more compacted and dense concrete.

Q: Give some insights and reflection about the "Significant Factors Causing Cost Overruns in the…

A: One of the factor which determines the success of a project and satisfaction of client is that…

Q: etermine the horizontal deflection at joint C of the truss by virtual work method. Use E = 10,000…

A: E=10000ksi A=5in2 L1=4ft L2=5ft L3=12ft To find horizontal deflection at point C

Q: 10. Given the specific gravity of oil is 0.85, what is the density in slugs/ft^3?

A: CONCEPT: Specific gravity is defined as the ratio of density of particular fluid to the density of…

Q: Normal Stress at Failure Plane A-B A) 76.32 kPa B) 76.22 kPa C) 76.42 kPa D) 76.52 kPa

A:

Q: #4 (a) A river discharges 1000 m³/s of water at high flood level of R.L. 103 m. A weir is…

A:

Q: T 2m 3 m B 10 kNE A 20 kN F 2 m2 m C D

A:

Q: What is rock's minimum principal stress? (A) 72.33 kPa (B) 72.53 kPa Ⓒ 72.23 kPa (D) 72.63 kPa

A: Using formula

Q: Consider the building in the figure, which has a width into the page of 35 ft. Maximum inundation…

A: Given:- The width of the building = 35 ft The maximum inundation height = hmax = 33 ft The flow…

Q: By the mixed method of joint and section, determine the bar forces in the lattered bars of the K…

A:

Q: Reinforce concrete design

A: Beam =350mmx600mm Length =8m Let assume f'c , fy and fr

Q: According to Lacey's theory of channel design, what will be the velocity of flow in the channel…

A: Given : Discharge(Q) = 140cumec= 140m3/s Silt factor (f)=1 To determine : velocity of flow V

Q: Draw a typical canal cross-section which is partly constructed in cutting and partly in filling.…

A: Canal cross section constructed partly in cutting and partly in filling- In this type of canal the…

Q: Use the portal method and determine (approximately) the reactions at supports A and B. YkN XKN A 5 m…

A:

Q: An agricultural land of 437 ha is to the irrigated for a particular crop. The base period of the…

A: Given- Area A=437 ha, Base period B=90 days, Total depth d=105 cm, Rainfall  P=15 cm.

Q: 2. Discuss and explain with illustration the graphical method in finding the resultant of two or…

A: The resultant is indeed a single force that exerts the same impact as several forces working…

Q: A BOD test is conducted using standard size BOD bottles. The technician prepares  two BOD bottles on…

A:

Q: Problem 3.5 - Given the cable tension T = 80 lb, determine a) the moment about point A due to T, and…

A: To determine the,  a) Moment about A due to T b) Shortest distance from point A to line BC.

Q: 30. If the volume of a liquid is decreased by 0.25 % for a change of pressure from 6,500 kPa to…

A:

Q: Q. 13. A 2.5m wide rectangular channel carries 6m³/s of flow at a depth of 0.50m. Calculate the…

A:

Q: Current Attempt in Progress Oil flows through the system shown in the figure below with negligible…

A:

Q: The influent wastewater flow at TMWRF is 30 MGD (million gallons per day). The facility conducts…

A:

Q: Compute the bearings of sides BC and CD in the accompanying figure. Leave your answers in degrees…

A: Objective: To determine the bearings of sides BC and CD.   Given: Bearing of line AB: S72°39'W Angle…

Q: Current Attempt in Progress (Bernoulli/continuity) Water flows steadily through the pipe shown in…

A: GIVEN- Pressure at section 1(P1)=320 kPa Pressure at section 2(P2)=80 kPa Velocity at section 1…

Q: Determine the value of El y at the right end of the overhan a =4.7 m, b = 2.6 m, Wo = 19.7 kN/m

A:

Q: Q. 13. A 2.5m wide rectangular channel carries 6m³/s of flow at a depth of 0.50m. Calculate the…

A:

Q: Situation #4 Determine the force in each member of the truss 60⁰ B, -Am -Am- Am 60 16. What is the…

A: Find out the support reactions and all member forces in the given truss. Use equilibrium conditions…

Q: A strut is attached to a wall at (x, y, z) = (0, 0. 0) and extends to a point located at (2, 3, 3)…

A:

Q: (Bernoulli/continuity) Water flows into a large tank at a rate of 0.011 m³/s as shown in the figure…

A:

Q: Determine the value of El y at the right end of the overhanging beam. a = 4.1 m, b = 2.4 m, Wo 19.0…

A:

Q: pulley system shown in the picture, and their friend begins to pull on the free end of the rope on…

A: Given:-height=6mspeed=0.90m/sTo find:-time to lift the child upto the platform in the tree

Q: In the recent earthquake, the velocity of P-waves is 3.12km/s while it traveled on the soil whose…

A:

Q: what's the mean height(h)?

A: The mean height of the building is defined as the average height of the roof from the ground level.…

Q: A typical hospital floor in a seven-storybuilding is composed of a 300mmthick slab resting on steel…

A:

Q: A pipe-line carrying water has average height of irregularities projecting from the surface of the…

A:

Q: As shown in the figure, a rigid beam with negligible weight is pinned at one end and attached to two…

A:

Q: 29. At a certain point in an oil the shear stress is 0.2 N/m^2 and the velocity gradient is 0.21 per…

A:

Q: A cantilever retaining wall is required to support a backfill having the following soil properties:…

A:

Q: Why are the arrows in the right direction when they are in the left direction in the original image?…

A: Required: Explanation for  Why forces direction have been considered opposite to that shown in…

Q: Question- An outlet irrigates an area of 20 ha. Find the discharge (l/s) required at this outlet to…

A: Given- Area A=20 ha,Base period B=20 days,∆=20 mm=0.02 m, It is needed to find the outlet discharge.

Q: *3-48. Determine the tension in the cables in order to crate. 400 N support the 400 N is weight of…

A: Objective: To determine the tension in the cables.   Given: Weight of the crate (say w) = 400 N…

Q: The velocity of a particle along the s-axis is given by v= 6s wheres is in millimeters and vis in…

A: Using formula

Q: Problem An open circular tank of 20 cm diameter and 100 cm long contains water upto a height of 60…

A: Given Diameter of cylinder D=20 cm, Hence, R=10 cm, Length L=100 cm, Height H=60cm, Speed N=300…

Q: Question 3: Consider the power transmission-line tower shown in the accompanying figure. Is this…

A:

Q: Size (mm) Weight retained (g) 18.96 33.18 45.03 54.51 42.66 11.85 4.74 4.74 21.33 0.25 0.149 0.075…

A: In the given table, sieve sizes and weight of the material retained at each sieve are given. We have…

Q: Gasoline flows steadily downward through the pipe shown in the figure below. Viscous effects are…

A: Given data: P1=0

MATLAB

MATLAB software is a registered trademark, multi-model programming language, and numerical computing environmental system created by MathWorks. 'MATLAB' is the short-form of "Matrix Laboratory". The MATLAB software permits the utilization of matrix operations, graphical representation of data, execution of algorithms, development of user interface, and linking programs created in other languages. Even though MATLAB is developed mainly for numerical computing, there is an optional toolbox that uses a symbolic engine known as MuPAD giving access to all the symbolic computing abilities. In addition to this, a Simulink package delivers graphical multi-domain simulation and design that is model-based for embedded and dynamic systems. MATLAB users are spread worldwide across the world and use MATLAB extensively.