50 V MM 8 ΚΩ MM HH 20 mH ww 4kQ MM 4k (1 2.5 mA

Q: In a two-terminal network, the open-circuit voltage measured at the given terminals by an electronic…

A: We need to find out the current through load for given circuit .

Q: Two long parallel current carrying wires are separated by 5 cm in air and are carrying current of…

A:

Q: Draw the logic diagram and logic equation of the followings: NOR IMPLEMENTATION: A. NOT B. AND…

A: Given, Implementation using NOR gate  A) NOT gate B) AND gate C) OR gate D) XOR gate E) XNOR gate

Q: Q3/ Consider the circuit in Figure (2), answer Three branch only. (a)-What type of circuit is this?…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: In signal detection terms, if you are doing something where a miss would be horrible and a false…

A: According to the question, we need to find the criteria of the signal detection under the given…

Q: A 50-m long transmission line has a total attenuation of 15 dB. What is the attnuation coefficient…

A: We need to find out the attenuation coefficient for given transmission line .

Q: For the following parts, identify the name of each circuit, plot the output waveform, and find the…

A: Given, Input AC voltage, V∘=Vmsinωt and Circuit 1, Circuit 2, Circuit 3, Average output voltage…

Q: B: Drive the radiation intensity equation of an isotropic antenna.

A: Isotropic antenna properties No pre-specified direction of the radiated wave It can radiate in any…

Q: Q.3 When a line-to-ground fault occurs, the current in faulted phase 'a' is 100A. The zero-sequence…

A:

Q: lossless transmission line operating at 50 MHz has a surge impedance (40 + j0) ohms and a…

A: We need to find out value of inductance for given transmission line .

Q: Solve for the equivalent capacitance at terminals a and b from the circuit. Given C1=50mF, C2 =…

A:

Q: What mathematical operation does an amplitude modulator perform? What is the ideal relationship…

A: Given: Amplitude modulator Modulating signal Vm and carrier voltage signal Vc.

Q: Question 15 6 Rb ww Vcc Question 16 6b Rc Consider the BJT circuit shown above with the values R =…

A: We need to find out the emitter voltage and collector voltage for given circuit , first we will find…

Q: A.) A coal-powered station has a maximum demand of 30 MW, a load factor of 60%, plant capacity…

A: Given data, Load factor LF = 0.6 Maximum demand = 30 MW

Q: A 230 V shunt motor has a nominal arma- ture current of 60 A. If the armature resist- ance is 0.15 ,…

A: The shunt motor is rated for 230 Volts.  The armature current is 60 A.  a. The counter emf is,…

Q: In a two-terminal network, the open-circuit voltage measured at the given terminals by an electronic…

A: Given data- 2 terminal network, Open circuit voltage- Voc=100 V, Ammeter reading I=5 A, Load…

Q: For the circuit below if EI=5V, D1=0, D5=0 the state of L1 to L5 will be: D E D7 D2, D3 10 5 OO OO M…

A: Given data: The IC seen here, the 74LS148, is an encoder with an 8-line input and 3 outputs. The…

Q: The stator of a 3-phase, a 4-pole induction motor is connected to a 50 Hz supply. The rotor runs at…

A: Number of pole pairs p = 42=2 Frequency f = 50 Hz Number of revolutions = 1455/minute We have to…

Q: 4. Determine the value of v and the power supplied by the independent current source in Figure D. 16…

A: The circuit diagram is shown below,

Q: Control System , Given transfer function, T (s) = αs + β / s^2 + (α + 2)s + β (i) Pick a…

A:

Q: Two coils in different connection have self-inductance of 2 mH and 4 mH and a mutual inductance of…

A: Given: Two coil in different connection with, Self inductance: L1=2 mH.L2=4 mH. Mutual inductance:…

Q: B: Drive the radiation intensity equation of an isotropic antenna.

A: Isotropic antenna properties No pre-specified direction of the radiated wave It can radiate in any…

Q: For the circuit shown, the potential of point A is zero. Determine the potential of poir 2.00 Q A…

A: Here basic properties are applied to solve it.

Q: Question 7: A 415V, three-phase, 50 Hz, 4-pole, star-connected induction motor runs at 24 rev/s on…

A:

Q: V₁ R₁ www 4₁ R₂ www R3 12 www R4 www 12 (↓) i

A:

Q: . In the transformer shown in the below figure, the inductance measured across the terminal 1 and 2…

A: In the given Transformer : When terminals 3 and 4 are open then inductance across terminals 1 and 2…

Q: Q4: A: A string of 3 insulators and the ratio of Ce/C = 0.15, if the string is connected to 3-4 line…

A:

Q: The waveform shown in the figure shown is observed on the screen of an oscilloscope. If the vertical…

A: Given: Oscilloscope screen, Vertical attenuation is set to 0.25 V/div.

Q: After closing the switch 'S' at t = 0, the current 1 (t) at any instant 't' in the network shown in…

A: Given data- Time constant- τ=LR=0.01, To Find- The current at any instant (t).

Q: A three-phase cage induction motor is started by direct-on-line (DOL) switching at the rated…

A: Given data- Three phase cage induction motor- Starting current- Is=6×full load current,Is=6×Ifl.…

Q: 0-120 vac C 8.8NF 20.457H 3 @ 171-43~ supply voltagez loov Lo Find, IT, Vc, VL, VR

A: Given parameters are: Supply Voltage VS=100V∠0° Capacitance, C=8.8μF Inductance, L=0.457H…

Q: Feedback & Control Systems - Time Response PLEASE ANSWER BASED ON THE 2ND PICTURE.

A: Given: Unit step response, Y(s)=5s(s+3)(s+6) for a system having Transfer function: T(s)=5(s+3)(s+6)…

Q: What are the advantages of switching from copper to fiber optics as a transmission medium?

A:

Q: A generator with constant 1.0 p.u. terminal voltage supplies power through a step-up transformer of…

A: Given data- Generator constant terminal voltage = 1.0 p.u. Reactance=0.12 p.u. Finite bus…

Q: A 50-mH inductor is connected to a 12-V rms source. What is the true power? What is the reactive…

A: We need to find out the power and reactive power for given inductor .

Q: A 12 Volt lead-acid car battery, engineered for "up to 500 or more charge/discharge cycles," has a…

A: Given: Lead Acid Car BatteryBattery voltage = 12vBattery Amp-hour = 225Battery Carge/Discharge cycle…

Q: What are the different types of write operations used in 8253?

A: Given: The given programmable timer used is 8253.

Q: Why do we use Laplace transforms for control systems? please discuss comprehensively. thanks!

A:

Q: Consider the sequential circuit in the following figure with four 4-bit registers (made of rising…

A:

Q: 7- The current distribution of the finite antenna is 8- The radiation resistance of the single turn…

A:

Q: 3. For the pair of 2nd - order system specifications below, find the location of the 2nd - order…

A: Given data: Settling time, Ts=7 seconds Peak time, Tp=3 seconds The question is to find the location…

Q: Determine E at the origin due to a uniform line charge distribution with ρL = 3.30 nC/m located at…

A: Given data, Line Charge Distribution ρL=3.3 nC/m Location x=3 m,   y=4 m

Q: 4- The directivity of the Infinitesimal dipole equal to .......... dB. when all power injected to…

A:

Q: How can the noise level of a photomultiplier detector be reduced below the level of shot noise? a.…

A: Photomultipler detectors Used to measure intensity of visible and UV radiation  It can amplify the…

Q: A 36- pole alternator is operated at 200 rpm. What frequency is generated?

A: Given, Number of poles in alternator, P=36. Speed of operation, Ns=200 rpm.

Q: 2. superposmon a) 6V(+ 2mA OITTe 2 km www 4th 2kf Cons 6 kn ww 01

A:

Q: The rated speed of a three-phase, 2-pole, 50 Hz cage induction motor is more likely to be d) 1750…

A: Given: A 3-phase cage induction motor has, Number of poles, P=2. Rated frequency, f=50 Hz.

Q: Why are lamps in a house lighting circuit not connected in series? +9+40 0900 6443! 404/g! Meup of…

A:

Q: Q2- Design a voltage regulator that will maintain an output voltage of 20V across a 1K0 load with an…

A: The value of the sourse resistance and the maximum current have been identified with the help of…

Q: find the value of i3 in the circuit below. R₁ = 100 www 20 mA 1 www R₂ = 25 Ω www R₂=7592

A: Given circuit:

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.