ば 52+GS+13

Q: Question 5. (a) Explain the expected stylization of the autocorrelation functions for the following…

A:

Q: magnitude of the line current,

A:

Q: Decompose the following non-minimum phase system into a minimum phase system and an all-pass system.…

A:

Q: A surge of 100 kV travels along an overhead line towards its junction witha cable. The surge…

A: we need to determine magnitude of the surge transmitted through the cable.

Q: Three phase star connected system has I = 1040, I = 104270 c=154135 determine the Symmetrical…

A:

Q: Problem 3.1: Determine the rms value of voltage induced in an 80-turn coil on a 30 cm × 25 cm…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: 10.If the number of poles is constant, how to control on the generated frequency of 3 phase…

A:

Q: classify the systeninto a-Linearornan tinees brTimeinvaiant Causal

A: Causal System: Output at any instance of time depends on past instance of input and atmost present…

Q: A single-phase line has two parallel conductors 256 cm apart. The diameter of each conductor is 7…

A:

Q: a load of 15 mva with power factor 0.86 lagging is given. Calculate the reactive power delivered by…

A: Given, A load of 15 MVA with power factor 0.86 lagging S=15 MVAso, P= 15×0.86=12.9 MW And, power…

Q: Q21-The Line Volta8es at the terminal ofabalanced Yeomected Lood 1S VAB-12066Each phase of the Lood…

A:

Q: In a 10 km long three phase conductor diameter of 2.5 mm the conductors are arranged symmetrically…

A:

Q: Q6/B: A three-phase double circuit line is shown below, the diameter of each conductor is 2 cm. F…

A:

Q: Most industrial loads (Motors, Fluorescent lights) are inductive in nature and have a lagging power…

A: To select correct answer Most industrial loads (Motors, Fluorescent lights) are inductive in nature…

Q: single phase transmission line has two parallel conductors 1.5 meters apart with 2.5cm diameter. The…

A: We know direct formula for loop inductance ,we will use that formula to find loop inductance.

Q: single phase full wave half-controlled

A:

Q: Q1. An equilateral transmission line has a total corona loss of 53 kW at 106 kV and a loss of 98 kW…

A: Given data, Corona loss P1=53 KW at V1=106 KV Corona loss P2=98 KW at V2=111 KV Phase voltage is…

Q: The type of dc generator used for boosters on d.c feeders is a O Series generator O shunt generator…

A:

Q: Q.1) By using Nodal theorem find (i). 30

A: Need to find current i1 in the given circuit

Q: Draw the single line diagram and determine the Y bus matrix for the given data. All admittances are…

A: In this question we need to draw a single line diagram and find Y bus matrix of the given system

Q: please model a transmission line pair with an equivalent circuit model. establish the transmission…

A:

Q: mcq single-phase unidirectional AC chopper is fully controller chopper   Semi controller chopper…

A: Half wave controlled rectifier are unidirectional AC coplper.

Q: A1 heee hee ll ee B2 ll A2 To three-phase load

A:

Q: Lwechinn 0,- Find out the eguivalent eircnit of a lons line by wsing TT no minal of transmission. ne…

A: Given long transmission line of length l=500 km Characteristic impedance Zc=410∠-6.5°…

Q: (a) The line currents in amperes in phases a, b and c respectively are 500 + j150, /100 - j500 ånd…

A:

Q: Which of the following combinations comprise the Transmission Line Impedance? O A. Conductance and…

A: Consider the diagram for the equivalent circuit model for the characteristic impedance  of the…

Q: ork why we need to consider the neutral impedance 3 times

A: The zero sequence components are in having the same phase in all the three phases. When there is a…

Q: Derive the formula for admittance and draw the current triangle and admittance triangle for parallel…

A: Explanation is given in step -2

Q: 10 + 16 * 10-3P. = 16 1- (3 * 10-*P, + 2 × 10-$P;) 8+ 18 + 10-P, 1- (3 * 10-*P2 + 2 * 10-5P,) = 16…

A:

Q: A certain 3-phase equilateral transmission line has a total corona loss of 53 kW at 106 kV and a…

A:

Q: b) Two transmission line circuits (circuit A and circuit B) that run parallel to each other is shown…

A: The circuit can be redrawn as GMR of circuit…

Q: How can we evaluate i123

A:

Q: (b) Determine the inductance per km/phase of a double circuit three-phase line as shown in the given…

A:

Q: VII. PROBLEMS : 1. The IR drop in the line due to the reactive current is one disadvantage of low…

A: In this question we will write why low power factor load is undesirable...

Q: Using the Gauss- Seidal Method to solve the simultaneous qequations X1 +X2 = 3 3x1 - 3x2 +X3 = -1 X1…

A:

Q: In a three-phase system the per-unit phase voltages are Van = 0.9220° , Vin 0.9Z – 100° , Von…

A:

Q: 5. A transmission line whose characteristic impedance is a pure resistance (a) Must be a lossless…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: phon with - length and is terminated in Br = Zo. At the sending is driven by a generator which has a…

A: Given data, Vg=10 Vf =1kHZZg=500 ohmZs=Z0=683-j138 ohmγ = 0.0074+j0.0356/ km

Q: Compute the voltage drop across the transmission line, ETL = E1 – E2, in both polar and cartesian…

A: A diagram of a two bas bur power system is shown in the question. We need to determine the voltage…

Q: 1. A single phase overhead transmission line deliw and reactance per conductor are 0-15 Q and 0-0

A: According to question:

Q: tourier Series

A:

Q: Three unequal single-phase loads are

A: Given-Voltage rating= 230 VoltsFirst load takes connected across 1 and 2= 106A with 0.78 pf…

Q: PROBLEMS : 1. The IR drop in the line due to the reactive current is one disadvantage of low power…

A: In this question we will write why low power factor loads are undesirable....

Q: For b) what is Vry, Vbr, Vyb? Why is Vyb phase -90 degrees and Vby phase 90 degrees?

A: In this question we will find line voltage phase angle with respect to phase voltage.....

Q: Find out the zero-phase sequence components of the following set of three unbalanced voltage…

A: In this question,  We need to choose the correct options What is the zero-phase sequence components…

Q: emf at rated load

A:

Q: Consider the network given in figure below where the numbers indicate admittances per unit. Find the…

A: To study the load flow analysis of the big network power system, Bus admittance matrix is used.…

Q: Calculate the following of the series and parallel AC network: Magnitude of the total impedance…

A:

Q: smaller lagging reactive power drawn by a circuit, consists of_________ power factor Smaller zero…

A: The value of the power factor depends on the value of the reactive power drawn by the circuit.

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.