53. A series resistance-capacitance (R-C) circuit is connected to 230-volt, 50 cycle AC source. The current through the resistor is 45.45 A and the power taken by the circuit is 5,000 watts. Compute the apparent power.

53. A series resistance-capacitance (R-C) circuit is connected to 230-volt, 50 cycle AC source. The current through the resistor is 45.45 A and the power taken by the circuit is 5,000 watts. Compute the apparent power.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Discuss thr impact of wind energy on power system

A: Types of Renewable energy Wind energy Solar energy Tidal energy Biomass energy ....etc…

Q: A single phase circuit with a given load 3 ohm resistance and inductive reactance of 4 ohms as…

A: The question is about active power, reactive power and apparent power, power factor.

Q: circuit breaker

A: Circuit Breaker A circuit breaker is basically an electrical switch that opens when there is an…

Q: A power transmission line of 11kV (maximum) carries a maximum current of 200A is connecting the two…

A: Given: A power transmission line of 11kV (maximum) carries a maximum current of 200A is connecting…

Q: (a) Explain the generation of single phase alternating voltage. Illustrate with a diagram.

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: (a) What is the resistance of a 220-V AC short circuit that generates a peak power of 96.8 kW? (b)…

Q: Find the average voltage from 45⁰ to 180⁰ @ Em = 100 Volts? b) what is the average current if this…

Q: A 230 V single phase energy meter has a constant load current of 4 A passing through if for 5 hours…

A: Given, A single phase energy meter has, Voltage rating, V = 230 V Constant load current, I = 4 A…

Q: **************************** SUBJECT = Electric Machines ****************************** Q A…

A: Solve as below

Q: An existing dc three wire system is to be converted into a 3phase 4 wire system by adding a fourth…

A: Same supply and load voltages, balanced condition and unity power factor 1) DC three wire system…

Q: A step down chopper has Vs = 230 V and R = 10 N. For a duty cycle of 0.4, the power taken by the…

A: A step down chopper has Input voltage, Vs = 230 V Resistor, R = 10 Ω Duty cycle, α = 0.4 The power…

Q: A single-phase 230V, 1kW heater is connected across I-phase 230V, 50Hz supply through an SCR. For…

Q: transformer as shown in the figure given below. transformer is connected to form an auto A…

Q: 50. A series resistance-capacitance (R-C) circuit is connected to 230-volt, 50 cycle AC source. The…

Q: For the mutual electric circuit shown in figure beside, find the set values of mesh currents 11 &…

A: a mesh is a loop that does not enclose other loops. KVL, states that “in any closed-loop network,…

Q: For the mutual electric circuit shown in figure beside, find the set values of mesh currents 1 & 12?…

A: KVL, states that “in any closed-loop network, the total voltage around the loop is equal to the sum…

Q: Suppose in a two-coil scenario, a positive increasing current driven in one coil results in a…

A: Note: Since you have posted multiple independent questions in the same request, we will solve the…

Q: An inductance of 0.106 Henry is connected to a 120-volt 60-cycle source. Calculate (a) the inductive…

A: As per our guidelines we are supposed to be answer only the first 3 questions. Kindly repost the…

Q: 1) Principle and features of different methods for measuring three-phase power. 2) Discuss the…

Q: (b) Based on part (a), illustrate the phasor diagram

Q: If it is connected in series with a pure resistance R with resistance R, inductance L, the current…

A: (a) Calculate the value of the resistance and the inductive reactance of the circuit. VR=IRR=VRI=30…

Q: Provide brief answer only. Define a fixed DC source alomg with it's symbol and applications.

A: According to the given question, it is required to determine the definition of a fixed DC source…

Q: Grounding methods in Power systems

Q: Transform 4A to independent voltage source and then determine the voltage drop at 2ohms

A: According to the question, we need to find the voltage drop across 2 Ω resistor by using current…

Q: A single-phase ac voltage source has 200 Vrms and a system connected consumes an active power of 300…

A: Given data, Active power P = 300 W RMS voltage V = 200 V RMS current I = 2.5 A

Q: c) Describe the following terms as they relate to utility providers; i) Peak Plant ii) Baseload…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: 3) A resistor, in series with a 138µf capacitor is connected to a 60cycle source. If the voltage…

Q: . What are the various causes of voltage drop in atransformer? B. A single phase transformer has…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: A 20-kVA, 507 V load is to be supplied by an ideal step-up autotransformer from a 400-V source. Find…

A: Neglecting the losses in transformer input power KVA = output KVA. VA=voltage×current.

Q: A single-phase energy meter having meter constant of 200 rev/kWh is operating on 230 V, 50 Hz supply…

A: Given: A single phase energy meter having, Meter constant, K=200 revkWh. Operating voltage, V=230 V.…

Q: An electromagnet consists of a coil with a laminated core assembly. This device takes 6 A when…

A: The electrolyte resistance, the current collector resistance, the active mass, and the transition…

Q: Discuss THREE (3) important roles of the instrument current transformer (CT) and voltage transformer…

A: The explanation is as follows.

Q: 1. list the different losses which take place in atransformer. 2. What are the various causes of…

A: Note: Since you have not specified any question to be answered, as per our honor code, we are…

Q: hort term and long term effects of wind energy on power system

A: SHORT TERM AND LONG TERM EFFECTS OF WIND ENERGY ON POWER SYSTEM: 1. The following factors are…

Q: A series resistance – capacitance (R – C) circuit is connected to 230 – volt, 50 cycle AC source.…

Q: Give your background about the AC systems from single phase and three phase systems to their…

A: AC system with single phase and three phase systems

Q: in Transitions Animations Slide Show Review View 1. A 3- phase, 30 MVA, 33 KV alternator has…

A: The solution can be achieved as follows.

Q: Find the no load line voltage of a star connected 4-pole alternator form the following: Flux per…

A: An alternator/Synchronous generator is a type of electrical machine that converts mechanical energy…

Q: Determine the apparent power, power factor & power factor angle when connected in a) series; b)…

Q: POWER MEASUREMENT OF DIRECT CURRENT (DC) AND ALTERNATING CURRENT (AC) SINGLE PHASE LOAD

A: Power is defined as the rate of doing work. Electric power is the electrical work done or electrical…

Q: a) Consider a three-phase power supply with associated electrical loads as shown in Figure Q4.…

A: Circuit diagram is given as,

Q: A series resistance – capacitance (R – C) circuit is connected to 230 – volt, 50 cycle AC source.…

A: As per the guidelines of Bartley we supposed to answer first three subpart only for solution of…

Q: 47. A series resistance-capacitance (R-C) circuit is connected to 230-volt, 50 cycle AC source. The…

Q: Explain the types of generators used in wind turbines with a neat diagram and also discuss the…

A: We have given the problem Explain the types of generators used in wind turbines with a neat diagram…

Q: An electrical heating element that has an AC resistance of 100 Ohms is connected across a 240V AC…

Q: In Transformers: a. What is the relationship between the turns ratio and the primary to secondary…

Q: A 20-kVA, 586 V load is to be supplied by an ideal step-up autotransformer from a 400-V source. Find…

Q: A power transmission line of 33kV (maximum) carries a maximum current of 1200A is connecting the two…

A: Given: A power transmission line of 33kV (maximum) carries a maximum current of 1200A is connecting…

Q: In the circuit in Figure 2, the capacitor and The circuit of resistance is defined as a load…

A: In the circuit the capacitor and resistance is load circuit. A) Find the average power dissipated by…

Q: QUESTION 55 "Since most loads are capacitive in nature (e.g. motors), improvement of power factor is…

A: In this question choose the correct option Check the given Statment is true or false?

Question

53. A series resistance-capacitance (R-C) circuit is connected to 230-volt, 50 cycle AC source. The current
through the resistor is 45.45 A and the power taken by the circuit is 5,000 watts. Compute the apparent
power.
a. 4,399.4874
b. 8,063.3393
c. 9,180.6139
d. 19,196.9845

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Alternating Current (AC) Series Motor and Universal Motor

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An RLC series circuit connected to a 110 – volt and 50 – cycle AC source, contains the following series resistances and reactances: R1 = 10 ohm, R2 = 15, R3 = 5 ohms, XL1 = 20 ohms, XL2 = 25 ohms, XC = 40 ohms. Find the following: a.) EQUIVALENT REACTANCE b.) TOTAL IMPEDANCE c.) VOLTAGE DROP ACROSS THE CAPACITOR d.) TOTAL INDUCTANCE IN MILLIHENRY e.) TOTAL CURRENT f.) REACTIVE POWER g.) REAL POWER DRAW THE PHASOR DIAGRAM IF POSSIBLE AND ROUND OFF TO FOUR DECIMAL PLACES
calculate phasor currents I1 and I2 in the circuit shown below
Find,a. Currents ?1 and ?3.b. Source voltage ??c. Power factor of the entire circuitd. Draw phasor diagram. Find magnitudes and positions of all the quantities. Please show complete solution and round off answers up to the 3rd decimal place. Thank you!
Determine the symmetrical components of the three currents ?? = 10 ∠ 0A; ?? =100 ∠ 2500 A; and ?? = 10 ∠ 1100 A.
A series resistance – capacitance (R – C) circuit is connected to 230 – volt, 50 cycle AC source. The current through the resistor is 45.45 A and the power taken by the circuit is 5,000 watts. Compute the following: a.) VOLTAGE DROP ACROSS THE RESISTOR b.) POWER FACTOR ANGLE c.) CIRCUIT IMPEDANCE d.) OHMIC VALUE OF THE RESISTOR e.) CAPACITIVE REACTANCE f.) CAPACITANCE IN MICROFARAD g.) APPARARENT POWER PLS SOLVE ALL ROUND OFF TO FOUR DECIMAL PLACES
A series resistance – capacitance (R – C) circuit is connected to 230 – volt, 50 cycle AC source. The current through the resistor is 45.45 A and the power taken by the circuit is 5,000 watts. Compute the following: a.) VOLTAGE DROP ACROSS THE RESISTOR b.) POWER FACTOR ANGLE c.) CIRCUIT IMPEDANCE d.) OHMIC VALUE OF THE RESISTOR e.) CAPACITIVE REACTANCE f.) CAPACITANCE IN MICROFARAD g.) APPARARENT POWER PLS SOLVE ALL ROUND OFF TO FOUR DECIMAL PLACES solvE LETTER D, E F, AND G PLSS PLSS KINDLY SOLVE FAST
TOPIC: Ohm's Law, Power and Generating Direct CurrentDirect Current Circuit AnalysisInductor, Capacitor, Generating Alternating Current Please Answer with complete solutions: V1 V2 V3
Use Kirchhoff's Voltage Law and Kirchhoff's Current Law to calculate the following data
25/. A three phase loads each resistance of 100 Ω and capacitance of 10 µF are given, with 415 V, 50 Hz supply. Find the total power for i) Star Connection ii) Delta Connection iii) Draw and Compare your result for both the cases
In general, a three-phase induction motor isdesigned for wye connection operation. However, forshort-time operation, a delta connection can be used atthe nominal wye voltage. Find the ratio between thepower delivered to the same motor in the wye anddelta connections.
In an apartment with three flats fed from a 400V 60 Hz three-phase network, a 250W device in apartment-1 and a 'kW device in apartment-2 were operating in a time interval as seen in the figure, while no power was consumed in apartment 3. A disconnection has occurred. In this case, approximately how many Volu is the voltage at the ends of the 250W device? a)214V b)230v C) 372V d)0(zero) e) 356V
The R, L and C circuit has resistance, R=10Ω, inductance, L= 107 milli-Henry and Capacitance, C=80 micro-farad. The supply voltage is 120 Volts-RMS with a frequency of 60 HZ. What is the power dissipated, across the resistor of the circuit in units of Watts?