53.2 mL of 0.795 M hydroiodic acid is added to 46.2 mL of barium hydroxide, and the resulting solution is found to be acidic. 28.5 mL of 0.695 M sodium hydroxide is required to reach neutrality. What is the molarity of the original barium hydroxide simulation? ___ M

Q: solution is made by diluting 200ml of a 3mol/L standard solution to a volume of 0.6L. What is the…

A: We have given that  A solution is made by diluting 200ml of a 3mol/L standard solution to a volume…

Q: A 0.3000 g sample of impure Na2CO3 requires 36.31 mL of a 0.1075 M HClO4 solution to reach the end…

A: Molarity of HClO4 = 0.1075 M  Volume of HClO4 = 36.31 mL = 0.03631 L Mass of sample = 0.3000 g  We…

Q: What is the concentration of hydrochloric acid? Find the concentration using the information given…

A: A question based on acid-base titrations that is to be accomplished.

Q: A student titrated 30.5 mL of a 3.50 grams per liter monoprotic acid with 15.0 mL of 0.10 M NaOH…

A: From the details in the question, it can be inferred that the reaction molar ratio is 1:1. Since it…

Q: b.) The same technician was later tasked with diluting a drug for this patient. The concentrated…

A:

Q: Concentrated HCl is 12.1 M.  Determine the volume in mL of the concentrated solution required to…

A:

Q: Calculate the final concentration of each of the following: A 41.0  - mL sample of a 15 %…

A:

Q: A 25.0 mL sample of aqueous sodium hydroxide has been used to titrate to the second equivalence…

A: Molarity is equal to the number of moles of solute that can be dissolved in per liter of solution.…

Q: What is the theoretical concentration of a standard solution prepared by 2.50 g of NaOH (MW=40.00…

A:

Q: Preparation of 50.0 mL 3.0 M hydrochloric acid solution by dilution 1. Calculate the volume of…

A: The detailed solution of your question given below-- Since, we know that the formula, Molality =…

Q: A student prepares a stock solution 100 mL of 0.50 M copper (II) sulfate solution, which is blue in…

A: Molarity is the unit of concentration of a solution, and its unit is mol/L It is defined by the…

Q: Titration reveals that 13.44 mL of 2.0 M sulfuric acid are required to neutralize the potassium…

A: Given: Molarity of Sulfuric acid=2.0 mol/L The volume of Sulfuric acid=13.44 mL The volume of…

Q: alculate the solubility of Mg(OH)2 in 0.10 M  Mg(NO3)2. Calculate the solubility in grams/liter (use…

A: Since you have posted multiple questions as per the guidelines we can solve only one . If you want…

Q: please highlight the correct answer

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: pertuint UI (TI/III) CONCentration. Step 5. Put exactly 1 cup (or 237 mL) of distilled water into…

A: In the given question we have to calculate the mass percent of Solution. given data: 1 cup of…

Q: 4.91 mL of NaOH solution was required to reach the endpoint when titrated against 0.1005 g of…

A: Here 4.91 ml of NaOH solution was required to react with 0.1005 g of KHP dissolved in 50ml water.We…

Q: A student combined 37.2 mL of 1.69 M KMnO₄ solution with 17.40 mL of a 0.891 M KMnO₄ solution.…

A: Molarity (M) : number of moles of solute (n) present in 1 L of solution is called molarity…

Q: How would you prepare 1000. mL of a 6.00 M HNO3 solution if only 3.00 M and 12.0 M solutions of the…

A:

Q: 14. A 0.300 M solution of HCl is prepared by adding some 1.50 M HCl to a 500 mL volumetric flask and…

A: Molarity(M) is the moles of solute per unit volume of the solution in litres. It's unit is mol/L…

Q: A sample of 7.0 mL of concentrated sulfuric acid, H2SO4 is used to make 250. mL of a 0.50 M sulfuric…

A: Given :- initial volume of solution = 7.0 mL  Final concentration of solution = 0.50 M Final volume…

Q: Suppose a student titrated a sample of monoprotic acid of unknown concentration using a previously…

A: Given, Volume of NaOH (VNaOH) = 24.68mlSts Concentration (MNaOH) = 0.125MVolume of acid…

Q: A student prepares a stock solution 100 mL of 0.50 M copper (II) sulfate solution, which is blue in…

A: M1=0.50M M2=0.20M V2=60ml

Q: Consider a 100 mL of 0.25 M solution of NaCl, what is the final concentration of that solution if…

A: Dilution of the solution: On dilution of the solution with the pure water, the mole of solute…

Q: A 30.00 ml sample of carbonic acid is titrated to the endpoint with a 0.1000 M potassium hydroxide…

A: Given data,Volume of carbonic acid=30.0mL=0.030LMolarity of KOH=0.100MInitial reading=13.04mLFinal…

Q: Determine the volume of 0.205 MM KOHKOH solution required to neutralize each sample of sulfuric…

A: The neutralization reaction takes place as,                             H2SO4 (aq) +2 KOH (aq)   →…

Q: San Pellegrino mineral water is 208 mg of calcium per liter according to the FDA. A. What is the…

A: The presence of calcium and magnesium in water results in the hardness of water. The concentration…

Q: Consider a titration where 0.215 M potassium hydroxide is added from a burette to 10.00 mL of…

A: The titration between a strong base, KOH, and a strong acid, HCl results in the formation of a…

Q: During your standardization experiment, you measured 0.0521 grams of potassium hydrogen phthalate…

A: Molarity is defined as no.of moles of solute divided by volume of solution in liter.

Q: A 0.128 g sample of KHP (HKC8H4O4) required 28.54 mL of NaOH solution to reach a phenolphthalein…

A:

Q: The student weighs out 0.18 g of a diprotic unknown acid and dissolves it in approximately 50 mL of…

A: Since the acid is diprotic  hence moles of NaOH required to reach end point = moles of acid X 2…

Q: You perform a titration between Sodium hydroxide (NaOH) and Carbonic Acid (H₂CO3). The NaOH is in…

A: Sodium hydroxide reacts with carbonic acid, to form sodium carbonate and water. The equation for the…

Q: 25.00 cm3 of 0.100 mol/dm3 sodium hydroxide solution is exactly neutralized by 0.125 mol/dm3…

A: The volume of hydrochloric acid needed in ml has to be calculated,

Q: 1. The time it takes for the crushed antacid/chalk to be dissolved in vinegar is greater than the…

A: We are authorised to solve one question at a time. Please  post rest of the questions separately.

Q: Sample 1 A student states “A solution of 4 M sulfuric acid (H2SO4) is a stronger acid than a 1 M…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 1. Fill a burette with the potassium permanganate solution of unknown concentration. 2. Into a…

A: In titration the volume of solution added from burette is calculated from the change of final…

Q: A solution of HCl was titrated against sodium carbonate. What is the average normality of acid in…

A: The balanced chemical equation for the reaction of HCl(aq) and Na2CO3(aq) is: 2HCl(aq) + Na2CO3(aq)…

Q: Determine the final concentration of each of the following solutions after 20mL of water has been…

A: " Since you have posted a question with multiple sub-parts , we will solve first three sub-parts for…

Q: If 21 mL of 3.2 x 10–5 M magnesium chloride and 15 mL of 1.5 x 10–4 M sodium fluoride are mixed,…

A: Volume of Magnesium Chloride solution = V1 = 21 mL = 0.021 LVolume of odium Flouride solution = V2 =…

Q: t is the normality of 50.0 ml Ba(OH)2 solution when titrated with 23.50 mL of 0.250 N HCl? MM BaOH2…

A: Given-> Volume of Ba(OH)2 = 50.0 ml Volume of HCl = 23.50 ml Normality of HCl = 0.250 N

Q: A chemist needs to determine the concentration of a sulfuric acid solution by titration with a…

A: Given, Molarity of standard sodium hydroxide (MNaOH) = 0.1834M. Volume of NaOH = 13.96mL. Volume of…

Q: How many grams of pure sodium carbonate are needed to standardize a 0.20N HCl when you expect the…

A: Given,  Options are :

Q: Calculate the concentrations of the NaOH and crystal violet solutions if the stockroom uses 0.7925 g…

A: Given, Molarity of NaOH = 0.01981398604M Diluted NaOH is 10mL of 0.010M

Q: Calculate equivalent weight of unknown acid using the following information: Mass of unknown acid=…

A:

Q: Calculate the initial concentration of Fe3+, based on the dilution that results from adding KSCN…

A: Solution Trial 1 : [FeSCN]2+eq = 0.216 x 0.0002/1.102 = 3.92 x 10^-5 M Trial 2 : [FeSCN]2+eq = 0.327…

Q: determine the mass of CuS formed when 100.mL of 0.100M H2S and 50.0ml of 0.150M Cu(C2H3O2)2 are…

A:

Q: 17. What volume of a 0.1000 M hydroiodic acid solution is needed to neutralize 25.0 mL of a 0.350 M…

A: Acid react with base to formed salt and water. Thus,

Q: Concentration Units. Follow the format. Given: Formula: Calculations and answer: 9. How much 0.075 M…

A: Dilution of the solution: When we dilute a concentrated solution with pure water, the mole of solute…

Q: 26.85 mL of a 1.0 M NaOH solution is used to titrate 22.5 mL of an acid solution, what is Ma?

A: Given , Molarity of NaOH = 1 M Volume of NaOH = 26.85 ml Volume of Acid = 22.5 ml

Q: A student is asked to standardize a solution of calcium hydroxide. He weighs out 0.945 g potassium…

A:

Q: How many milliliters of 0.300 M Li,S are needed to react with 25.00 mL of 0.315 M AgNO3? LizS(aq) +…

A: Given, Li2S concentration =0.3 M  Volume of AgNO3 = 25 ml = 0.025 L and concentration of AgNO3 =…

Q: A 30.00 ml sample of sulfuric acid is titrated to the endpoint with a 0.1000 M potassium hydroxide…

A: Answer:- This question is answered by using the simple concept of calculation of molarity using the…

Q: Standardization of NaOH solution 1.trial 2.trial 15.0 mL of 0.1015 M HC1 + 15.3 mL NaOH 15.0 mL of…

A: At the equivalence point of the reaction, the moles of HCl and the moles of NaOH are equal. moles of…