6- For the same maximum pressure and temperature, what is the relation among the efficiencies of the Otto cycle, the Diesel cycle and the Dual cycle? a) NDual >NDiesel >Motto b) NDiesel >NDual >Motto c) NDiesel >Notto >NDual d) Notto >NDiesel >NDual 7- Which of the following cycle is less efficient as compared to the remaining? a) Carnot cycle b) Stirling cycle c) Ericsson cycle d) Otto cycle e) All have identical efficiency 8- Which of the following cycle consists of othermal and two constant volume processes? a) Stirling cycle b) Joule cycle c) Diesel cycle d) Rankine cycle e) Otto cycle sMahmouoA Mashkour

6- For the same maximum pressure and temperature, what is the relation among the efficiencies of the Otto cycle, the Diesel cycle and the Dual cycle? a) NDual >NDiesel >Motto b) NDiesel >NDual >Motto c) NDiesel >Notto >NDual d) Notto >NDiesel >NDual 7- Which of the following cycle is less efficient as compared to the remaining? a) Carnot cycle b) Stirling cycle c) Ericsson cycle d) Otto cycle e) All have identical efficiency 8- Which of the following cycle consists of othermal and two constant volume processes? a) Stirling cycle b) Joule cycle c) Diesel cycle d) Rankine cycle e) Otto cycle sMahmouoA Mashkour

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The properties of this Organic Rankine Cycle are as follows: • Turbine feed: P = 24.49 bar, T = 272.19C• Turbine exhaust: P = 2 bar, T = 203C. Assume ideal gas at P = 2 bar. • The pump efficiency is 65%.• Benzene is used as the working fluid Calculate the turbine shaft work Ws,turbine (in J/mol).
diesel cycle or Otto cycle ??
Write legibly, provide manual step by step solution, and diagram for below given problem. A superheat steam Rankine cycle has turbine inlet conditions of 17.5 Mpa and 530 C expands in a turbine to 0.007Mpa. The turbine and pumps polytropic efficiencies are 0.9 and 0.7 respectively, pressure losses between pump and turbine are 1.5MPa. What should be the pump work in KJ/kg? A. 17.3 C. 37.3 B. 27.3 D. 43.4
Provide complete solution and diagram for this problem. In a Brayton cycle, the compression ratio of compressor is 8. Find the cycle efficiency of thecycle. A. 56.47% B. 50.34% C. 45.34% D. 65.34% Answer: A
How does "power producing cycle" be applied in agriculture and machinery?
Solve for the efficiency of Process 1-2-6-5 (Simple Rankine Cycle) (orange circle) *Not the reheat rankine cycle Efficiency for Simple Rankine Cycle = 35 % (probable answer)
Combined Rankine Cycle Show the details of your solutions with Schematic and TS diagrams Performance between: Condition 1 Required PH = 17 MPa, 10000C Thermal Efficiency ? PR = 8 MPa, 8000C PReg = 4 MPa PL = 0.008 MPa Condition 2 Required PH = 17 MPa, 10000C Thermal Efficiency ? PReg = 8 MPa PR = 4 MPa, 8000C PL = 0.008 MPa
6- Why thermal efficiency of diesel engine is more than petrol engine? 7- Discuss results?
p103#4. two and one-half pounds of air actuate a cycle compes of the following processess: polytropic compression 1-2, with n=15; constant pressure 2-1; constant volume 3-1. the known data are p1=20psia, t1=100degree F, QR= -1682 Btu. determine (a) T2 and T3, (b) the work of the cycle using the pV plane,in Btu; (c) QA, (d) the thermal efficiency and (e) pm
Provide a complete and logical solution for the problem. If linear interpolation is required in the problem, tabulated values is considered as a solution. Also, provide T-S or P-V diagrams for each problem. For a Rankine Cycle, steam at 5.25 MPa, 435°C expands to 0.036 MPa. For 10 kg/s of steam, determine: a. Heat added b. Heat rejected c. Work of turbine d. Thermal Efficiency
1- Why is the back work rate high from gas-fluid power cycles? The relevant figure or figures will be explained by drawing.
Rannkin cycle 1_The value of enthalpy at point 1 is ( h1 =?) 2_ value of enthalpy at point 2 is ( h2 =?) 3_ value of enthalpy at point 3 is ( h3 =?) 4_value of enthalpy at point 4 is ( h4 =? 5_ value of steam mass flow rate in kg/s is 6_rate of heat supplied7_ power developed by Turbine (WT) in kW is : 8_ Thermal efficiency of Rankine cycle is: