6. A cylindrical water tank 12 feet high with a radius of 8 feet is buried so that the top of the tank is 3 feet below ground level. How much work is done in pumping a full tank of water up to ground level? The weight of water is 62.4 pounds per cubic foot.

Q: 9. (A.) Find the approximately height of water upstream of the dam or the headwater in meters, such…

A:

Q: An open cylindrical vessel with a diameter of 1m contains water at a depth of 3.56m. If the vessel…

A:

Q: A square tank of water (18 inx18 in) is drained from 15 inches to 14 inches with an orifice size of…

A:

Q: An open vessel contains water up to a depth of 5.29 m and above it an oil of SG = 0.8 %3D for a…

A:

Q: A horizontal cylindrical tank 4ft in the diameter and 10ft long is full of water. Find the work done…

A: Draw a diagram for the problem. Here, G is the center of gravity of the cylindrical tank filled…

Q: An open storage vessel has 3 m of oil (SG = 0.82) and 6 m of water. Find the pressure at the bottom…

A: Given data: ho=3 mSG=0.82hw=6 m Need to determine the pressure at the bottom of the tank.

Q: A large tank of water, open at the top, has a small bole through its side a dis- tance t below the…

A:

Q: A pond with water, whose width is b, is divided by a partition. On one side of the partition the…

A: For the given system  To determine  Force acting on the septum

Q: 2. A vertical cylindrical tank is filled to the top with water at a temperature of 20°C. The…

A:

Q: Find the work required to pump the water out of a tank shaped like an upside down pyramid with…

A:

Q: A cylindrical water tank 4 meters high with a radius of 2 meters is buried so that the top of the…

A: Consider a layer of water with thickness ∆y at a distance y metres from orifgin.r=2…

Q: Compute the depth of the ocean if the pressure at seabed is 531.5 in Hg. The average specific…

A: Given data,   Pressure at sea bed = 531.5 Hg   Specific gravity of sea water =1.12To compute :…

Q: Find the volume of water in a swimming pool with vertical ends and sides. The length measured at the…

A: Given data: Volume of water in a swimming pool with vertical sides Length, h = 50 ft Breadth, H = 20…

Q: 4. An oil tank is an upright cylinder, buried so that its circular top is 10 feet beneath ground…

A:

Q: A conical vessel is 12 ft across the top and 15 ft tall. If it contains a liquid weighing W lb/ft3…

A: The schematic diagram of the conical vessel with a ring element is as follows:

Q: A rectangluar swimming pool 25 feet long, 15 feet wide, and 7 feet deep is filled with water to a…

A:

Q: 4. An upright tank, full of water, has a height of 2m and a triangular base (cross section). If the…

A:

Q: vertical cylindrical tank (1m in diameter and 4m Height) open at the top end is full of water. If…

A:

Q: find the specific gravity of the denser fluid

A: For solution refer below images.

Q: 4. A conical vessel with sides inclined 30" with its vertical axis is revolved about another axis 1…

A: Here, given the detils of radius of rotation= 1 m inclination of sides from the vetical axis= 30…

Q: A frustum of a right conical vessel stands vertically on its vertex. It has an altitude of 1.0 m.…

A: Given: dbottom=0.5 mdtop=0.8 mh=1mN=90 rpmTo find:volume of water remained after rotation=?

Q: Convert 15.0 L in cm^3.

A: Given 15 L of fluid To find Conversion to cm3

Q: A double purpose tank 18 ft wide, 24 ft long and 4 ft depth is filled with water. What is the weight…

A: Write the given data with suitable variables.

Q: A tank is filled with water at a rate of 9 gal/min as shown in the figure below. Given that D = 3 ft…

A: Given A tank is filled with water at a rate of 9 gal/min as shown in the figure below. Given that D…

Q: A cylindrical tank 2m diameter, 3m high is full of oil. If the specific gravity of oil is 0.9, what…

A:

Q: An open tank of water accelerates down at 15° inclined plane at 16 ft sec2 ⁄ . What is the slope of…

A:

Q: A cylindrical tank is filled with water at the rate of 5,000 gal/min. The height of water in the…

A:

Q: A 4-inch diameter cylinder moves a 25000 Ib load 24 inches in two seconds. Determine: a. The…

A: Given data,D=4instroke length L=24 inLoad =25000lbtime t =2s

Q: a conical water tank has its top at ground level(considerr this to be the x-axis) and its base 12 ft…

A:

Q: A tank initially holding 90 gal of fluid with 30 lb of salt has two sources of fluid being pumped…

A: Let V be the volume of the tank. Write the expression for change in volume of the tank.…

Q: A city requires a flow of 25 million gallons per day for its water supply. If the required velocity…

A: Given data: Discharge required, Q=25 million Gallons/day=25×10624×60 Gallons/min…

Q: An open vessel contains water up to a depth of 5.34 m and above it an oil of SG = 0.8 for a depth of…

A:

Q: elow the water surface should a vertical square 1.22m on a side with two sides horizontal,be…

A: To determine how far below the water surface should a vertical square 1.22m on a side with two sides…

Q: Given a system between two tanks. as shown in the following figure. Calculate the water level…

A: Pressure in lower tank, Pe=0.5 atPressure in upper tank, PVAC=7.35 psiLength of the pipeline, l=15…

Q: How much work is required to empty the full tank shown below by pumping water up and over the top…

A: Given: The density of water, ρ = 62.4 lb/ft^3

Q: A circular section of lawn on a golf course needs to be watered with 2 inches of water per week. If…

A: The diameter of the circular section is 100 feet. The circular section needs to be watered with 2…

Q: 12. A spherical tank is full of water that has a total mass of 10,000 kg. If the outside diameter of…

A:

Q: 11. Suppose that a gasoline tank is an upright cylinder with a radius of m and a depth of 4m is…

A: Density of a fluid is defined as the mass of the fluid per unit volume. Weight is mass times the…

Q: poiler capacity is 100 kW, then the suitable expansion tank volume is:

A: According to Boiler design capacity,  Volume of expansion tank = 4 to 7 litres per kW capacity of…

Q: dinder with draft 2 m and radius 1 m, as below.

A:

Q: A conical vessel 12m across the top and 15m deep. If it contains water to a depth of 10m, find the…

A: Given data as per the question Total depth of cone =15 m  water depth in cone = 10 m

Q: 4. Situation 2 - A cylindrical tank contains water to a depth of 0.90 m. What is the resulting…

A: To find : The resulting pressure in kPa at the bottom of the tank . Given: The depth of water is…

Q: A conical tank having a radius of the base equal to 0.39 m and a height of 0.75 m. The cone is laid…

A:

Q: 3. How much work would it take to pump oil of weight density 35 lb/ft3 out of a spherical tank of…

A:

Q: 12. Surface tension is caused by the force of . a the free surface. ....

A: Cohesion

Q: An open vessel contains water up to a depth of 4.83 m and above it an oil of SG=0.8 for a depth of…

A:

Q: A very large cyndrical shaped tank has a radius of 4 feet and a height of 15 feet. The tank is…

A: Given               radius = 4 feet               height = 15 feet weight density = 48 pounds per…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.