6. Some measurements require a different type of measuring device. Use the micrometer to measure thediameter of the wire (and a ruler to measure the length).What kind of geometric "figure" is the wire? CylinderDiameter 1 = 0.80cmLength 1 = 11.0cm%3D%3DDiameter 2 = 0.079cmLength 2 = 11.1cm%3DDiameter 3 = 0.078cmLength 3 = 10.9cmAverageLengthAverage DiametercmcmTo how many decimal places (in cm) can you accurately read the micrometer?AreaVolumem3Area Calculation (include formula and units)Volume Calculation (include formula and units)

Given : Diameter reading of wire using micrometer D1 = 0.80 cm D2 = 0.79 cm D3 = 0.78 cm Length of…

6. Some measurements require a different type of measuring device. Use the micrometer to measure the diameter of the wire (and a ruler to measure the length). What kind of geometric "figure" is the wire? Cylinder Diameter 1 = 0.80cm Length 1 = 11.0cm Diameter 2 = 0.079cm Length 2 11.1cm Diameter 3 = 0.078cm Length 3 = 10.9cm Average Length Average Diameter cm www cm To how many decimal places (in cm) can you accurately read the micrometer? Area = m2 Volume = Area Calculation (include formula and units) Volume Calculation (include formula and units)

6. Some measurements require a different type of measuring device. Use the micrometer to measure the diameter of the wire (and a ruler to measure the length). What kind of geometric "figure" is the wire? Cylinder Diameter 1 = 0.80cm Length 1 = 11.0cm Diameter 2 = 0.079cm Length 2 11.1cm Diameter 3 = 0.078cm Length 3 = 10.9cm Average Length Average Diameter cm www cm To how many decimal places (in cm) can you accurately read the micrometer? Area = m2 Volume = Area Calculation (include formula and units) Volume Calculation (include formula and units)

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter1: Physics And Measurement

Section: Chapter Questions

Problem 1.53P: A sidewalk is to be constructed around a swimming pool that measures (10.0 0.1) m by (17.0 0.1) m....

See similar textbooks

Similar questions

A high fountain of water is located at the center of a circular pool as shown in Figure P1.47. Not wishing to get his feet wet, a student walks around the pool and measures its circumference to be 15.0 m. Next, the student stands at the edge of the pool and uses a protractor to gauge the angle of elevation at the bottom of the fountain to be 55.0. How high is the fountain? Figure P1.47
A house is advertised as having 1 420 square feet under its roof. What is area in square meters? (a) 4 660 m2(b) 132 m2 (c) 158m2 (d) 132 m2 (e) 10.2m1
1. What are the values of Ax and Ay in meters? 2.What are the values of Bx and By in meters? 3.What are the values of Dx and Dy in meters?
1. If a flower is 6.5 cm wide, its width expressed in millimeters is x mm, where x is A. greater than 6.5 B. less than 6.5 C. none of the above D. equal to 6.5 E. 100
I make a scale model of a tower using a scale of 1:300. If the real toweris 120 metres tall, how tall is my scale model in cm? Explain
How many millimeters make ten kilometers? A) 1010 B) 109 C) 108 D) 107
Which of the equations below are dimensionally correct? A) V2xf - V2 xi = 2ax + Δt B) Y= Y1+Vy1t- 1/2 gt2
Choose the letter of the correct answer. 1) The length of a table is 120.5 cm. Which of the following sets of measurement represents the value with good accuracy? a)118.6 cm, 117.6 cm, 119.6 cm, 117.2 cm b)118.8 cm, 119.0 cm, 119.2 cm, 118.8 cm c)119.3 cm, 119.2 cm, 118.6 cm, 118.7 cm d)120.2 cm, 120.5 cm, 120.3 cm, 120.1 cm 2) Aria and Jessi determined the mass of an object on two different balances. The accepted mass of the object was 2.355 g. Vivz obtained the following values: 2.531 g, 2.537 g, 2.535 g, and 2.533 g. Kenny obtained the values of 2.350 g, 2.404 g, 2.296 g, and 2.370 g. Which statement best describes the results that were obtained by Vivz and Kenny? a) Aria obtained the better precision. b) Aria obtained the better accuracy. c) Jessi obtained the better accuracy. d) Jessi obtained the better precision.
These are the options: (45x103/602) nm/sec2 (45x103) nm/sec2 (45x105/602) nm/sec2 (45x103/60) nm/sec2
11. Which of the following is the correct conversion of 300Mm/s in SI? Group of answer choices No answer 300x106 km/s 300x106 m/s 3.00x108 m/s 3.00x108 km/s
Four students use different instruments to measure the length of the same pen. Which measurement implies the greatest precision? (a) 160.0mm. (b) 16.0cm. (c) 0.160m. (d) 0.00016km. (e) Need more information
1. Find the percent uncertainty of 300±5 cm. How will you write the value of the measurement? 2. How do you write the following numbers in scientific notation or power of ten notation? a. 0.000123 b. 3,141,600,000 c. 1,005,000 d. 0.000000007 e. 100,000,000 3. Determine the number of significant figures in the following measurements. a. 0.00624 b. 300.1 c. 62,000.00 d. 1.0100 e. 10.01 4. Convert the following measurements to the mks(m-kg-s) system of units. a. 20 g/cm3 b. 100 km/hr c. 980 cm/s2 d. 0.5 kg/cm 5. Using dimensional analysis, check which of the following equations is or are correct. a. d = (1/2)at b. mgh = (1/2)mv2 c. a = v2/t