6. When a 240 V, 50 Hz supply is applied to a combination of a resistor of 15 Q in parallel with an inductor, the total current is 22.1 A. What value must the frequency have for the total current to be 34 A?

6. When a 240 V, 50 Hz supply is applied to a combination of a resistor of 15 Q in parallel with an inductor, the total current is 22.1 A. What value must the frequency have for the total current to be 34 A?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 5PP: Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 -...

See similar textbooks

Related questions

Q: Full adder circuit using Design a and external gates. a decoder

A: In this questions, we need to design full adder using decoder.

Q: Example: Convolution in the Laplace Domain Find y(t) given: h(t), f(t) vs time h(t)=e, t20 h(t) 0,…

Q: Q14/ 10 messages signals, each bandlimited to 5KHz are multiplexed using frequency division…

Q: Consider an IP datagram with the following characteristics: Length of IP header: 20 bytes Total…

A: (a) We can get the fragment payload size by subtracting the header, the dividing by 8, then…

Q: AJ-K flip-flop with J = 1 and K = 1 has a 20 kHz clock input. The Q output is Constantly HIGH…

A: We need to select correct option for j k flip flop output

Q: Q1/ For the circuit of Fig. (1) a. Determine V2 using Kirchhoff's voltage law. b. Determine I. c.…

Q: The value of the Vgs that causes the drain current to reach its maximum value; a. 0 b. Vp c. Vd max…

A: In JFET, The maximum drain current IDSS occurs when gate-to-source voltage VGS = 0 V and…

Q: The block diagram representation of a hydraulic system which provides the power for a numerically…

Q: Full adder circuit using Design a and external gates. a decoder

Q: Source 1 -jxc VLOAD R ww ZLOAD Figure 1 j XL 0000 Source 2

Q: Consider the circuit shown below. 1) Determine the coupling coefficient 2) Calculate the energy…

Q: Choose the correct answer 1- The resistivity of the conductor depends on (a) area of the conductor…

Q: For the parallel resonant circuit with resonance frequency fo-2 M Hz, the bandwidth i B-1.25 M rad/s…

Q: The transmission line act as inductor when it terminated by short circuit O open circuit O matched…

A: Transmission line parameters Transmission line :- a system which is used to tranfer energy from…

Q: 8. How FM wave can be converted into PM wave?

Q: Q4/ for the following circuit find total current, lp, le, VA VB and V? IR ww B Ic R40.512 ET R240…

Q: If a 10-bit ring counter has an initial state 1101000000, what is the state after the second clock…

A: We need to select correct option for given counter

Q: c) Draw the block diagram of delta modulation with a brief explanation of this modulation techniques

A: Delta modulation is a Differential Pulse Code modulation (DPCM) technique in which the difference…

Q: For all problems, solve for the following a. Vgs b. ld c. Zin d. Zout e. Av 20 V 6.2 ΚΩ HH V₁0 1 ΜΩ…

A: For the above given depletion n type MOSFET we need to calculate DC as well as AC parameters.

Q: 7.2 A 30 HP AC motor operates at full load, and draws 25 kW. What is the efficiency of that motor?

A: Given here A 30 HP ac motor operates at full load , draws 25kW here we have to find the efficiency…

Q: 10-A heater is rated as 230 V, 10 KW, A.C. What is the value 230 V referring to? 11- Sine wave…

Q: 0: ohm per phase. Calculate the synchronizing power per mechanical degree displacement

A: A synchronous generator converts mechanical energy in to electrical energy. The effectiveness of…

Q: Digital mammography uses much lower X-ray energies than standard X-ray scans, and is used to obtain…

A: State True or False.. Digital mammography uses much lower X-ray energies then standard X -rays…

Q: Calculate the current " I " to give air-gap flux of 20 mwb

Q: State the equations of the following voltages (V₁ & V₂) shown in fig. (1) in time domain and in…

Q: Q.5: Correct any five sentences using suitable scientific phrases. 1 UNGE IN TE 2. 3. The…

A: Three-phase power can be measured by One wattmeter method two wattmeter method Three wattmeter…

Q: Calculate the current " I " to give air-gap flux of 20 mwb

Q: Matlab

Q: The synchronous generator will have its voltage and frequency depend on O Field current and speed. O…

Q: The DEIMOS camera attached to the KECK telescope uses an array of 16 CCDs. Each CCD is an array of…

A: The size of the pixel array is 2048 x 4096 pixels. The number of transfers from the first pixel of…

Q: * If X= (1100101)excess-3 X=(101)octal O X=(65)decimal O X=(110000)gray O X=(1000001)binay O none of…

A: The coding techniques in the digital systems are listed as follows to represent a decimal number:…

Q: The group of bits 10110111 is serially shifted right (right-most bit first) into an 8-bit parallel…

Q: Use rules of block diagram reduction to determine the closed loop transfer function:(see the…

A: By using Rule of block diagram reduction determine the closed loop transfer function: Options are:…

Q: Activity 3: A fluid system has two sensors, a pressure sensor and a flow sensor. The pressure sensor…

A: As per the honor code I will do only first three parts . Kindly repost the other questions again.…

Q: a) For the Circuit shown calculate the value of C if the resonant frequency is 5000 vad /sec 5 0-6…

A: a) To find the value of C if the resonant frequency is w = 5000 rad /sec

Q: Q2/A-list the characteristics of PIC 17 series B- Explain with drawing the basic blocks in PIC16F48

A: (A) PIC 17 a memory mapped accumulator. read access to code memory (table reads) direct register…

Q: A lossless transmission line has a characteristic impedance of Zo= 50 , a load impedance of ZR =…

A: In the above given question we need to calculate the value of reflection coefficient and input…

Q: QUESTION 5 An electron and a mystery charge 5.3 x 10^-11 m apart attracts each other with a force of…

A: Given: Electron charge, q1=1.6×10-19 C Unknown charge, q2=? Force between charges, F=2.61×1012 N…

Q: If i(t) = 5u(t-3), this signal in frequency (s) domain is the following: a. I(s) = 5e-3s/S b. None…

A: Given data, Signal in time domain it=5ut-3

Q: Suppose the discrete time signal x(n) = [233] To shift the sequence x [n] to the right by one sample…

A: Answer: false Because of following explanation.

Q: 2. Mention the advantages of indirect method of FM generation?

A: 2) There are various advantages of using indirect method to generate FM signal.

Q: J.W. 1 If a microprocessor can perform structions per second, how many ro equired to excute an…

Q: 5. The ODE d²y dy dx² dx + - 2y = 0 has a general solution y(x) = C₁еx + С₂e−2x Determine the…

Q: Calculate: a) Current in Rx that is Ix. [Ans: I MA) | b) Power dissipated. by. Rx. and R.. [Anss…

Q: We need a three-stage time-space-time switch with N = 100. We use 10 TSIs at the first and third…

A: Given a three-stage time-space-time switch with, N =100 No of TSIs at the first stage= 10 No of TSIs…

Q: Q-1. A 3 phase, 0.8 MVA, 3.3 kV, star - connected synchronous generator has 5 2/phase synchronous…

Q: Consider the circuit shown below. 1) Determine the coupling coefficient 2) Calculate the energy…

Q: connection of C1=0.2F, C2=0.3F and L=0.10H. It is connected to a supply voltage (Vi). Find the…

Q: I If a microprocessor can perform 4 million. instructions per second, how many nanoseconds are…

Q: When two identical parallel wires are 3 m apart, the inductance per unit length is 2.5 μH/m.…

Concept explainers

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.

Question

Answer this question. TY

6. When a 240 V, 50 Hz supply is applied to a combination of a resistor of
15 Q in parallel with an inductor, the total current is 22.1 A. What value
must the frequency have for the total current to be 34 A?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?
The circuit is connected to a 60-Hz line. The apparent power in the circuit is 29.985 VA, and the power factor is 62.5%. The resistor has a voltage drop of 14.993 V, the inductor has an inductive reactance of 60 , and the capacitor has a capacitive reactance of 45 . ETITZVA29.985PF62.5%ER14.993VIRRPELILXL60VARsLLECICXC45VARsCC
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
A pure capacitive circuit is connected to a 480-volt, 60-Hz power source. An ammeter indicates a current flow of 24 amperes. The circuit current must be reduced to 16 amperes by connecting a second capacitor in series with the first. What is the value of the existing capacitor? What value capacitor should be connected in series with the original capacitor to limit the circuit current to 16 amperes?
If a capacitor produces 15 ampere on a 240-volt supply, which of the following is its microfarad rating? 166 microfarad 15 microfarad 200 microfarad 3450 microfarad
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
A circuit contains series combination of a resistance of value 10 ohm, an inductance of value 40 mH and a capacitance of value 20 microfara. What will be the value of the impedance of of the circuit at a frequency of 100 kHz?