0:7B/s ilIli.13 Jlguoغير مجاب عليه بعدالدرجة من 6.25علم هذا السؤالA square loop (L = 0.20 m) consists of50 closely wrapped turns, eachcarrying a current of 0.50 A. The loopis oriented as shown in a uniformmagnetic field of 3.3 T directed in thepositive y-direction. What is themagnitude of the torque on the loop (?in units of N.m)BLy60اخترأحد الخياراتА. 3.85 ОB. 1.65 OC. 1.01 CD. 2.86E. 2.34 OO

Given-Number of turns N=50Length L=0.20 mArea of square loop A=L2=0.202=0.04 m2Magnetic field B=3.3…

Answered: 6.25 a iz علم هذا السؤال loor 020 m) go…

Science

Physics

6.25 a iz علم هذا السؤال loor 020 m) go neiste

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter30: Magnetic Fields And Forces

Section: Chapter Questions

Problem 82PQ

See similar textbooks

Similar questions

Is Ampere’s law valid for all closed paths? Why isn’t it normally useful for calculating a magnetic field?
, (a) At what angle 0 is tlie torque on a current loop 90.0% of maximum? (b) 50.0% of maximum? (c) 10.0% of maximum?
In Figure P20.65 the rolling axle of length 1.50 m is pushed along horizontal rails at a constant speed v = 3.00 m/s. A resist or R = 0.400 is connected to the rails at points a and b, directly opposite each other. (The wheels make good electrical contact with the rails, so the axle, rails, and R form a closed-loop circuit. The only significant resistance in the circuit is R.) A uniform magnetic field B = 0.800 T is directed vertically downward. (a) Find the induced current I in the resistor. (b) What horizontal force F is required to keep the axle rolling at constant speed? (c) Which end of the resistor, a or b. is at the higher electric potential? (d) Alter the axle rolls past the resistor, does the current in R reverse direction? Explain your answer. Figure P20.65
Two frictionless conducting rails separated by l = 55.0 cm are connected through a 2.00- resistor, and the circuit is completed by a bar that is free to slide on the rails (Fig. P32.71). A uniform magnetic field of 5.00 T directed out of the page permeates the region, a. What is the magnitude of the force Fp that must be applied so that the bar moves with a constant speed of 1.25 m/s to the right? b. What is the rate at which energy is dissipated through the 2.00- resistor in the circuit?
Consider the system pictured in Figure P28.26. A 15.0-cm horizontal wire of mass 15.0 g is placed between two thin, vertical conductors, and a uniform magnetic field acts perpendicular to the page. The wire is free to move vertically without friction on the two vertical conductors. When a 5.00-A current is directed as shown in the figure, the horizontal wire moves upward at constant velocity in the presence of gravity. (a) What forces act on the horizontal wire, and (b) under what condition is the wire able to move upward at constant velocity? (c) Find the magnitude and direction of the minimum magnetic Field required to move the wire at constant speed. (d) What happens if the magnetic field exceeds this minimum value? Figure P28.26
A generator connected to the wheel or hub of a bicycle can be used to power lights or small electronic devices. A typical bicycle generator supplies 6.00 V when the wheels rotate at = 20.0 rad/s. (a) If the generator's magnetic field has magnitude B = 0.600 T with N = 100 turns, find the loop area A. (b) Find the time interval between the maximum emf of +6.00 V and the minimum emf of 6.00 V.
The conducting rod shown in the accompanying figure moves along parallel metal rails that are 25-cm apart. The system is in a uniform magnetic field of strength 0.75 T, which is directed into the page. The resistances of the rod and the rails are negligible, but the section PQ has a resistance of 0.25 . (a) What is the emf (including its sense) induced in the rod when it is moving to tire right with a speed of 5.0 m/s? (b) What force is required to keep the rod moving at this speed? (c) What is the rate at which work is done by this force? (d) What is the power dissipated in the resistor?
Sketch a plot of the magnitude of the magnetic field as a function of position r for a coax (Fig. P31.27).
Singly charged uranium-238 ions are accelerated through a potential difference of 2.00 kV and enter a uniform magnetic field of magnitude 1.20 T directed perpendicular to their velocities. (a) Determine the radius of their circular path. (b) Repeat this calculation for uranium-235 ions. (c) What If? How does the ratio of these path radii depend on the accelerating voltage? (d) On the magnitude of the magnetic field?
The magnetic field 40.0 cm away from a long, straight wire carrying current 2.00 A is 1.00 T. (a) At what distance is it 0.100 T? (b) At one instant, the two conductors in a long household extension cord carry equal 2.00-A currents in opposite directions. The two wires are 3.00 mm apart. Find the magnetic field 40.0 cm away from the middle of the straight cord, in the plane of the two wires. (c) At what distance is it one-tenth as large? (d) The center wire in a coaxial cable carries current 2.00 A in one direction, and the sheath around it carries current 2.00 A in the opposite direction. What magnetic field does the cable create at points outside?