6.8 a) Find the inductor current in the circuit in Fig. P6.8 if v = 30 cos 500t V, L = 15 mH, and i(0) = -4 A. PSPICE MULTISIM %3D b) Sketch v, i, p, and w versus t. In making these sketches, use the format used in Fig. 6.8. Plot over one complete cycle of the voltage waveform. c) Describe the subintervals in the time interval be- tween 0 and 4T ms when power is being absorbed by the inductor. Repeat for the subintervals when power is being delivered by the inductor. Figure P6.8

6.8 a) Find the inductor current in the circuit in Fig. P6.8 if v = 30 cos 500t V, L = 15 mH, and i(0) = -4 A. PSPICE MULTISIM %3D b) Sketch v, i, p, and w versus t. In making these sketches, use the format used in Fig. 6.8. Plot over one complete cycle of the voltage waveform. c) Describe the subintervals in the time interval be- tween 0 and 4T ms when power is being absorbed by the inductor. Repeat for the subintervals when power is being delivered by the inductor. Figure P6.8

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Using the 0.68 kilo Ohms, 3.3mH inductance, and 5V source, compute for the theoretical voltages across the resistor and inductor for 10 kHz and 60 kHz. Show the step-by-step computation. Express the voltages in polar form.
A current of 2 uA is discharged on a capacitor with a plate area of 100 cm² and a capacitance of 1x10-^7F at t=0, and find the displacement current intensity (uA) between the plates at t=0.
The voltage at the terminals of the 200 μH inductor in Fig. P6.2(a) is shown in Fig. P6.2(b). The inductor current i is known to be zero for t≤0. 1. Derive the expressions for i for t≥0. 2. Sketch i versus t for 0≤t≤∞.
Determine vc,iL, and the energy stored in the capacitor and inductor
Inductance, Capacitance, and Mutual Inductance d.) Find the energy (in microjoules) stored in the inductor at 5 ms.e.) Find the maximum energy 9in microjoules) stored in the inductor and the time(in milliseconds) when it occurs.D and E only. Thank youuu
The distance between the plates of a capacitor, which consists of a square plate with a side length of 3 cm, is 2mm. The dielectric coefficient of the insulator is 2. If the maximum electric field that the air can withstand is 2.10 ⁶ V / m, find the maximum load the capacitor can carry.
5 Assume that you have been tasked with evaluating a new inductor. The inductor has a Q of 1454 at 50KHZ; a 0.1mm diameter, and is fabricated by wrapping a 10meter length copper wire wound around a magnetic core. Assume the following parameters for copper wire wound around a magnetic permeability of copper is 1. A. what is the inductance of the inductor? B. Assuming that the skin affect does not affect the Q at 50KHZ at all, determine the Q at 50MHZ.
Given the waveform below for the current of a 20 uF capacitor, sketch the waveform of the voltage Vc across the capacitor if Vc = 0 v at t = 0 s. Provide detailed solution pls
The voltage across a 200-mH inductor is given by v = 3t2 + 2t + 4V. Determine the current through the inductor after 1s. Assume that i(0) = 0
Solve for the (and refer to the image): - individual voltages - individual charges wherein Equivalent capacitance of the capacitor is 0.76 F Charge stored in the circuit is 45.50 C. And V= 60V
A capacitor is constructed with parallel metal plates, If the plate separation is 2 mm and the capacitance is given to 1 nano Farads, determine the area of the parallel plates of the device.
The voltage across a 15 H inductor is given by v = 28.5 + 6t1/2 v. Find the current in the inductor at 2.5 seconds if the initial current is 15 amperes.