60. An RLC series circuit connected to a 110-volt and 50-cycle AC source, contains the following series resistances and reactances: R1=10 ohm, R2= 15, XL1=20 ohms, XL2=25 ohms, XC= 40 ohms. Find the real power. a. 65.3899 b. 392.4372 c. 397.848 d. 588.6559

Q: Exercise 2: Resistances connected in Series-Parallel across a Sinusoidal AC Supply Calculate the…

A: In the circuit, pure Resistances connected in Series-Parallel across a Sinusoidal AC Supply We are…

Q: Discuss Fully the various methods available for transforming 3-phase voltages to higher or lower…

A: Different methods available for transforming 3-phase voltages to higher or lower 3-phase voltages at…

Q: a) Biefly explain the importance of reactive power in the analysis of power system performance.

A: (a) AC power system has two types of power. Active Power Reactive Power The power which is…

Q: 2)With reference to the waveform given below formulate the equation for the average value of DC…

A:

Q: For the circuit shown in Figure Q1, find the value of load impedance, Zi that will receive maximum…

A:

Q: What are the elements which contribute to the cost of the electricity? And discuss how the "load…

A: Electricity :  flow of electric charge is known as electricity . Electricity used for commercial…

Q: (a) What is the resistance of a 220-V AC short circuit that generates a peak power of 96.8 kW? (b)…

A:

Q: 100 www Q.31: For the circuit shown, find the steady-state voltage Vs-16cos100t Volt using…

A:

Q: An existing dc three wire system is to be converted into a 3phase 4 wire system by adding a fourth…

A: Same supply and load voltages, balanced condition and unity power factor   1) DC three wire system…

Q: What is nodal analysis/node-voltage method for Ac circuits. Also, please give me atleast 2 circuit…

A: NODAL ANALYSIS/NODE ANALYSIS FOR AC CIRCUITS: 1. One method of calculating the current and voltage…

Q: 41. Two ac sources feed a common variable resistive load as shown in figure. Under the maximum power…

A:

Q: A step down chopper has Vs = 230 V and R = 10 N. For a duty cycle of 0.4, the power taken by the…

A: A step down chopper has Input voltage, Vs = 230 V Resistor, R = 10 Ω Duty cycle, α = 0.4 The power…

Q: Q6.Using Kirchhoff's current law, find the values of the unknown currents in Figure .below

A: There are two Kirchhoff's law, known as Kirchhoff's voltage law (KVL) and Kirchhoff's current law…

Q: 2)With reference to the waveform given below formulate the equation for the average value of DC…

A: Given A three phase supply is connected to bridge rectifier V=180 V R=200 ohm

Q: A single phase transformers working at UPF has an efficiency of 90% at both half load and at the…

A:

Q: For the mutual electric circuit shown in figure beside, find the set values of mesh currents 11 &…

A: a mesh is a loop that does not enclose other loops. KVL, states that “in any closed-loop network,…

Q: For the mutual electric circuit shown in figure beside, find the set values of mesh currents 1 & 12?…

A: KVL, states that “in any closed-loop network, the total voltage around the loop is equal to the sum…

Q: An AC voltage of 230 v is applied to a circuit consisting of a resistance of 10 ohms in series with…

A:

Q: Illustrate the differences between tan δ terminology and power factor terminology (with the help of…

A: tanδ: If the applied electric field direction is reversed, the dipole alignment direction will be…

Q: 1) Principle and features of different methods for measuring three-phase power. 2) Discuss the…

A:

Q: An RLC series circuit connected to a 110 – volt and 50 – cycle AC source, contains the following…

A: In this question,  A RLC circuit connect with 110V , 50Hz battery.  Find the all data as per given…

Q: If it is connected in series with a pure resistance R with resistance R, inductance L, the current…

A: (a) Calculate the value of the resistance and the inductive reactance of the circuit. VR=IRR=VRI=30…

Q: When connected in series with a pure resistor R with resistance r and inductance L, three pairs of…

A:

Q: Determine the effective resistance Rin of the network exhibited in the figure. Each Ris 2.2n A…

A:

Q: Consider the circuit shown in Figure 2 below. a) Compute the phasor form of the load ZL that will…

A: (A)                                                                         Fig: Given circuit…

Q: If we knew that the transformer shown in FigureP7.49 were to deliver 50 A at 110 V rms with a…

A: Write the given values on the secondary side of the transformer. Find the output power of the load.

Q: 1. A single phase AC circuit consists of a 25 N pure resistance. It is connected to an AC supply of…

A:

Q: For type-A chopper of. dc source voltoge = 230 V, load resistance = 102. Take a voltage drop of 2 V…

A: Given values are - VS=230VVD=2VDuty ratioD=0.4 Given that chopper is type-A so that it is step down…

Q: 2)With reference to the waveform given below formulate the equation for the average value of DC…

A: Given A three phase supply is connected to bridge rectifier V=180 V R=200 ohm

Q: what should be the magnitude of ZL in ohms for it to absorb maximum power? what should be the phase…

A:

Q: (a) Considering pure resistance in an ac circuit element, show that the alternating voltage and…

A:

Q: DC Loads need to be connected to the power source through 2 wires (+) and (-) whereas AC loads…

A:

Q: Analyse the methods that improve the power factor of a electrical circuit.

A: In electrical engineering, the power factor of an AC electrical system is determined as that of the…

Q: Give your background about the AC systems from single phase and three phase systems to their…

A: AC system with single phase and three phase systems

Q: Q.23: For the circuit shown, find the steady-state current "i" and the total power supplied to the…

A:

Q: 352 452 I0V 15VT

A:

Q: As shown in Figure Q1(b), two loads A and B are connected in parallel across a 1.5 kV rms 60-Hz…

A: The solution can be achieved as follows.

Q: using the circuit below. if Vth = 40 Volts and Rth = 130 Ohms. Rth ww Vth Current flowing through RL…

A:

Q: When it is connected in series with a pure resistor R with resistance r and inductance L, the…

A: Given Pure resistor R is connected in series with resistance r and inductance LSinusoidal voltage…

Q: Q4. Define three cases on which real and reactive power flow gets affected. Draw the phasor diagrams…

A: Active power- The power is utilized or consumed in an AC circuit. It is known as real power, True…

Q: POWER MEASUREMENT OF DIRECT CURRENT (DC) AND ALTERNATING CURRENT (AC) SINGLE PHASE LOAD

A: Power is defined as the rate of doing work. Electric power is the electrical work done or electrical…

Q: A very important parameter in AC power circuits is power factor. Explain what “power factor” is, and…

A:

Q: Is there a difference between the phase windings resistances, if so, what does it mean? Please…

A: Insulation Resistance: For the electrical protection part, a protection opposition (IR) instrument…

Q: (a) Briefly explain the need for power factor correction (PFC). **Please kindly provide 5 points…

A: (a) 5 need of power factor correction is given below. Improved Voltage : When the system has low…

Q: An electrical heating element that has an AC resistance of 100 Ohms is connected across a 240V AC…

A:

Q: In an apartment with three flats fed from a 400V 60 Hz three-phase network, a 250W device in…

A: Given circuit: Line voltage

Q: 1- Effective value when connected in series with a pure resistor R with resistance r and inductance…

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.