7) The apparent power consumed by the 4 ohms resistor is ...... VA:a) 4.38 2-152e) 13.45b) 24) 22.48d) 8.76h) None of the abovec) 4.76g) 4.38

None of these Resistors only consume active power and it is measured in watts not in volt amperes

Answered: 7) The apparent power consumed by the 4…

7) The apparent power consumed by the 4 ohms resistor is .... VA: a) 4.382-152° e) 13.45 b) 24 f) 22.48 c) 4.76 d) 8.76 h) None of the above g) 4.38

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 18 1. Given a unity positive feedback system with open-loop transfer function G(s) =- 8 +s* – 7s³ – ...

Q: Compute linear convolution using circular convolution of the following sequences х, (п) %3 6(п) + 6(...

Q: PROBLEM: An amplifier without feedback has an internal gain of -500 with a distortion of 10% and a n...

Q: What is the resistance of a copper specimen with an initial resistance of 250 ohms at 38 degrees Cel...

Q: HW22(C) For the network of Problem 13: 12 V a. Determine (re). b. Find (hfe )and (hie). c. Find (Zi)...

A: As per company guidelines we can solve only first three sub parts kindly post another parts separate...

Q: T To what voltage the machine will excite when the ficld resistance is 55 0 and the spced 800 rp.m. ...

A: In this question, Saturation curve of the shunt generator is given. Find the filed resistance for ...

Q: . Given the operational amplifier below. a. Solve for the input voltage, if the feedback resistors ...

A: Given circuit:

Q: Q2 / For the connection of Figure 2, in terms of switching surge, when the second terminal of CB is ...

A: Given R=8.5 ohm L=7.1 mH C=0.0516 microfarad

Q: A circuit draws a current of (4 + j 3) A from a (150 - j 5) V source. What is the real power of the ...

Q: Design the given circuit shown. Finalize answers as: Idavertgmin= Idpkrtgmin%3; Vdpkrtgmin=: Isavert...

Q: (d) Determine the minimum value of Rz to ensure that the Zener diode is in the "on" state. Rs 220 N ...

Q: difference between a bandwidth of a signal and bandwidth of a channel

A: Difference between a bandwidth of a signal and bandwidth of a channel:

Q: [Q4]For the following fiels equations which one is rotational and which one is irretational 1- F=yza...

A: This question belongs to electro magnetic field theory . It is based on the concept of curl of a vec...

Q: Find Io and current at point x using the following: A. KVL B. KCL Include Vab, Vbc, Vca

A: In this question, Find Io and current at point x using the following: A. KVL B. KCL Include Vab, Vbc...

Q: Resistor Color Bond Resistance and Tolerance Yellow-White-Blue-Silver 2 Green-Red-Red-No color 3 Blu...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ...

Q: Q.3 (a) Assuming Vs = 10 V, calculate the values of Vi, VN and Vo i.e. voltage at inverting terminal...

Q: HW22(E ) For the common-base network of Fig. 5.187 : a. Determine (Z i) and (Zo). b. Calculate( Av) ...

Q: Wireless communications have had a significant impact on the Internet. We use the Internet today in ...

A: Wireless communications: Wireless communication is a kind of information communication that is perfo...

Q: Problem For the circuit shown below, use KCL and KVL to find the current in all branches. A 50 60 13...

A: This question belongs to circuit theory . It is based on the concept of kvl and kcl for calculation ...

Q: A coil has resistance of 5 ohm and inductive reactance of 4 ohm. a) what is the impedance of the co...

A: This question belongs to circuit theory . It is based on the concept of impedance and admittance of ...

Q: 4 Violet-Black-Orange-Silver Gray-Black-Red-No color White-Black-Blue-Gold

A: 4. Color code: Violet-Black-Orange-Silver 1st digit 2nd digit Multiplier Tolerance Colors V...

Q: Consider the two signals c1(t) = cos(105nt) and c2(t) = sin(10°t). Consider also the two signals, m1...

Q: laplace transform of 6u(t)

Q: Three capacitors 8µF, 6µF, and 4µF are connected in series with an 9V battery. Determine the: (4) en...

Q: Problem 4 Consider the FM signal with kf = 207. The message signal m1(t) is as given below. Plot the...

Q: Electrical Engineering I'm trying to study Microcontroller instructions (PIC16F877A) by Assembly (35...

A: Microcontroller- Microcontroller is a form of integrated chip. It a combination of memory, input out...

Q: 6. Compute: а. 1100 + 1000I b. 11100 + 00100 c. 01100 - 1001i assuming (one-by-one): signed-magnitud...

A: Given: a. 11100+10001 b. 11100+00100 c. 01100-10011

Q: Assume that a 5 MW distribution substation experiences an annual peak load of 3500 kW. The total ann...

Q: the inductor as a function of t

A: Resistance in parallel-1Req=1R1+1R2+1R3+........... Resistance in series-Req=R1+R2+R3+...........

Q: write the state equadion-far the networ.k. ShawAbelow Ust) () loope (voy 2

Q: 00000 O

A: Given

Q: If the cross sectional area of the conductor increases, then the resistance of the conductor A5 From...

Q: 2. Find the current in the 5 ohms resistor in the circuit. (Hint: combination of nodal and Thevenin'...

A: Here To find the current through 5 ohm Nodal analysis can be done and The values of node voltages ...

Q: A 40uF capacitor is connected across a 230V, 50HZ supply. Calculate a) the reactance offered by the ...

Q: What are the node voltages values in the circuit below. Express answers with or without (20 or 20 V)...

Q: An inventor reported that he could apply the knowledge available from the standard reduction table e...

A: Given: Cell delivers 12V

Q: DETERMINE THE OUTRUT VOLJAGE (VO) OF A DIFFERENTIAL AMPUFIER FOR THE INPUT VOLTAGES f 300 miorovolt ...

Q: An accelerometer consisting of an elastic element and a potentiometric displacement sensor has to me...

A: It is given that: Input range=0 to 5 gDamping ratio=ξ=0.8Output range=0 to 10 VMaximum non-linearity...

Q: 1. Find the (Vo) theoretical? 2. Drive the (AV) the integrator? 3. The input of integrator operation...

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: Two resistors with resistances of 10 Q and 23 Q are connected in parallel. The parallel combination ...

Q: Three capacitors 3 µF, 5µF, and 9µF are connected in parallel with an 9V battery. Determine the: (1)...

Q: i) Determine the transfer function for the RC network below. Hint: use mesh analysis.

Q: 9. Find the rise time for the given transfer function: 100 G(s) = s' +15s +100 10. Determine the pea...

Q: Thickness of layer of the cable depends on Voltage. A3 a) Armoring b) Bedding c) Serving d) Insulati...

A: In this question, We need to Choose the correct option. The thickness of..... Layer of the cable d...

Q: Enumerate five step-by-step procedures of Maximum power transfer theorem method in application to ac...

A: MPT theorem: This is used to find the maximum power in the load.

Q: iii) Consider a system described by: ÿ + 3ỹ + 2ý = u Derive the state-space representation of the sy...

Q: Determine the following A) Voltage gain (Av) B) Current gain (Ai) C) Determine the Peak-to-Peak out...

A: As per company guidelines we can solve only first three sub parts kindly post another parts separate...

Q: Given the circuit below operating at 60 Hz. Determine all relevant ;ILave=:ILpk=_ quantities. Finali...

Q: IR R1 L1 C1 2.50 2mH 30µF The voltage applied across 3-branched circuit (shown below) is given by v=...

Q: 4. A 3-phase, wye-connected alternator is rated at 2000 kVA, 13.5 kV. The effective resistance and s...

Question

7) The apparent power consumed by the 4 ohms resistor is ...... VA:
a) 4.38 2-152
e) 13.45
b) 24
) 22.48
d) 8.76
h) None of the above
c) 4.76
g) 4.38

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In your opinion what role Electrical Engineers can contribute in community development in the year 2021. Elaborate
TOPIC: Fundamentals of Alternating Current Powers Give illustration and a step by step solution. Final answer must be in 4 decimal places. 1. A load takes 55kW at 70% power factor lagging from a 240V, 50Hz supply. If the supply is made 60Hz, with the voltage remaining the same, what will be the kW load at 60Hz? 2. An inductive coil takes a current of 2A and consumes 160W when connected to a 240V supply. A second coil when connected across the same supply takes 3A and 500W. Find the total power when the two coils are connected in series to the supply. 3. A series RC circuit is connected to 230V, 60Hz source. If the power taken by the circuit is 4,800W and the voltage drop across the resistor is 115V, calculate the capacitance of the capacitor. Thank You in advance!
The voltage and current at the terminals of the element are v=250 cos 800πt V, i=8 sin 800πt A. Find the maximum value of the power being delivered to theelement.
6 One end of the voltage coil should be connected with the M terminal of the wattmeter Select one: True False
Which of the following is an integrating instrument? a. Ammeter b. Voltmeter c. Watthour meter d. Wattmeter
PV ________ is a group of PV __________ that comprises the complete PV generating unit. Select one: Array; cell Cell; module Panel; array Array; Panel
In the circuit in the figure, the apparent power (S) of the second arm is given as 1490 VA. Accordingly, a) I2 current, b) circuit voltage calculate. Calculate.
The values of the circuit elements are given below. accordingly, find the current i at t=34.6 sec.
An electric fan has resistance 5 ohm and an indacatance of of 2*19 millihenry .what is it's impedance if f=60 herts.
Referring to the Figure 1 below, given the value of frequency, f =50 Hz Determine: - i) The phasor domain equivalent circuit ii) The value of voltage source, Vs iii) The value of voltage, Vo Write your answer in 3 decimal places.
Determine the power absorbed by element X of the circuit, a) an independent 60V voltage source, reference + at the top.
Suppose that each headlight of your car uses 3A and that you accidentally left the headlights on. How long will it take for a 12 V battery rated 80A – hr to be fully discharged