[7] x(t) is a band-limited signal with bandwidth B=3000 rad/sec. Its spectrum is assumed to have a square shape with unity amplitude. We sample x(t) at a rate of one sample every Ts second. (a) What is the minimum sampling rate @s=2rTs required to avoid the Aliasing effect? (b) Draw the spectrum of the sampled signal, when the sampling frequency is 1500, 3000 and 7500 rad/sec. (c) If we pass the sampled signal through an ideal LPF with bandwidth equals B, draw the spectrum of the reconstructed signal in each of the three cases described in (b).

[7] x(t) is a band-limited signal with bandwidth B=3000 rad/sec. Its spectrum is assumed to have a square shape with unity amplitude. We sample x(t) at a rate of one sample every Ts second. (a) What is the minimum sampling rate @s=2rTs required to avoid the Aliasing effect? (b) Draw the spectrum of the sampled signal, when the sampling frequency is 1500, 3000 and 7500 rad/sec. (c) If we pass the sampled signal through an ideal LPF with bandwidth equals B, draw the spectrum of the reconstructed signal in each of the three cases described in (b).

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A robotic system with transfer function ?(?) =(100)/(s(0.1s+1)(0.1s +1)) is controlled with gain K as shown in the figure. A)To analyze the frequency response of this system, draw the Nyquist graph. B)Apply the Nyquist stability criterion. C)Verify the stability analysis you made in part (b) by plotting root locus plots for the positive and negative values of the K gain. D)Calculate the gain value that makes this system borderline stable and show it on Nyquist and Root locus graphs. E)Calculate the gain margin, phase margin, gain crossover frequency and phase crossover frequency values. F)Explain whether the system is stable over the gain margin and phase margin values. WE NEED TO SOLVE THE PROBLEM IMMEDIATELY. PLEASE HELP.
Answer the Following and provide solution. 1. The maximum frequency deviation of the carrier is ± 15 kHz and the maximum modulating frequency is 3 kHz, calculate for the modulation index. 2. Assume that the 60-dB bandwidth of a receiver is 12 kHz and the 6-dB bandwidth is 7 kHz. What is the shape factor of the circuit? 3. What is the bandwidth of a receiver with a quality factor of 50 and a resonance frequency of 540 kHz. 4. What is the maximum bandwidth of an FM signal with a deviation of 27 kHz and a maximum modulating signal of 4 kHz as determined by Carson’s rule? 5. A PM signal has a maximum allowed deviation of 17 kHz and an actual deviation of 8 kHz. What is the percentage modulation?
What is the bandwidth of an AM signal whose carrier is 2.1 MHz modulated by a 1.5-kHz square wave with significant harmonics up to the fifth? Calculate all the upper and lower sidebands produced? (Our lesson is AMPLITUDE MODULATION FUNDAMENTALS) (Please box the answer )
A filter is provided with a cascaded differential amplifier. The midband gain and noise coefficient of the filter are given as −3 dB and 3 dB, respectively.According to this,a) If it is known that the amplifier gain is ?1= 20 dB and the noise coefficient is ?1= 2 dB, calculate the midband gain for the entire cascaded system. Give your answers in dB
What is the bandwidth of an AM signal whose carrier is 2.1 MHz modulated by a 1.5-kHz square wave with significant harmonics up to the fifth? Calculate all the upper and lower sidebands produced. (Our lesson is AMPLITUDE MODULATION FUNDAMENTALS)
A digital radio communication system receives a signal with signal power Sof 3 µW, and noise level of 200 nW, on a radio channel with upper cut-offfrequency of 2.42 GHz, and a lower cut-of frequency of 2.40GHz. . What is the signal Bandwidth in Hertz?
Type your question here Compute the noise equivalent bandwidth of third order Butterworth filter whose magnitude frequency transfer function is (?) = √1+?6 . Compare your answer to the −3?? bandwidth.
The carrier c(t) = 100 cos(2πft) is frequency modulated (FM) by the message signal m(t) = 5 cos( 20000πt), where f.= 100MHz. The peak-frequency deviation is 20 kHz. The modulated signal is a wide-band FM.1. Determine the amplitude and frequency of all signal components that have a power level of at least 10% of the power of the unmodulated carrier component.2. From Carson's rule, determine the approximate bandwidth of the FM signal.
i) A communication system employs a continuous source. The channel noise is white and Gaussian. The bandwidth of the source output is 10 MHz and signal to noise power ratio at the receiver is 100. (a) Determine the channel capacity. (b) If the signal to noise ratio drops to 10, how much bandwidth is needed to achieve the same channel capacity as in (a). (c) If the bandwidth is decreased to 1 MHz, what S/N ratio is required to maintain the same channel capacity as in (a).
4. short answers a. What is the effective antenna area of an antenna at 2500 MHz, if the gain is 13 dBi. b. For a WCDMA handset with 7 dB noise figure and 5 MHz effective noise bandwidth, calculate the noise floor in dBm. c. An NBA basketball player is close to 2 meters tall, and an “Umpa-Lumpa” from the movie “Willie Wonka” is 0.5 meters tall. Assuming 2-ray propagation model, what is the ratio of the signal strength received by the two people? d. Consider a 12-km microwave link with 15 meter towers at both ends, calculate the minimum frequency in GHz, such the first Fresnel zone does not intersect the ground? Assume that the ground is flat between the towers.
1. Given an analog signal x(t)=10 cos(2π.5500t)+5 cos(2π.7500t) is sampled at a rate of 8,000 Hz, a. Sketch the spectrum of the sampled signal up to 20 kHz; b. Sketch the recovered analog signal spectrum if an ideal low pass filter with a cutoff Frequency of 4 kHz is used to filter the sampled signal in order to recover the original signal; c. determine the frequency/frequencies of aliasing noise.
A digital communication link carries binary-coded words representing samples of an input signal, xa(t)=3cos⁡(600πt)+2cos⁡(1800πt)The link is operated at 1,000 samples/s. (a) What is the folding frequency? (b) What is the Nyquist rate for the signal xa(t)? (c) What are the frequencies in the resulting discrete-time signal x(n)? (d) Will there be any aliasing here? (e) Which frequency will alias to what frequency