7. A dc electric motor consumes 36 MJ when con- nected to a 250 V supply for 1 hour. Find the power rating of the motor and the current taken from the supply. [10 kW, 40 A]

Q: 2. Design a Hi-Fi circuit to drive a 11 load with 1) Voltage Gain: 300 2) Output Swing: +40V. Your…

A: To Design Voltage Gain and output

Q: Unless given, use the: POLAR FORM for voltage and current, RECTANGULAR FORM for impedance. Consider…

A: As per the guidelines of Bartleby we supposed to answer first three subpart only for solution of…

Q: A substation rated 1250 kVA is operating at full load at 0.8 pf lagging and to carry an additional…

A: Capacitor banks ,synchronous phase modifiers are used to increase the power factor of the system. By…

Q: TI systems has the block diagram as shown in Figure 1. Signal Flow Graph for the system. G4(S) Y(S…

A:

Q: A 4-pole, lap-connected d.c. motor has 576 conductors and draws an armature current of 10 A. If the…

A:

Q: When the input voltages to this circuit are Vi1 = 0.15 V and Vi2 = 0.7 V, the output is 10 ΚΩ 5 ΚΩ…

A: given here a op amp based circuit and asked to find the output voltage V0 .   here nothing is…

Q: Using mesh analysis, find io in the circuit below

A: In this question we will ise mesh analysis and find unknown current i0....

Q: 8 Ω ww + K 2 www 392 + m 6 Ω 30 V Determine the following: 1. The current i1, i2, i3 2. The power…

A:

Q: Determine the z-transform of the following: (⑥) 20 x(n)= -11 <O 6 <H<₂ |(1-2z-¹) 5 --2 3 응시를 대 시디2 이…

A:

Q: For the following block diagram: r(t) + 1 k s(s+ 4)(s + 10) (a) For what values of k> 0 is the…

A:

Q: matrices.

A:

Q: Determing the front pitch, back pitch, and average pitch of the armature winding.  12 poles     100…

A:

Q: Circul brushes. The field current is 1.8 A Determine (full-load line current (ii) full load shaft…

A: In this question , we will find full load line current , shaft torque etc of dc shunt motor....

Q: A balanced Y-Y four-wire system has phase voltages ??? = 120∠0° V, ??? = 120∠ − 120° V, ??? =…

A:

Q: The diodes are ideal, zero cut in volts, zero forward resistance and infinite reverse resistance.…

A:

Q: For the given network below find the a - VD , b-VC , C-VG , D-VGSQ , e-IDQ , f-IE , j-IB

A: The given circuit diagram is shown below:

Q: 14.1 a) Find the cutoff frequency in hertz for the RL fil- ter shown in Fig. P14.1. b) Calculate…

A: a) the figure shows a low pass filter using RL circuit     The transfer function of the circuit is…

Q: Design a combinational logic circuit that Subtractor (B8 B7 B6 B5 B4 B3 B2 B1) from (A8 A7 A6 A5 A4…

A: Binary code used in digital electronics, In binary number there are two possible results off and ON…

Q: Australians use the n76 band at 3.5 x 109 Hz. Determine the wavelength at this frequency. Show clear…

A: Given data, Frequency f=3.5×109 Hz Speed of light c=3×108 m/s

Q: IB www RB RE Vcc RC I'c Ic + VCE IE

A: Voltage feedback bias circuit always works in active mode because collector voltage is always more…

Q: Find the input-output relationship for the transational mechanical system shown below. The input is…

A:

Q: 2. Determine the rms value for each of the waveforms shown in figure below. (a) e (V) hour 2 2 5 7…

A:

Q: Derive the operating point ,Q-pt.,  of the BJT voltage-divider bias circuit shown using Approximate…

A: It is given that: Required: Q-point or Operating point.

Q: An air craft control system has H(s) = 1 and G(s) = Determine the: a) b) c) Gain margin Phase margin…

A: Given: An aircraft control system has a feedback gain of  Hs=1, and forward path transfer function

Q: What is the voltage when current is 5 A and resistance is 88 ? Do NOT include units Round your…

A: for determine voltage  we use ohm's law it is given as when pressure and temprature is constant then…

Q: .Design equation F(A,B,C,D)=E(1,2,3,6,8,10,12,13,15) using a 4x1 Mux?

A: Follow the Boolean laws provided  Compare the obtained F with standard multiplexer notations and…

Q: A lead (= 5 x 10 S/m) bar of square cross section has a hole bored along its length of 4 m so that…

A: given σ=5×106 S/m   and length l=4 m asked to find resistance R

Q: A multiloop circuit of resistors, capacitors, and batteries is switched on at t = 0, at which time…

A: It is given that: At t=0, a multi-loop of resistors, capacitors, &amp; batteries is turned on, with…

Q: 9) The voltage across a 12-mH inductor is v= 24cos (200t – 10°) V. Find the instantaneous through…

A: In this question we have given voltage across inductor ....We have to find out current through it...

Q: Diagram of the problem, necessary formulas, clearance and numerical solution. A steady current of…

A:

Q: 1. In addition to resistive components, state or name one other electromagnetic component found in…

A: As per guidelines given to us we can only provide the solution of one question in multiple type of…

Q: 100 ΚΩ 20 ΚΩ 9-2V Jov J1V 92V 100 ΚΩ 20 ΚΩ

A:

Q: Determine the values that should be used for both K1 and K2 so that the step response of the…

A:

Q: Basic Electrical Engineering 1. Derive the formula for the energy stored in an inductor

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 220 V 60 Hz R R = 25 Q2 L V₁ L=6 mH C HI Ve C= 100 μF

A:

Q: Use Simulink, you can set the symbol rate as 1 kHz. a) Plot the spectrums of the BFSK, 4FSK, 8FSK,…

A: To Plot the spectrums of the BFSK, 4FSK, 8FSK, 16FSK system

Q: Em-e An EM wave propagating

A: EM wave : EM wave is also known as electro magnetic wave as the name suggests EM wave formed as a…

Q: if a pure resistor is connected in parallel with the original impedance

A:

Q: A transformer which can produce 8v from a 240v a.c supply has an efficiency of 80%.if the current in…

A: Given data, Primary voltage Vp=240 V Secondary voltage Vs=8 V Assuming secondary current as 15 A…

Q: A pressure measuring device indicates 13 psi which actually has the true value as 11 psi. The…

A:

Q: Q2: A PMMC(Galvanometer instrument) has a resistance of 10002 and FSD for a current of 400Aμ. A…

A: given:

Q: Use Nodal Theorer to solve for the cit 7 45 4 75.8& 1201 4 Find the total power. unsumed by the…

A: In this question we will find power consumed by circuit.....

Q: A schematic design of a full-wave bridge type power supply is given below. Provide the appropriate…

A: The Given full wave rectifier, VODC=7.5,  P0=20mW,  Vmp=311.13Vpf=60Hz,…

Q: Find the transfer function of the high pass filter shown in Fig1. R1 HE www Vo + Vi R3 WHI ww R2

A:

Q: What is the value of Rf in ohms if we want a gain of -125 for an inverting amp which has an R1 =…

A:

Q: List the responsibilities of the project contractor

A:

Q: 2.7) True or False: Directional antennas provide poor efficiency of power transmission. 2.8) Fill in…

A: Given  True or false question and few fill in the blanks based on antenna theory. Please find the…

Q: Derive the operating point ,Q-pt.,  of the BJT voltage-feedback bias circuit shown.

A:

Q: Determine the phasor currents I, and I, in the circuit of Fig. 13.13. 5Ω j2 Ω 100/60° V j6 Ω -j4 Ω Μ…

A: Here we discuss about the circuit concepts using mutual coupled circuits.

Q: After a long time in position-a, the switch in the circuit shown Fig.5 is change to position-b at…

A: Following are the condition for capacitor in dc transient analysis:  Capacitor opposes the sudden…

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.