An electric lift truck is powered by a dc motor connected to a 110 V battery. The truck exerts 200 lbs pull while moving at 7mph. If the overall efficiency of the motor and drive mechanism is 75%, what is the current drain on the battery ?

Q: 10 Vx 0.05Vx Vo 12A 20 20 1 i) Determine the Thevenin equivalent circuit parameters “VTH" and "RTH" ...

A:

Q: Explain the importance of cascaded IF amplifiers in a superheterodyne receiver.

A: Superheterodyne receiver- A superheterodyne receiver mixes its input with a higher or lower frequenc...

Q: (a) Determine the lower cutoff frequency for the network of Fig. 11.16 using the fol- lowing paramet...

A: We need to find out lower cur off frequency of the given circuit

Q: The figure above on the left side shows the first quadrant of the J-V and power curves of an ideal a...

A: Given the figure as shown below: A) From the following figure, we need to find Fill Factor for the ...

Q: 14.A. The two basic receiver components that perform amplification are the A. signal-detect circuit ...

A: To select correct answer from given options

Q: Two point charges Q1=25nC and Q2=60nC are located at P1(4,-1,7) and P2(-3,4,-2), respectively. Find ...

A:

Q: Problem 1 For the circuit shown, use nodal analysis to determine the values of the voltages V, and V...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: Given: 275 kW, 3-phase, 6,600 V was tested with the following results. OCT in volts SCT in Amps With...

A: Note:  As per the  guide lines of the bartleby we are supposed to solve 3 questions, when they are i...

Q: For an NPN Bipolar Junction Transistor base-emitter voltage, VBE is 0.7 V at collector current, Ic o...

A: We need to find out saturation current for given collector current

Q: Q1. The system impulse response is given as h[n] = 0.3"u[n – 3] – 2"u[-n-3]. Check if the system is ...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: In the balanced three phase power measurement using two wattmeter method, each wattmeter reads 24 kW...

A: We have given the following problem

Q: Provide a brief (a few phrases) definition and description of each of the following, as well as an e...

A: In consideration of complex system, there are many differential equations. These equations are commo...

Q: A three phase, wye-delta connected, 345/34.5 kV transformer has an emergency rating of 60 MVA. Deter...

A: Transformer is a device which is used to increase or decrease the input or output voltage which are ...

Q: 1. Three impedances Zı = 1– j4 , Z2= 0 – j6 and Z3 = 4 + j3 ohms respectively are connected in serie...

A: This question belongs to circuit theory . It is based on the calculation of equivalent impedance of ...

Q: As a data acquisition anti-alias filter, an RC Butterworth filter is designed with a cutoff frequenc...

A: The Butterworth filter is a signal processing filter that aims for a flat frequency response in the ...

Q: 2. A generating unit of 10 MW capacity supplies the following loads: Domestic consumers with a maxim...

A: Since you have posted multiple different question. we will solve the first question for you. To get ...

Q: 10 ohms 8ohms 0.03H pf: 09 lagging

A:

Q: 4. Calculate the output voltage of an op-amp summing amplifier with the following values: Rf 1.5MN, ...

A: We need to find out the output voltage for summing amplifier and non inverting amplifier

Q: A coil has an inductance of 40mH and negligible resistance. Calculate its inductive reactance and th...

A: Given a coil has, Inductance, L = 40 mH Resistance = 0 (negligible) Supply voltage, Vs = 240 V Frequ...

Q: In substations, the buses are made of a. ACSR b. aluminium O c. PVC O d. Iron

A: Since you have asked multiple question, we will solve the first question for you. If you want any sp...

Q: The reactance of 10 mH inductor and a 0.2 uF capacitor are equal when the frequency is: 21 kHz 7.12 ...

A: Given: Inductor, L=10 mH Capacitor, C=0.2 μF Reactance of inductor and capacitor are equal.

Q: ww Rs 享 Ish ас Rsh Rm Input Rectifier Type of Voltmeter

A: The solution is given below

Q: Determine V, and Ip for the networks of Fig. 160.

A:

Q: a) Apply nodal analysis to solve for Vx in the circuit of figure Ba. Copyright © The McGraw-HiI Comp...

A: Since we are authorized to answer only one question at a time since you have not mentioned which que...

Q: 3 Series Diode Configurations 5. Determine the current I for each of the configurations of Fig. 155 ...

A: Since you have posted the multiple questions so we are supposed to answer first one.

Q: O shown below are two separate cincuito. Let |VeE lon) | = 0,7 valt , VECtat) | = 0.2Volt, VA = lo4 ...

A:

Q: The figure shows an electric circuit which contains a double switch labelled by S. When the switch i...

A: Given Switch at 11'  ,  II=6 A Switch at 22'  ,  III=6 A Switch at 33'  , ammeter reading ?  

Q: Draw a simple circuit, label the parts and write brief explanations on how these parts work in a cir...

A:

Q: ii. A causal discrete time LTI system is described by y[n]-n-1]+Mn- 2]= x[n] , where xtn]and y[n] ar...

A:

Q: A system uses channel bandwidth as 4 MHz and it can support a raw data rate of say 15 Mbps, assuming...

A: Given that New data rate=13Mbps Bandwidth=4MHz

Q: 12.A. A connector is a _______ device used to connect a fiber to a source, detector, or another fibe...

A: The solution is given below 

Q: Stability of a system was defined in the lecture and in section 2.2.5 of the text, and it was shown ...

A: For a stable system the signal should be absolutely summable for entire interval.  

Q: x2(t) = 5 cos(4at + a/4) + 7 sin(5xt). Signal z2(t) is the input to an LTI system with the impulse r...

A:

Q: Find V, using superposition theorem. -j42 j5 2 ww 10/0° V 3/0° A

A: Given Superposition system:The response produced at an element when all rthe sources are present is...

Q: Design a Half adder, Full adder, Half Subtractor and Full Subtractor.

A:

Q: Using the load-line methodology, please find the operating point of the Zener diode of the following...

A: Diode- Diode means uni-directional flow of current, that's why to convert Ac to Dc voltage we use re...

Q: Obtain the Fourier transform of At) = H(4)e la>0) inono a.

A:

Q: Problem 3. Determine the total resistance across ab. a R R R R R R. R R R 9,

A: In this question Find the equivalent resistance across the terminal a and b.  We know if two resista...

Q: 2.47 The Fourier transform of a signal is shown in Figure P-2.47. Determine and sketch the Fourier t...

A:

Q: 2- A conducting bar of length L moves with a velocity V along +x direction in a static magnetic fiel...

A: Electromotive force is defined as the electric potential produced by either electrochemical cell or ...

Q: 1a Name four benefits of a digital system over an analog system. 1b.Name the three parts of the syst...

A: Given: Digital system and analog system

Q: 16.A. A glass fiber weighs ________ a copper conductor. A. twice as much as B. considerably more tha...

A: 16.A. A glass fiber weighs ________ a copper conductor. A. twice as much as B. considerably more tha...

Q: How do you know if a single stage and a second stage amplifer is considered to be an IF amplifier ju...

A: Single stage  In Single stage IF amplifier There is only one transistor. there is only one  L and C ...

Q: Explain the opera tion principles of Yotating tansformer with neat Sketch. Also, define the laws and...

A: A rotary transformer is a type of transformer that couples electrical impulses between two rotating ...

Q: Find the unit vector directed from (3, -7, 6) toward (4, 6. -12).

A:

Q: A 5 OH MS RESISTOR IN SERIES WITH AN INDUCTOR HAVING ANINDUCTANCE OF L= 15,92 MILLI HENRY IS CONNECT...

A:

Q: D A + В F + A (a) R S T P - T R + S T (b)

A: The solution is given below

Q: Determine the waveform of the output voltage Vo in the network efficiently for sinusoidal input sign...

A:

Q: Which of the following has the maximum Energy gap between conduction band and valence band? O None O...

A: The bandgap is the energy gap between the valence band and conduction band or between the free state...

Q: The maximum peak-to-peak value of an AM wave is 125 V. The peak-to-peak value of the modulating sign...

A: Given, Maximum peak-to-peak value of AM wave is 125 V. Peak-to-peak value of modulating signal is 20...

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.