7.3 Fluid fills the space between two parallel plates. The differential equation that describes the instantaneous luid velocity for unsteady flow with the fluid moving parallel to the walls is = l- The lower plate is stationary and the upper plate oscillates in the x-direction with a frequency w and an amplitude in the plate velocity of U. Use the characteristic dimensions to normalize the differential equation and obtain the dimensionless groups that characterize the flow. U cos ot |H P7.3

7.3 Fluid fills the space between two parallel plates. The differential equation that describes the instantaneous luid velocity for unsteady flow with the fluid moving parallel to the walls is = l- The lower plate is stationary and the upper plate oscillates in the x-direction with a frequency w and an amplitude in the plate velocity of U. Use the characteristic dimensions to normalize the differential equation and obtain the dimensionless groups that characterize the flow. U cos ot |H P7.3

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.13P: 5.13 The torque due to the frictional resistance of the oil film between a rotating shaft and its...

See similar textbooks

Similar questions

Independent variables in a turbomachine are the impeller diameter, D, angular speed, ω, and fluid viscosity and density. Dependent properties are volumetric flow rate, Q, head, H (energy per unit mass), and power input, P. Use ρ, ω, and D as repeating variables in a dimensional analysis. a) Determine the dimensionless ratios that characterize this problem. b) Under what conditions will flows in two different machines be similar? c) Determine the speed of operation for machine 2 for the same flow as machine 1 if D2/D1 = 2 and viscous effects are unimportant. What will be the head ratio under these conditions? Note:hand written solution should be avoided.
Solving fluid dynamic problem, flow through a cylinder, a uniform gradient only applied in z direction, If r is the radial polar co-ordinate, derive the velocity v_z(r) for steady flow at low Reynolds number. The result is about pressure gradient divide by 4 times viscosity and multiply by the difference of square of two distances. Do I need to convert distance into to radial polar co-ordinate in the result? How to consider this result in cylindrical coordinate?
Determine the form of an equation for the distance (s) that a sphere will fall in time t, if it starts with an initial velocity and the resistance of the fluid through which it falls is taken into consideration. Resistance is dependent upon the density (ρ) and viscosity (μ) of the medium and the diameter (d) and mass (m) of the sphere. Hence in addition to g, v and t these factors are incorporated. S = f (g, v, t, m, d, ρ, μ) USE DIMENSIONAL ANALYSIS AND BUCKINGHAM PI THEOREM
The power input P to a centrifugal pump is assumed to be a function of the volume flow Q, impeller diameter D, rotational rate Ohm, the density rho, and viscosity mu of the fluid. Rewrite this as a dimensionless relationship
A simply supported beam of diameter D , length L , and modulusof elasticity E is subjected to a fluid crossflow of velocityV , density ρ , and viscosity μ . Its center deflection δ isassumed to be a function of all these variables. ( a ) Rewritethis proposed function in dimensionless form. ( b ) Suppose itis known that δ is independent of μ , inversely proportionalto E , and dependent only on ρ V 2 , not ρ and V separately.Simplify the dimensionless function accordingly. Hint:Take L , ρ , and V as r e peating variables.
The thrust force of propeller (P) depends upon the flow velocity V, angular velocity o, diameter D, dynamic viscosity , density p. the speed of sound in the medium C. (1) Derive the relationship between the above variables and the thrust force by using Buckingham's IT-theorem. (2) Explain the physical meaning of the obtained dimensionless groups. إجابت
The time t d to drain a liquid from a hole in the bottom of atank is a function of the hole diameter d , the initial fluidvolume y 0 , the initial liquid depth h 0 , and the density ρ andviscosity μ of the fluid. Rewrite this relation as a dimensionlessfunction, using Ipsen’s method.
Dimensional Analysis and Hydraulic Similitude (fluid mechanics) 1. Water at 60F at 12 ft/s in a 6-in. pipe. (a) For dynamic similarity, determine the velocity of medium fuel oil at 90F flowing in a 12-in. pipe. (b) Determine the diameter of the pipe that should be used if a medium lubricating oil at 70oF if flowing at a velocity of 50 ft/s. find the: a. velocity : ____________________ fps b. diameter : ____________________ in.
6 For incompressible flow, density remains the same Select one: True False
Q// Upon completion of the Reynolds experiment, we had this information. The tube diameter was 0.03 m, time is 14 sec and the lamellar bisection type 'Find Q flow rate m^3/s , Re, viscosity and velocity m / s at a temperature of 26 ° C for water.
A 1:7 scale model simulates the operation of alarge turbine that is to generate 200 kW with a flowrate of 1.5 m3/s.What flow rate should be used inthe model, and what power output is expected?(a) Water at the same temperature is used in bothmodel and prototype.(b) The model water is at 25°C and the prototypewater is at 10°C.
Measurements at a certain point of a pipe have been done where the following parameters were recorded: Fluid of density = 887 kg/m3, Fluid velocity = 4 m/s, Pressure= 11.3 KN/m2 If the total energy per unit weight at this point = 32 m, then the potential energy is: