Question

The switch in the circuit seen in fig. p7.52 has been in position a for a long time. At t=0, the switch moves instantaneously to the position b. For t >= 0+, find i0(t).

7.52 The switch in the circuit seen in Fig. P7.52 has been
PSPICE in position a for a long time. At t0, the switch
MULTISIM moves instantaneously to position b. For 0,
find
a) vo(t).
b) io1).
Figure P7.52
10 kΩ
40 nF
10()
40 kΩ
10 k()
75 V
Expand
Transcribed Image Text

7.52 The switch in the circuit seen in Fig. P7.52 has been PSPICE in position a for a long time. At t0, the switch MULTISIM moves instantaneously to position b. For 0, find a) vo(t). b) io1). Figure P7.52 10 kΩ 40 nF 10() 40 kΩ 10 k() 75 V

Expert Answer

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Electrical Engineering

Related Electrical Engineering Q&A

Find answers to questions asked by students like you.

Q: Convert the following numbers to scientific notation.Following these Question and answer.29) 5000 KΩ...

A: We need to convert the numbers given below into scientific notations.

Q: The three conductors A, B and C of a 3-φ line are arranged in a horizontal plane with DAB = 2 m and ...

A: The conductors of 3 phase line are arranged in horizontal plane.

Q: 8- In the following circuit find i() 2Ω 0

A: From the circuit, write the expression for io(t) as follows:

Q: 6- In the following circuit find io (t) t-0 3 A i, (t)

A: Figure 1 shows the modified circuit when t < 0.

Q: A single phase overhead transmission line delivers 4000 kW at 11 kV at 0·8 p.f. lagging. If resistan...

A: The equivalent circuit diagram is as follows:

Q: Feedback Control of Dynamic Systems (7th edition) - Problem 7.18

A: (a). Numerator part of the gain:b(s) = b1sn-1 + b2sn-2 + …………+ bn…………………… (1)Denominator part of the...

Q: How would I sketch the input-output relationship of op-amp comparators with hysteresis?

A: Consider an inverting Op-Amp comparator circuit as shown in Figure 1.

Q: 4. Find the current I assuming ideal diod es 1.2k2 10V (+ 15%4 12V+ 3V

A: The given is redrawn as shown in Figure 1.

Q: In the following circuit, use two different methods (Nodal Analysis, Mesh Analysis, or using Theveni...

A: Let us find the Nortons's Current (Isc) :

Q: Feedback Control of Dynamic Systems (7th edition) - Problem 7.19

A: Click to see the answer

Q: s) We noded 0holgss to Solve the aitteisb end nd uR loop Umobtis to Solue the wrts ond find

A: a) Nodal Analysis:Let V1 is the node voltage at node. 

Q: 2. Assuming ideal diode models, find status of diodes Di and D2 (on or off) D2 + 15V 10% +

A: First, assume both diodes are on,

Q: Electrical Engineering Question

A: Part (A):Given data,

Q: A single phase transmission line has two parallel conductors 1·5 metres apart, the diameter of each ...

A: Given,The spacing between the two parallel conductors is,

Q: How was the value of the capacitor derived?

A: Click to see the answer

Q: 12- Find i(t) and v(t) in the following circuit. You may employ any method you wish. 24"φ

A: When t < 0, the inductor acts as a short circuit.So, at time t=0, we will get :

Q: Attempt five questions only Q1.) a) Derive the basic S.I units, then write the basic dimensions for ...

A: Hii there!! Since there are two different questions in the image, I will be solving the first one. I...

Q: A single phase 11 kV line with a length of 15 km is to transmit 500 kVA. The inductive reactance of ...

A: Given,The length is 15 km.The inductive reactance is,

Q: You are given that the system shown in Figure 4.25 has a 110/220 kV autotransformer. The positive- a...

A: Since there is single line to ground fault in phase a. So, fault current in phase a will be IF and f...

Q: Figure 3.60 For Prob. 3.11. 3.12 Using nodal analysis, determine V, in the circuit in Fig. 3.61. 40 ...

A: Nodal analysis depends primarity on the application of Kirchoff's Voltage Law (KVL). The circuit men...

Q: Find the charge q(t) flowing through an device if the current is:(c) i(t)= 20 cos(10t + π/6)10^-6A, ...

A: Charge is defined as integral of current over a certain interval of time. The mathematical expressio...

Q: I am having trouble with a Differential Amplifier problem that I attached a photo of. I must "Design...

A: For a single input single output BJT amplifier for the gain of +150 we have to make some changes in ...

Q: e foll a Onny uruut hind 34%

A: Part (a): Refer to Figure as shown in the part (a) of the given question.According to the Maximum po...

Q: 1. Assuming ideal diode models, find status of diodes D1 and D2 (on or off) D2 Di +12 29

A: In ideal case, all forward biased diodes are in on state, and all reverse biased diodes are in off s...

Q: At which times will Q be high? clk A) T1, T2, T3, T4 B) T2, T5 C)ll times C) D) T1 , T3, T4 Ti T23T4...

A: 1) JK flip flop truth table is given as:JKQ+00Q(no change)01010111Q’

Q: A short 3-φ transmission line with an impedance of (5 + j 20) Ω per phase has sending end and receiv...

A: The resistance and reactance of each conductors are,

Q: 2 A 8Ω 4Ω 12 V 6Ω 6Ω HI- Figure 3.46 For Review Questions 3.1 and 3.2. 3.2 In the circuit of Fig. 3....

A: The purely resistive circuit provided in the question can be solved by applying Kirchoff's Voltage L...

Q: Problem 2 question 2

A: In this problem, It is said that the value of R1, R2 and C should be physically realistic value such...

Q: In the following circuit, use either differential equation approach or the step by step method to fi...

A: Figure 1 shows the modified circuit when t < 0.

Q: A substation receives 6000 kVA at 6 kV, 0.8 p.f. lagging on low voltage side of a transformer from a...

A: The single line diagram of the system is shown below:

Q: imu omplete SY%

A: Part (a): Refer to Figure as shown in the part (a) of the given question.According to the Maximum po...

Q: A (medium) single phase transmission line 100 km long has the following constants: Resistance/km/pha...

A: As per the norms, we answer three parts of a question. Since your question contains four parts, we s...

Q: Feedback Control of Dynamic Systems (7th edition) - Problem 7.39

A: Hi there!! Since there are four parts in the question, I will be answering only the first two parts....

Q: Nt

A: To find the thevenin resistance or equivalent resistance:Thevenin resistance is determined by open  ...

Q: Finel)inefollo Can ollomh -0 et 2v2 ols) Lo

A: When t < 0, the switch is open and there is no independent source connected to the circuit.So, at...

Q: help me with ques 8A

A: Consider the four inputs namely A, B, C, and D and its respective outputs are mentioned as X1, X2, X...

Q: In the following circuit, use either differential equation approach or the step by step method to fi...

A: Figure 1 shows the modified circuit when t < 0.

Q: uunection current 0.5mA is to be used. 02: a) Derive the equations of balance for Hay bridge to dete...

A: Hay bridge is a modified version of Maxwell\'s bridge and the circuit diagram is given below 

Q: I got parts a & b right. I just need a clarification how the author got the answer to part c 72....

A: From Part (a), the lower cutoff frequency (fL) is 34.412 Hz.

Q: what will be the output of the following meters, if the input signal is the waveform show in fig

A: The output reading of each meter should be determined.

Q: a the following circuit find i,o 1-0 t= る(t) 1н =0 ЗА

A: We first find the initial and final values. Let us say that the voltage across the capacitor is v(t)...

Q: 2Ω 4Ω 1H3%(t)に0 - 2A

A: When t < 0, the inductor acts as a short circuit. Let us say that current through the inductor is...

Q: For the circuit below, use superposition to find i. Calculate the power delivered to the 3-Ω resisto...

A: According to superposition theorem, the total current across any element due to all the sources is e...

Q: Use linearity and the assumption that Vo = 1 V to find the actual value of Vo in the following circu...

A: A linear circuit is one whose output is linearly related or in other words which is directly proport...

Q: A short 3-phase transmission line connected to a 33kV, 50 Hz generating station at the sending end i...

A: It is given that:

Q: In the following circuit, use either differential equation approach or the step by step method to fi...

A: STEP BY STEP METHOD:From the given circuit, the switch opens at t =0. That is, switch is in closed c...

Q: The one-line diagram of a three-phase power system is as shown in the figure attached. Impedances ar...

A: The load at bus is S2=15.93 MW-j33.4 MvarFirst converting all the values in per-unit systemThe load ...

Q: CompressionLet’s take a look at compression.Take the file Fig 05-15 which can be found on the author...

A: 1. Right click on file and go to properties to get  the type of file format.Answer: a) Chapter 5.doc...

Q: Find the Thevenin's equivalent of the following circuit looking through ab. 2Ω 2Ω 2 A

A: To find the Thevenin voltage across the terminals a-b.The given circuit is redrawn as shown in Figur...

Q: How would I sketch the output waveform and calculate the frequency of a op-amp / signal generator?

A: Operational amplifier is a device which is linear and is capable of ideal DC amplification and is th...