8- A permeable soil layer is underlain by an impervious layer, as shown in Figure7.28. With k= 5.2 104 cm/sec for the permeable layer, calculate the rate of seepage through it in m³/hr/m length if H= 3.8 m and a 80, WERWERNER Groundwater table (free surface) Impervious layer Ground surface Direction of seepage

8- A permeable soil layer is underlain by an impervious layer, as shown in Figure7.28. With k= 5.2 104 cm/sec for the permeable layer, calculate the rate of seepage through it in m³/hr/m length if H= 3.8 m and a 80, WERWERNER Groundwater table (free surface) Impervious layer Ground surface Direction of seepage

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter7: Permeability

Section: Chapter Questions

Problem 7.2P

See similar textbooks

Similar questions

A permeable soil layer is underlain by an impervious layer, as shown in Figure 6.13. With k = 5.2 × 10–4 cm/s for the permeable layer, calculate the rate of seepage through it in m3 /hr/m length. Given: H = 3.8 m and α = 8°.
11. A channel runs almost parallel to a river as shown in the figure. The water level in the river has an elevation of 36 m. and the elevation of the channel is 33 m. The river and channel are 600 m apart and a previous formation of the average thickness of 9 m and hydraulic conductivity of 0.80 m/hr joints them together. Compute the hydraulic gradient Compute the rate of seepage flow from the river to the channel per meter width in liters per day. If the seepage velocity is 0.048 m/day, compute the void ratio of the previous medium.
A permeable soil layer that is underlain by an impervious layer slope at 5 degrees to the horizontal and is 4m thick measured vertically. If the coefficient of permeability of the permeable layer k=0.005 cm/sec, determine the rate of seepage per meter width of permeable layer in liters per hour.
3.1 A soil mass in its natural state is partially saturated having a water content of 17.5 % an d avoid ratio of 0.87 . Determine the degree of saturation , total unit weight, and dry unit weight. What is the weight of water required to saturate a mass of 10 cubic meter volume? Assume Gs = 2.69
A layer of silty soil of thickness 5 m lies below the ground surface at a particular site and below the silt layer lies a clay stratum. The ground water table is at a depth of 4 m below the ground surface.The following data are available for both the silt and clay layers of soil.Silt layer: ?10 = 0.018 mm, e = 0.7, and Gs = 2.7Clay layer: e = 0.8 and Gs = 2.75Required: (a) Height of capillary rise, (b) capillary pressure, (c) the effective pressure at the ground surface, at groundwater table (GWT) level, at the bottom of the silt layer and at a depth of H =6 m below ground level, and (d) at a depth 2 m below ground level. (Sketch or draw the stress distribution diagram).
A permeable soil layer is underlain by an impervious layer as shown below. Knowing that k = 6 x 10 -3 cm/sec for the permeable layer. Given H = 5.4 m, calculate the rate of seepage through this layer in m 3 /hr. if: α = 5 o α = 7 o α = 9 o α = 12 o Draw a chart α vs. q (i.e. α on the x-axis, and q on the y-axis) and discuss how the slope angle (α) impact the flow rate and explain the reason for such behavior.
A permeable soil layer is underlain by an imprevious layer. With k= 5.5x10^-4 cm/s for the permeable layer, calculate the rate of seepage through it in m^3/hr/length. Given: H = 4.2 m and a = 7 degrees.
The SQUARE base permeameter (seen from above), has three soil layers arranged vertically as shown in the image. L is: 70cm, the difference of head h is: 105 cm. The coefficient of permeability of soil 1 K1 is 0.065 cm/sec, soil 2 K2 is 0.0030 cm/sec and soil 3 K3 is the 0.0095 Calculate the amount of water collected in a time of 10 minutes.
Seepage around a retaining wall is shown in the figure below. The hydraulic conductivity of the sand is 1.8 x 10-5 cm/s. The retaining wall is 20 m long. Determine the quantity of seepage across the entire wall per day
An aquifer slopes away from a river, as shown in Fig. 3-7 The hydraulic conductivity of the aquifer which is 20 ft thick is known to be 0.2 ft/day. The water is 20 ft deep in the river, and the bottom of the trench is 30 ft below the bottom of the river and 600 ft away from the edge of the river. The trench is 40 ft deep. Will water flow out of the trench without pumping? If so, what will be the rate of flow?
1. How many millimetres (equivalent depth) of water are contained in a soil profile 1 metre deep if the mass water content of the upper 400 mm depth is 15% and that of the lower 600 mm is 20%. The bulk density in the upper layer is 1300 kg m-3 and in the lower layer is 1500 kg m-3. Assume ρw = 1000 kg m-3.How much water does the soil contain (in cubic metres) per 1.5 hectares of land?
9. From the figure shown: (See picture below) Cross-sectional area = 0.6m2 Hydraulic Conductivity of sand = 0.1 cm/sec What is the rate of upward seepage of water? (Answer: 360 cm3/sec) What would be the critical hydraulic gradient? (Answer: 1.12 m) What value of h to cause boiling? (Answer: 2.8 m)