8. (a) An angle modulated signal with carrierfrequency w. = 2n x 10° rad/sec is givenas follow :OpM () = 10cos (w̟t +5sin(3000t) +10sin (2000t)}:(i) Find power of modulated signal.fii) Find the maximum frequencydeviation.(iii) Finddeviation. ..maximum phase(iv) Estimate the bandwidth of FMsignal.

The solution can be achieved as follows.

8. (a) An angle modulated signal with carrier frequency w. = 2a x10° rad/sec is given as follow : OrM () = 10 cos (w.t + 5sin(3000t) + 10sin (2000t)) (i) Find power of modulated signal. (ii) Find the maximum deviation: frequency (iii) Find the maximum phase deviation. (iv) Estimate the bandwidth of FM signal.

8. (a) An angle modulated signal with carrier frequency w. = 2a x10° rad/sec is given as follow : OrM () = 10 cos (w.t + 5sin(3000t) + 10sin (2000t)) (i) Find power of modulated signal. (ii) Find the maximum deviation: frequency (iii) Find the maximum phase deviation. (iv) Estimate the bandwidth of FM signal.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

What is the voltage gain (Av) of the circuit when β = 100, r0 = 40 kΩ, RB = 360 kΩ, RC = 3.3 kΩ, RE = 220 Ω, Rs = 15 kΩ and RL = 248 kω in the circuit given in the figure?Note-1: the output impedance of the transistor r0 will be taken into account in calculations.Note-2: capacitors are negligible at midband frequency.
fi(t) is instantaneous frequency. a) Find fc, fm, kf, β ? b)Write the basic euqation of modulated FM signal?
For an Armstrong indirect FM transmitter with the crystal carrier oscillating at 210 kHz, the crystal reference oscillating at 10.2 MHz, the sideband voltage is 0.018 V, the carrier input voltage to the combiner is 5V, the first and second multipliers are both 40, and the modulating signal frequency is 2 kHz, determine: a.) modulation index at the output of the combining network and the power amplifier; b.) frequency deviation at the same two points; and c.) the transmit carrier frequency.
Consider a modulating signal of 20khz that is applied to an FM modulator, whose modulation index (β) is a value of 4, then the real bandwidth will be:
What are the relative amplitudes of the fourth pair of sidebands for an FM signal with a deviation ratio of 8?
An FM modulator has kf=30kHz/V and operates at a carrier frequency of 180 MHza. Find the output frequency for an instantaneous value of the modulating signal equal to150mV. b. If the carrier signal is modulated by a 2Vrms sine wave. Calculate the peak frequencydeviation. c. Using the given in the previous number, also find the bandwidth using the Bessel table below for thePM signal when the message frequency is (a) doubled, (b) halved, but all else remains constant.
What are the advantages and disadvantages of single-sideband transmission? Briefly describe each.
-MCQ- FM modulator is used to transmit a cosine message signal with 4V amplitude and 20Hz frequency. The frequency deviation constant kf = 25 Hz/V, the carrier is a cosine sign with an amplitude of 10V and a frequency of 2000Hz. The FM modulated signal is passed through a bandpass filter and 90% of the power of the modulated signal remains. What is the bandwidth of the FM modulated signal in this case? a) 240hz b) 20hz c) 100hz d)200hz
For a mosfet amplifier circuit, how can I choose an input and output capacitor with poles at 10Hz and 100Hz? Where RC = 1/w.
An FM modulator has kf=30kHz/V and operates at a carrier frequency of 180 MHza. Find the output frequency for an instantaneous value of the modulating signal equal to150mV. b. If the carrier signal is modulated by a 2Vrms sine wave. Calculate the peak frequencydeviation.
The modulating signal that is the input into an FM modulator is m(t)=2cos(10??).a) Express the time domain expression of ?(?) signal.b) Express FM signal in terms of Bessel functions.c) Sketch the frequency spectrum of the modulated signal.d) Determine the bandwidth of ?(?) occupies 98% of the total power (Carson Rule) in the acquired spectrum.e) Determine the condition of required bandwidth of ideal BPF if at least 80% of the total power appears at the output of the filter?
Given the following CA configurations:A) CA_42AB) CA_4A_6BQuestions:1) Identify the CA type, duplex type, theoretical maximum bandwidth, and maximum numberof CCs for each CA configuration.2) If the CA_4A_6B has maximum bandwidth of 30 MHz, what are possible frequencyassignments for this CA configuration?