A carrier wave is frequency modulated using a sinusoidal signal of frequency wm = 2n rad/s and an amplitude am. Increasing am from 0 Volts, it is found that the carrier component of the FM signal is reduced to zero for the first time when am = 2 volts. a. What is the frequency sensitivity of the modulator? b. Fixing k, for the same value obtained earlier, what is the value of which the carrier component is reduced to zero for the second time? аm for

A carrier wave is frequency modulated using a sinusoidal signal of frequency wm = 2n rad/s and an amplitude am. Increasing am from 0 Volts, it is found that the carrier component of the FM signal is reduced to zero for the first time when am = 2 volts. a. What is the frequency sensitivity of the modulator? b. Fixing k, for the same value obtained earlier, what is the value of which the carrier component is reduced to zero for the second time? аm for

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The modulating signal that is the input into an FM modulator is m(t)=2cos(10??).a) Express the time domain expression of ?(?) signal.b) Express FM signal in terms of Bessel functions.c) Sketch the frequency spectrum of the modulated signal.d) Determine the bandwidth of ?(?) occupies 98% of the total power (Carson Rule) in the acquired spectrum.e) Determine the condition of required bandwidth of ideal BPF if at least 80% of the total power appears at the output of the filter?
For an Armstrong indirect FM transmitter with the crystal carrier oscillating at 210 kHz, the crystal reference oscillating at 10.2 MHz, the sideband voltage is 0.018 V, the carrier input voltage to the combiner is 5V, the first and second multipliers are both 40, and the modulating signal frequency is 2 kHz, determine: a.) modulation index at the output of the combining network and the power amplifier; b.) frequency deviation at the same two points; and c.) the transmit carrier frequency.
Given the following FM modulator, if the modulating signal m(t) is given below:(a) Sketch the input message signal m(t).(b) Determine the FM modulated output signal yFM(t) for 0 ≤ t < 3. Given that the frequency sensitivitykf and the carrier frequency fc of the FM modulator are 5Hz/volt and 20Hz respectively.(c) What is the maximum frequency deviation (change of the carrier frequency) of the modulator?
Calculate the frequency deviation and the carrier swing of a frequency- modulated wave which was produced by modulating a 50.4 MHz carrier. The highest frequency reached by the FM wave is 50.415 MHz. Then calculate the lowest frequency reached by the FM wave. If the frequency of the modulating signal is 5 KHz, what is the bandwidth of the FM wave?
2 (AM) A 10 V amplitude sinusoidal signal is used as a modulating signal to generate an AM signal with modulation index 0.8. What is the amplitude of the carrier? What is the power of the side bands? What is the efficiency of the modulated signal?
fi(t) is instantaneous frequency. a) Find fc, fm, kf, β ? b)Write the basic euqation of modulated FM signal?
For an FM modulator with a modulation index mf = 1, a modulating signalVm(t) = Vm sin(2π1000t) and unmodulated carrier Vc(t) = 10 sin(2π500kt),determinea) Number of sets of significant sidebandb) Their amplitudec) Then draw the frequency spectrum showing their relative amplitudesd) Determine the unmodulated carrier power for the FM modulator(assume a load resistance RL = 50 Ω)e) Determine the power in the modulated carrier and each side frequency,and sketch the power spectrum for the modulated wave.
(a) Determine the frequency deviation ∆f and the carrier swing for an FMsignal with a carrier frequency of 100 MHz and whose upper frequency swing is100.007 MHz when modulated by signal m(t).(b) Find the lowest frequency swing experienced by this FM signal.
Problem1 A baseband signal with frequency components from near dc to 15 kHz frequency modulates a 200-kHz carrier, andthe frequency deviation is ±3 kHz. The signal is applied as the input to a cascade of two frequency triplers and onefrequency doubler. Determine the output (a) center frequency, (b) frequency deviation, and (c) deviation ratio (d) A VCO has an unmodulated carrier frequency of 100 MHz and sensitivity of −12 kHz#V. Determine thefrequency when the input signal is set at 5 V.
amplitude value of output voltage (Vout) = ?? Note1 : E-MOSFET output empedance rd= 70kΩ Note2: capacitors are of negligible size at midband frequency Note3 : 5kHz in midband frequency
5. The following data is available: fc= carrier frequency = 750kHz, Ac= maximum amplitude of the unmodulated carrier = 10V fm= modulator frequency = 300Hz-8kHz modulation index m=0.5 a) What is the frequency of the upper sideband? b) What is the frequency of the lower sideband? c) What is the amplitude of the modulating signal? d) What is the maximum amplitude of the envelope of the modulated signal? e) What is the minimum amplitude of the envelope of the modulated signal? f) What is the bandwidth of the modulated wave? g) Write an expression for the modulated wave
The SNRi of an FM transmitter is determined to be 24.093dBV. Solve for the peak frequency deviation caused by the noise if the transmitter sensitivity is determined to be 368.903Hz/V, and a modulating signal of 13.926V and the modulating index is kept at 4