8.49PSPICEMULTISIM72 V50 Ωa100 nFzb 5 knt=0+Va75 ΚΩ2.5 HThe circuit shown in Fig. P8.49 has been in operation for a long time. At t = 0,the source voltage suddenly increases to 250 V. Find v(t) for t ≥ 0.

In this question we need to find the voltage Vo(t) for t>0 . At t= 0 switch at position b and…

Answered: 8.49 PSPICE MULTISIM 72 V 50 Ω www 100…

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

For the two-source circuit of Fig. 8.89, note that one source is always on. (a) Obtain an expression for i(t) valid for all t; (b) determine at what time the energy stored in the inductor reaches 99 percent of its maximum value.
For the circuit below with the switch closed and then opening at t=0, and R1= 3Ω, R2= 7Ω, C = 0.2H, ig = 8A, vs = 2v, calculate the initial condition. Develop the differential equation for the solution for t > 0. Calculate the current ia(t) for all times.
A series RLC circuit has an inductor that has a value 500 mH, the capacitor 25 µF, and the resistor has a value of 400 Ω. They are connected to an ac power supply functioning at frequency 60 Hz. The peak current is 450 mA a) Find Vmax b) Find the angle by which the current leads, or lags, the voltage. Using your result is it leading or lagging? c) How much power is the circuit dissipating on average?
a) For the circuit shown, what value of Rx would make the circuit critically damped? b) For the circuit shown, what would be the the resistance for a damped natural frequency of wd= 8k rad/s
For the circuit shown in Fig 8, find i, vc, and iL, as well as the energy accumulated in the capacitor and inductor.
Design an RLC circuit with 6 uH inductance and 1 uF capacitance. Calculate the minimum value of resistance (R) for the circuit to be damped? What is the oscillation frequency of the circuit if R=1 ohms?
The switch in the circuit of Fig. 8.91, often called a make-before-break switch (since during switching it briefly makes contact to both parts of the circuit to ensure a smooth electrical transition), moves to position b at t = 0 only after being in position a long enough to ensure all initial transients arising from turning on the sources have long since decayed. (a) Determine the power dissipated by the 5 - resistor at t = 0−. (b) Determine the power dissipated in the 3 - resistor at t = 2 ms.
The switch in Fig. 8.73 is moved from A to B at t = 0 after being at A for along time. This places the two capacitors in series, thus allowing equal andopposite dc voltages to be trapped on the capacitors. (a) Determine v1(0−),v2(0−), and vR(0−). (b) Find v1(0+), v2(0+), and vR(0+). (c) Determine thetime constant of vR(t). (d) Find vR(t), t > 0. (e) Find i(t). ( f ) Find v1(t) andv2(t) from i(t) and the initial values. (g) Show that the stored energy at t = ∞plus the total energy dissipated in the 20 k-resistor is equal to the energystored in the capacitors at t = 0.
Calculate the magnitude of current in the capacitor shown in Fig. P8.6 if the voltage input is v1(t) = 10cos(381t-58) V
The resistance, inductance and capacitance in a parallel RLC circuit are 1500 ohms, 400mH and 10nF, respectively a. Calculate the roots of the characteristic equation that describe the voltage response of the circuit b. Will the response be over, under or critically damped? c. What value of C will yield a damped frequency of 15 krad/s? d. What are the roots of the characteristic equation for the value of C found in (c)? e. What value of C will result in a critically damped response?
The switch in Fig. 8.73 is moved from A to B at t = 0 after being at A for a long time. This places the two capacitors in series, thus allowing equal and opposite de voltages to be trapped on the capacitors (d) Find vr(t), t > 0. (e) Find i(t). (f) Find vi(t) and v2(t) from i(t) and the initial values. (g) Show that the stored energy at i = 0 plus the total energy dissipated in the 20 kS2 resistor is equal to the energy stored in the capacitors at t = 0
A series RLC circuit has R=10ohms, C=10^-2 farad, L = 0.5 Henry, and an applied voltage V =15 Volts. Assume that no initial current and no initial charge at t=0 when the voltage is first applied, find the subsequent current in the circuit. Show complete solution.

SEE MORE QUESTIONS

Recommended textbooks for you

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Fundamentals of Electric Circuits

Electrical Engineering

ISBN:

9780078028229

Author:

Charles K Alexander, Matthew Sadiku

Publisher:

McGraw-Hill Education

Electric Circuits. (11th Edition)

Electrical Engineering

ISBN:

9780134746968

Author:

James W. Nilsson, Susan Riedel

Publisher:

PEARSON

Engineering Electromagnetics

Electrical Engineering

ISBN:

9780078028151

Author:

Hayt, William H. (william Hart), Jr, BUCK, John A.

Publisher:

Mcgraw-hill Education,

SEE MORE TEXTBOOKS

8.49 PSPICE MULTISIM 72 V 50 Ω www 100 nF b t=0 5 ΚΩ www + Va 75 ΚΩ 2.5 H The circuit shown in Fig. P8.49 has been in operation for a long time. At t = 0, the source voltage suddenly increases to 250 V. Find v(t) for t ≥ 0.