Question 2 When the message frequency in an FM system is 500Hz and the peak message voltage is 2.5 v, then the deviation ratio is 65. Calculate the maximum frequency deviation. What is the deviation ratio when the message frequency is reduced to 300 Hz and the peak message voltage raised to 3.5 v simultaneously?

Question 2 When the message frequency in an FM system is 500Hz and the peak message voltage is 2.5 v, then the deviation ratio is 65. Calculate the maximum frequency deviation. What is the deviation ratio when the message frequency is reduced to 300 Hz and the peak message voltage raised to 3.5 v simultaneously?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Explain modulation on your own word regarding the following aspect: (No copy paste. I willcheck the plagiarism)a. Interferenceb. Noisec. Height of antenna
Twelve (12) signals each band-limited to 5 kHz are to be transmitted over a single channel by frequency division multiplexing. If AM-SSNB modulation guard band of 1 kHz I used, determine the bandwidth of the multiplexed signal.
24. Modifying the frequency of the carrier produces frequency modulation.Group of answer choices True False 25. FM produced by a phase modulator is called indirect FM.Group of answer choices True False 26. The modulating signal for stereophonic subcarrier shall be equal to the sum of the left and right signals.Group of answer choices True False 27. The amplitude of the modulating signal determines the frequency deviation in the carrier.Group of answer choices True False
10 kHz, 300 MHz, 4-15kHz 30kHz, 300MHz, Off-5kHz f30kHz, 300 MHz, 4/15kHz 10 kHz, -100 MHz, 4/SkHz Choice aoption fm2= ?
solve a and b please. a.How FM signal is demodulated using band pass limiter, explain with the help of mathematical equations. b.Define instantaneous frequency, how the instantaneous frequency is important in frequency modulation and phase modulation, explain with the help of mathematical equations.
The maximum deviation of an FM carrier with a 2.5-kHz signal is 4 kHz. What is the deviation ratio?
Determine which of the following statements is true or false, and correct the wrong? Modulation process is done in the transmitter side in a communication system.
Draw the whole block diagram of a digital satelite comunication system which uses QPSK modulation technique. In this system the satelite is a transparent relay, linking a ground transmiter to a ground receiver.
Type your question here The figure below shows a satellite receiver uses two hytrodyne operations. It is used to receive transmissions at 136 ???. the first local oscillator operates below the incoming carrier frequency, while the second operates above the first IF frequency. Find all possible image frequencies.
A transmitter operates on a frequency of 825 MHz. The maximum FM deviation is +/- 10kHz. What is the maximum and minimum frequencies that occur during modulation? What is the deviation ratio if the transmitter only had a maximum deviation of 50 kHz and a maximum modulation frequency of 40 kHz?
What happens when fs < 2 fm?
Select the following correct answers about Multiplexing.a) Cable companies use Frequency Division Multiplexing to provide television channels to subscribers b) Satelite companies use Frequency Division Multiplexing to separate channels used c) TDM is used by cable companies to provide tv channels to subscribers d) Telephone companies use frequency division multiplexing to bundled many calls on a single telephone line.