9) A and B can form ideal solution, at certain temperature, if pi> Pa, which of following ex pression is correct? (a) y,>x4 (b) y, = x4 (c) y,

Q: Calculate the Z and V for ethane at 50 °C and 15 bar by the following equations: a. Truncated virial...

A: We need to find  Z and V for ethane at 50 °C and 15 bar  using the following equations : (a) Truncat...

Q: 2.14 Consider the following nuclear symbols. How many pro- tons, neutrons, and electrons does each e...

A:

Q: When a force acting on a body displaces it in direction of force then WORK IS DONE. *

A: When a force acting on a body displaces it in a direction of force , then the work done is MAXIMUM.

Q: Two large beakers are connected with a straight horizontal pipe, 2 cm in diameter and 12 cm long. Th...

A: Write the expression or the diffusivity of organic components in water as follows: DAB = 1.173×10-16...

Q: d) The following equation relates the moving mass (m) to the resting mass (m) of a particle in terms...

A:  

Q: the advantages of using Cyclic Olefin Copolymer (COC) as sustainable syringes in medince

A: Asked; Advantages of using Cyclic Olefin Copolymer (COC) as sustainable syringes in medicine are as ...

Q: 4. The burning of pure butane with excess air gives a stack gas which analyses 11.55 % CO2 on a dry ...

A: The excess percent of air and excess percent of oxygen are the same for a reaction. This is obtained...

Q: Q2. Air in a piston that undergoes two processes. First the air is at 100 kPa with a specific volume...

A:

Q: 1. A 7-meter-long steel pipe was installed by a man during a cold whether at 20°C. What would be the...

A:

Q: 4. A buffer is prepared containing 1.00 M acetic acid and 1.00 M sodium acetate. What is its pH?

A: Given that for a buffer solution, Concentration of acetic acid [CH3COOH] =1.00 M Concentration of so...

Q: Q/ A body of mass 5kg falls from a height of 500 cm above the ground. Find Potential energy stored i...

A: Given that, Mass of the body m = 5 kg Height h = 500 cm = 5 m g = 10 m/s2 It is required to calculat...

Q: Discuss how the urban, regional, and global scale of different air pollutant problem influences chem...

A:

Q: The reaction A > B is to be carried out isothermally in a continuous-flow reactor. The entering volu...

A: Note: We are authorized to answer one question at a time, since you have not mentioned which questio...

Q: 2A9CI + Na2SO4 · Ag2SO4 + 2NaCl (MW Ag = 108, Cl = 35.45, Na = 23, S= 32 and O = 16) Answer the Foll...

A: Given that there is a given reaction we have to find stoichiometric coefficient of AgCl

Q: The top tray of a distillation column and the condenser are at a pressure of 20(psia). The liquid on...

A: Assume the temperature at first and the values of K in the liquid mixture are considered. This gives...

Q: For each of the following scenario, determine which material is best suited for? ceramics composite ...

A: Ceramics are compounds lies between metallic and nonmetallic elements. their interatomic bonds are e...

Q: Subcooled or compressed liquid is the phase of water when it is NOT CLOSE to vaporizing.

A: Given data: Subcooled or compressed liquid. (water)

Q: Determine the transition length from the entrance of a 30 mm pipe for the following liquids: From p...

A: Given that : Diameter  =30 mm V = 3.2 m/s

Q: A sieve analysis test was performed on a sample of coarse aggregate and produced the following resul...

A: Given that : there is different sieve size is given and its amount retained is also given for its si...

Q: 100 mol of 0xygen is mixed with 300 mol 0f nitrogen at SATP (T = 298.15 K, P = 105 Pa). Calculate th...

A: Given that- At SATP conditions, T= 298.15 K P= 105 Pa Mol of oxygen, nO2 = 100 mol Mol of nitrogen, ...

Q: 10) Few sucrose dissolves into water to form dilute solution, which of following statement is correc...

A: Introduction Colligative properties are those properties of solutions that depend on the ratio of th...

Q: 4s L-1 4s2+ O sin cos를 + sin를 O cos 2t + sin 2t O cos COS

A:

Q: An OPEN SYSTEM is one in which both the heat and work as well as mass of the working substance cross...

A: Given data: Open system

Q: The derivative dT P is tedious to calculate by implicit differentiation of an equation of state such...

A: Write the Peng-Robinson equation of state as follows: P = RTV-b -aαVV+b+bV-bP = RTVV+b+bV-b-aαV-bVV2...

Q: 3. How much heat is required to rise the temperature of 0.5 kg water from 30°C to its boiling point?...

A: Given m=0.5 kg Specific heat=4186 J/kg-k T2=1000C T1=300 C

Q: Nitrogen at 150°C and 170 kPa with a volume of 1.7 mở is compressed using an isothermal process unti...

A:

Q: The PV DIAGRAM is also the phase diagram.

A: Given data: Information about PV DIAGRAM

Q: Two identical 7.5-cm cubes of copper at 425 and 90°C are brought into contact. Assuming that the blo...

A:

Q: 1. Based on the figure below: ng(mol) 0.983 DA 0.017 W(V) 100 mol 10.983 DA 10.017 W(v) n;(mol) nz(m...

A: Given : mole fraction of feed(XF)=0.04  mole fraction of mixture of feed and Recycle (XM)=0.023 mole...

Q: Part E Very small semiconductor crystals composed of approximately 1000 to 100,000 atoms, are called...

A: To answer E. if we wanted to make one 6.5 nm dot from multiple 2.5 nm dots , how many 2.5 nm dots wo...

Q: If a system after undergoing a series of processes, then returns to the initial state then the sum o...

A: Given Data: Application of first law of thermodynamics.

Q: f A at location 2 with respect

A:

Q: For example, consider the following labeled flowchart for a simple chemical process based on the rea...

A: A recycle stream is introduced in the system to reuse and recover the unreacted reactants. In this, ...

Q: 1. Saturated liquid feed of F = 40 mol/hr, containing 50 mol% A(1)/B(2), is supplied to the apparatu...

A: Given data: Molar flow rate of feed = 40 mol/h Composition of feed is, A = 0.5 B = 0.5 Reflux ratio ...

Q: A saturated solution containing 1500 kg of potassium chloride at 360 K is cooled in an open tank to ...

A:

Q: . Two incompressible viscous fluids of the same density p flow, one on top of the other, down an inc...

A:

Q: The effects on polymer addition to the mixture of colloidal particles has been widely reported. With...

A:

Q: Part II: Calculate the following two quantities for 5.00 mol of an ideal gas with Cv.m = 5/2 R that ...

A: The measure of disorder in a thermodynamic system is given by entropy. CHange in entropy happens in ...

Q: Give the formula for each of the following ionic com- pounds: (a) ammonium carbonate, (b) calcium io...

A:

Q: A mixture of 1-L containing water at room temperature and 100,000,000 little solid spherical beads (...

A: The particle settling in a fluid at constant temperature is called settling velocity. The particle i...

Q: The density of a fluid that is flowing in a steady state manner inside a pipe is constant at 68.7 Ib...

A: Given Density of fluid=68.7 lbm/ft3 Fluid is flowing in a pipe which undergoes gradual expansion D1...

Q: True or False

A: Ans 1- True  2-  False ( because cooling and chilling rate are governed by any of form it can be con...

Q: A small reaction bomb fitted with a sensitive pressure-measuring device is flushed out and then fill...

A: Given data: Pressure and time data for a reaction is given.

Q: a) Ethanol (C2H:OH) melts at -114°C and boils at 78 °C. The enthalpy of fusion of ethanol is 5.02 kJ...

A: Given, Mass of ethanol =42g

Q: Considering the same substance, heat for temperature change and phase change are categorically THE S...

A: for any substance, the heat required for temperature change is  when it comes in contact with hotter...

Q: Calculate the Gibbs free energy of fusion (melting) for water [in J/mol] at T = 0°C at 15.0 bar noti...

A: Given physical conditions of  T = 0°C and P= 15 bar Gibb's free energy at 1 bar=0 density of liquid ...

Q: How to get pKa and concentration ratio of protein in solution?

A: To determine pKa pH=−log[H+] pOH=−log[OH−] pKa=−log[Ka] pKa =pH+pOH The pKa is the negative logarith...

Q: Water at 2.2048 MPa and 500 °C (state 1) is heated at constant pressure in a piston/cylinder arrange...

A: Given: Water at 2.2048 MPa and 500 °C (state 1) is heated at constant pressure in a piston/cylinder ...

Q: Determine the volume change in m3 when 4 kg of saturated water is completely vaporized at a pressure...

A: Given that m =4 kgP =140 KPa

Q: The reaction A → B is to be carried out isothermally in a continuous-flow reactor. The entering volu...

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part ...