9. A nutrition company has produced a tablet that can be dissolved in water and consumed during exercise to replace the electrolytes lost from sweating. Each tablet weighs 5.400 grams and contains the following amounts of each electrolyte: Electrolyte Amount per tablet (mg) Sodium (as sodium carbonate) 300 Potassium (as potassium bicarbonate) 150 Calcium (as calcium carbonate) 40 Magnesium (as magnesium oxide) 25 Calculate the wt% of each metal in the tablet. *challenge option: calculate the wt% of each metal if the tablet is compounded by adding 5.400 grams of starch binder to the salts. this version is much more complex!

Many over-the-counter antacid tablets are now formulated using calcium carbonate as the active ingredient, which enables such tablets to also be used as dietary calcium supplements. As an antacid for gastric hyperacidity, calcium carbonate reacts by combining with hydrochloric acid found in the stomach, producing a solution of calcium chloride, converting the stomach acid to water, and releasing carbon dioxide gas (which the person suffering from stomach problems may feel as a “burp”). Write the unbalanced chemical equation for this process.

On Easter Sunday, April 3, 1983, nitric acid spilled from a tank car near downtown Denver, Colorado. The spill was neutralized with sodium carbonate: 2HNO3(aq)+Na2CO3(aq)2NaNO3(aq)+H2O(l)+CO2(g) a. Calculate H for this reaction. Approximately 2.0 104 gal nitric acid was spilled. Assume that the acid was an aqueous solution containing 70.0% HNO3 by mass with a density of 1.42 glcm3. What mass of sodium carbonate was required for complete neutralization of the spill, and what quantity of heat was evolved? (Hf for NaNO3(aq) = 467 kJ/mol) b. According to The Denver Post for April 4, 1983, authorities feared that dangerous air pollution might occur during the neutralization. Considering the magnitude of H, what was their major concern?

The units of parts per million (ppm) and parts per billion (ppb) are commonly used by environmental chemists. In general, 1 ppm means 1 part of solute for every 106 parts of solution. Mathematically, by mass: ppm=gsolutegsolution=mgsolutekgsolution In the case of very dilute aqueous solutions, a concentration of 1.0 ppm is equal to 1.0 g of solute per 1.0 mL, which equals 1.0 g solution. Parts per billion is defined in a similar fashion. Calculate the molarity of each of the following aqueous solutions. a. 5.0 ppb Hg in H2O b. 1.0 ppb CHCl3 in H2O c. 10.0 ppm As in H2O d. 0.10 ppm DDT (C14H9Cl5) in H2O

It is stated in Section 6.3 of the text that to balance equations by inspection you start “with the most complicated molecule.” What does this mean? Why is it best to do this?

You wish to prepare 1 L of a 0.02-M potassium iodate solution. You require that the final concentration be within 1% of 0.02 M and that the concentration must be known accurately to the fourth decimal place. How would you prepare this solution? Specify the glassware you would use, the accuracy needed for the balance, and the ranges of acceptable masses of KIO3 that can be used.

What mass of HCl is contained in 45.0 mL of an aqueous HCl solution that has a density of 1.19 g cm-3 and contains 37.21% HCl by mass?

Molarity is a conversion factor relating moles of solute in solution to the volume of the solution. How does one use molarity as a conversion factor to convert from moles of solute to volume of solution, and from volume of solution to moles of solute present?

3.34 In principle, it may be possible to engineer the trap- ping of carbon dioxide by a precipitation reaction with Ca(OH)2 to form calcium carbonate and water. Write the molecular, total ionic, and net ionic equations for this reaction.

What is the difference between a solute and a solvent?