9.40 The circuit shown in Fig. P9.40 is operating in the sinu- PSPICE soidal steady state. The capacitor is adjusted until the MULTISIM current i, is in phase with the sinusoidal voltage vg. a) Specify the capacitance in microfarads if vg = 80 cos 5000r V. b) Give the steady-state expression for ig when C has the value found in (a). Figure P9.40 800 mH 10 k2

Q: IpS15 = IDS18 = Ips19 = IB %3D ||

A:

Q: 5A >21x

A: We need to find out current for given circuit

Q: B M2 3 H i2 i(1) 20 H M1 M3 5 H I FIGURE 13.46 For the circuit of Fig. 13.46, M = 1 H, M2 = 1.5 H,…

A:

Q: Analysis Results in These Sequence Quantities Ve, Va, Va, Vb, Vb, Va2 = -24.1 Va0 = -5.4 s Va1 =…

A: In this question we will analysis given sequence quantities....

Q: II Revie The circuit shown in (Figure 1) contains a voltage- controlled current source. Suppose i =…

A: Given, i=1.5 A

Q: What is the frequency corresponding to a wavelength of 1 meters?

A: In this case, the frequency corresponding to a wavelength of 1 meters needs to be determined,

Q: 6-6 Multistage Amplifiers 27. Each of two cascaded amplifier stages has an A, = 20. What is the…

A:

Q: If the size of the memory is 1MB, what is the last address of the memory? A. Ох3FFFF OXFFFFF C.…

A: As per our company guidelines we are supposed to answer only first question kindly repost other…

Q: An infinite uniform line charge of 2 μClm is located on the z axis. Find E in cartesian coordinates…

A:

Q: Explain in words the relationship between m18 and m19

A:

Q: Your output port is connected to 8 LEDs.  You wish to turn on only the first, least significant LED,…

A: In this question,   We need to determine the Hex code if wish to turn on only the first, least…

Q: Explain how an oscilloscope may be use to display a current waveform.

A: The behavior of the target signal is checked using an oscilloscope, which is plotted in the x-y…

Q: inverse z-transform of Y(Z)

A:

Q: A load of 200 kW at 0.85 power factor is to pe shared by two transformers A and B aving the same…

A:

Q: 5. For the following circuit, determine v.(t) for t>0. t D0 9 k2 3 kΩ No 20 µF = % 36 V

A: To find the voltage across capacitor vo(t) for t>0

Q: 25. a. Calculate the resistance associated with the JFET of Fig. 6.22 for Ves = 0 V from Ip - 0 mA…

A: The resistance value can be obtained from the graph using the ratio of voltage to the current.

Q: Explain this diagram,What is a colpitts oscillator?

A: Oscillator: An oscillator is a mechanical or electronic device that operates on the principles of…

Q: Given are the following differential equations. Find inverse Laplace Transform of the given DE.…

A: In this question we will find solution of differential equation using Laplace transform ..

Q: 1. Solve for the current of 1+j3 ohms impedance using Kirchhoff's 0.02R 0.02 L 00

A: In this question we will find current through inductor using Kirchhoff law.....

Q: x(t) M = 1 kg K, K, = 5 N/m fy = 1 N-s/m f(t) = u(1)N M -f(t) for

A: In this question,   We need to calculate the x(t) signal.

Q: Q1//Determine the DC bias voltage VCE and the current IC for the configuration of figure (3) using…

A: In this question,   We need to determine the Value of DC biasing Q point of the BJT?.

Q: 1. What is the advantage of PPM over PWM?

A: Since multiple questions are present, as per the guidelines, in the following section, only the…

Q: G, G G3 Σ G4 G6 3, RO OY G2 G3 (b)

A: In this question we will solve given control system and will find transfer function....

Q: Given are the following differential equations. Find inverse Laplace Transform of the given DE.…

A: To find the solution of given Differential equation using Laplace transform

Q: 42. Calculate the average power delivered to the 400 mSN and 21 N resistors, respectively, in the…

A: We need to find out power delivered to given resistance .

Q: 4. A uniform volume charge density of 80 µC/m³ is present throughout the region 8 mm 10 mm, find D,…

A:

Q: Home Workse P1 Two resistors must beselected.so that the cunnt in one is our times the cucent in the…

A: Given data The given value of equivalent resistance Req = 5kΩ For calculating the value R1 and R2 we…

Q: llib s lssbi vinson worl probom tiommoo 5 Find v, in the circuit in Fig. P5 - Figure P5.5 15 kN 6V…

A:

Q: Using the convolution integral find the inverse transform of 1/s(s+2)

A:

Q: 2. Calculate inductive reactance (X) and total impedance (Z;) 3| Page Electrical Circuit Analysis…

A:

Q: 1. What is the measured residual voltage of DC machine in the experiment?

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Calculate Av and Ap

A: The required parameters can be calculated by using the DC analysis and AC analysis of the amplifier…

Q: 4. A digital low pass filter with generalized linear phase is required to meet the following…

A: Given  A digital low pass filter    a. Determine the minimum length (M) of the impulse response and…

Q: Instructions: • Write the GIVEN with their respective symbols and units. • Do not skip the…

A: It is given that: Differential equation:d2ydt2+3dydt+2y=1+tInitial Conditions:y0=0 and…

Q: 2) If a down counter has 4 flip-flops and its initial count is 6, what count will it hold after 38…

A: The solution is given below.

Q: What is a biasing circuit for a push pull amplifier?

A: It is asked discuss about the biasing circuit for a push pull amplifier.

Q: P1. 31. Given vectors A- 2j + k; B-8i + gk: C-i- 5j + 13k. Determine (AxB) C. Select one: а. 186 O…

A:

Q: region 8 mm

A: It is given that: ρ=80μCm3     8mm<r<10mm

Q: Using Boolean algebra, simplify the following Boolean expressions. X’Y’+Y’Z+XZ+XY+YZ’…

A:

Q: Using the convolution integral find the inverse transform of 1/s(s + 2). Answer: |(1 - e -2")

A: Let function Fs=1s(s+2) The Integral formula for Inverse Laplace transform is ft=∫0∞Fsestds

Q: Q1a Voltage control – fault level • A load bus (bus-L) is suppling from two different buses A & B…

A:

Q: (g) ( 1.5 (us)? , Consider the cireuit in the figure below. What is V(2) when : = I at t = t=0,…

A: According to the question, for the given transmission line circuit as shown below We need to find…

Q: O) Determine the corona characteristics of a 3-phase line 160 km long, conductor diameter 1.036 cm,…

A:

Q: Determine the output voltage, Vout when: R1 = 10000, R2 = 14110, Vref = 5V

A:

Q: 43-45 NETWORKS Find the currents in the following networks. 43. 10Ω 44. 3800 V 13 50 2 20 Ω I3 (I2…

A: In this question we will find network currents.... Note:- as per our guideline , I am.supposed to…

Q: The registers are involves in Indirect Сycle are: O MAR, MBR O MAR, MBR, IR MAR, MBR, Control unit.…

A: The indirect cycle is operated after the fetch cycle is completed in the microprocessor. The…

Q: QUESTION 20 Start here R4 l4 R Re Rs b. AV AV For the circuit above which is the correct equation…

A:

Q: (RC-circuit) Find and graph the current i(t) in the RC- circuit in Fig. 147, where R = 100 N, C :…

A: The solution is given below

Q: Q4/ A buck-boost converter generates an output voltage of range 8-14V in CCM. The input voltage is…

A:

Q: Explain how an oscilloscope may be use to display a current ww waveform.

A: Oscilloscope: An oscilloscope is a common laboratory tool for displaying and analysing the waveform…

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.