9.A semiconducting crystalwith 12 mm long, 5 mm wideand 1 mm thick has amagnetic density of 0.5Wbm-2 applied from frontto back perpendicular tolargest faces.current of 20 mA flowsWhenalength wise through thespecimen,measured across its widththevoltageis found to be 37uV. What isthe Hall coefficient of thissemiconductor?

9. From the above question data is as follows: To find Hall coefficient:VH=37 μV=37×10-6 Vt=1…

9.A semiconducting crystal with 12 mm long, 5 mm wide and 1 mm thick has a magnetic density of 0.5 Wbm-2 applied from front to back perpendicular to largest current of 20 mA flows faces. When a length wise through the specimen, measured across its width the voltage is found to be 37µV . What is the Hall coefficient of this semiconductor?

9.A semiconducting crystal with 12 mm long, 5 mm wide and 1 mm thick has a magnetic density of 0.5 Wbm-2 applied from front to back perpendicular to largest current of 20 mA flows faces. When a length wise through the specimen, measured across its width the voltage is found to be 37µV . What is the Hall coefficient of this semiconductor?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A string of 8 suspension insulators is to be fitted with a grading ring. If the pin to earth capacitances are all equal to C, find the values of line to pin capacitances that would give a uniform voltage distribution over the string.
A parallel-plate capacitor using a dielectric material having an Pr of 2.2 has a plate spacing of 2 mm (0.08 in.). If another material having a dielectric constant of 3.7 is used and the capacitance is to be unchanged, what must the new spacing be between the plates?
Determine the work done, in mJ, in moving a 8-nC charge against the electric field due to a point charge 8 mC at (1, 3, 4) m from A(-3, 0, -1) m to B(0, -4, -3) m.
Determine the boundary conditions for the tangential and the normal components of P at an interface between two perfect dielectric media with dielectric constants Er1 and Er2.
. A parallel-plate capacitor has a plate separation d and plate area A. An uncharged metallic slabof thickness t is inserted midway between the plates. Determine the:a. Find the capacitance of the device.b. Show that the capacitance is unaffected if the metallic slab is infinitesimally thin.
In a plate capacitor experiment, the percentage of error in magnitude of electric field is 3%.Then, what is the experimental value, which is lower than the theoretical value, of magnitudeof electric field, if the distance and potential difference between the plates are 10cm & 25V?
An infinitely long coaxial cable has an inner and an outer conductor of radii "a" and "b"respectively. If the space between the conductors is filled with two different dielectrics ofdielectric costants ɛ1 and ɛ2 as shwon below, find the capacitance per unit length of this coaxialcable
It is required to grade a string having seven suspension insulators. If the pin to earth capacitance are all equal to C, determine the line to pin capacitance that would give the same voltage across each insulator (C1, C2, …….C6) of the string.
Consider a pure Sn crystal that has εr = 24 and the number of Sn atoms per unit volume, N = 2.39 × 1028 m-3. What is the electronic polarizability due tovalance electrons per Sn atom? Suppose that a Sn crystal sample is electroded on opposite faces and has a voltage applied across it. By how much is the local field greater than the applied field? Given, εo= 8.85 × 10-12 F/m.
Calculate the capacitance between a 50V conducting wire and its image if the wire has a diameter of 10cm and the distance between the wire to a nearby conducting plane is 3cm in free space. *
Please discuss the "BOUNDARY CONDITION FOR PERFECT DIELECTRIC MATERIALS" in many sentences
Find the electric field (magnitude and direction) at the point P for the following 3-charge configuration, where Q= +1nC and a=2cm. Show detailed work and a free body diagram.