____ commonly find applications in tires, O-rings, gaskets, seals, hoses for automobiles and trucks, diaphragms, belts, wire insulation etc

Q: Conclusion about Hooke's Law

A: To conclude that what Hooke's Law state

Q: 8 KN SFD=? BMD=? 3m 3m v

A: Draw the load diagram and find the reactions. Consider the equilibrium of moments about point A.…

Q: What is the collapse-resistance pressure (psi) of 2.375 inch, H-40, 4.7 lb/ft external upset tubing?…

A: given : Tubing size = 2.375 inch upset = 4.7 lb/ft grade : H-40

Q: What is the contamination level of a hydraulic fluid with a range code of 18/15?

A: Controlling contamination is the most important task to ensure the reliability of the hydraulic…

Q: what is elastohydrodynamic bearings and thermo-elastohydrodynamic bearings and what is aplication…

A: Elastohydrodynamic bearing is a type of hydrodynamic lubrication in which lubrication is achieved by…

Q: B 100 lbf 10 in AC - 10 in- - 10 in- 10 in

A: P= 100 lbf

Q: Which one of the following reboiler requires more complex pipe work? Horizontal thermosyphon…

A: Horizontal thermosyphon reboiler are depends on natural circulation where in shell sides,…

Q: why bare pipe has 0% efficiency and full covered insulate pipe has more efficiency

A: A thermal insulator has a low thermal conductivity and is a poor heat conductor. To reduce heat loss…

Q: ) What would be the best instrument to use for detecting steam leaks on a superheated steam line, a…

A:

Q: a introduction for smart motorcycle jacket.

A: Given question: Introduction for smart motorcycle jacket It is related to machine design and solid…

Q: Discbrake friction linings are sometimes called brake The ratio of the force required to slide one…

A: Given questions are related to IC engines and Machine design             [Note : According to…

Q: • The gas turbine cycle combustor outlet temperature profile must be uniform. Any non-uniformity in…

A: Thermal efficiency of the turbine depends on the highest and lowest temperature in the cycle.

Q: What type of insulation is used in modern freezers? b) Which is the most sensitive detector?

A: Polyurethane rigid foam is the insulating material that is most widely used throughout the world…

Q: uestion 8 Which of these is an important design consideration in engineering design? Select one: O…

A: Solution.jpg

Q: Accumulator that could be used in hydraulic system is _______________  type of accumulator.…

A:

Q: -K-Type thermocouples were placed at multiple locations along the copper rods to mesure temperature.…

A: The thermocouple working rule is based on the Seeback Impact. This impact states that when a…

Q: State Hooke’s law in general and as applied to a coiled spring.

A: Hooke' s law  in general state that stress is directly proportional to the strain occur in body.…

Q: Q₁-(A) Compare between internal and external leakage with respect to 1- Where and when does it…

A: 1. The internal leakage of the valve is the condition that the medium still leaks from the…

Q: WHAT ARE THE WASTE OF CAR TYRE

A: The waste tire is a type of tire that is not mounted on a car or vehicle. It means that the waste…

Q: The gas turbine cycle combustor outlet temperature profile must be uniform. Any non-uniformity in…

A: According to Bartleyby's policy, we can answer 1 question at a time so if you want the solution of…

Q: What is the pressures required for safe pipeline transport of CO2?

A: In fluid mechanics, there are two types of flow laminar and turbulent. The flow which doesn't have…

Q: Pressure Transducer Basic principle of operation Application Diaphragm Capsule C-Shaped Bourdon Tube

A: Pressure transducer  converts the physical change caused by applied pressure into a voltage signal…

Q: ese refrigerants (insert number) with their properties listed below. (1) R-12 (2) R -134A (3)…

A: (1) R-12..............On its way out due to high GWP (2) R -134A................Banned by Montreal…

Q: For the manufacture of a pipe wrench would you select: a. Fe-0.4%C steel b. Fe-0.4C steel abs case…

A: Pipe wrenches are available in different sizes from 3 inches to 48 inches or larger. A pipe wrench…

Q: Damaged swaged-end fittings on a piece of flexible hydraulic hose ___________________ (can or…

A: Damaged swaged-end fittings on a piece of flexible hydraulic hose cannot  be replaced.

Q: ducted on S were taker oservations

A:

Q: On the Mindray A5/A3, what is the part number for the gasket, C02 bypass assembly. Also, when should…

A:

Q: Introduction to pneumatics

A: Pneumatics: It is the branch of science and technology of pressurized air—using piped, compressed…

Q: What are the major differences between aerobic and anaerobic sealants

A: ANSWER :- The major differences between aerobic and anaerobic sealants :- Aerobic sealants…

Q: The eyclic device can be

A: Given data; T1=1000 KT2=500 KT3=300 KQ1=Q2=Q3=100 KJ=50 KJ=60 KJ respectiveley

Q: What are the steps required to prevent noise pollution in industrial places

A: The noise pollution plays a very crucial role in the industry, it should be at the lowest level so…

Q: Choose 4 of the following locations that describe where asbestos can be found. (CHOOSE FOUR) 1)…

A: Asbestos is a special material which has high heat resistant, high wear, resistance to alkalis and…

Q: e equipment are used fill in the descriton of each item braifely in 1 or 2 senteces each

A: we have to define the function of each of these equipment in the experiment

Q: Well Completion : Tubing leaks is one of well completion problems. the causes and method(s) to…

A: Causes of tube leaks: 1.High water pressure leads to damaging wear and tear on your pipes. Water…

Q: pacitor b) evaporator c) cooling towe

A: given: This device is responsible for passing outside air over the water to remove the heat from the…

Q: lame four material properties that affect thermal shock resistance

A: Thermal Shock resistance definition:  It is defined as A material property that is thermal shock…

Q: Briefly explain how a thermocouple works in determining temperatures

A: HOW THERMOCOUPLE WORKS : Thermocouple;  Thermocouple is a device used for temperature measurement.…

Q: Which of the following is true about components of a pneumatic system such as valves, pipes, and…

A: As per given question Which of the following is true about components of a pneumatic system such as…

Q: True or False? Pipe 10 Std and Pipe 10 x-Strong will exactly same outer diameter.

A: From the table showing pipe specifications and dimensions, the outer diameter for Pipe 10 Std has an…

Q: factors affecting the force impacted by jet on defelcter

A:

Q: 1) List and describe two types of mechanical fasteners that are used when securing electrical…

A: Mechanical fasteners are the simple mechanical objects which are used during installation of any…

Q: Hydraulic hose couplings do not seal on their connecting threads. They seal on the mating of two…

A: Water-powered hose couplings don't seal on their interfacing strings.  They seal on the mating of…

Q: Which of the following is an example of structural technology? Welding The pillars running through…

A: Option b is correct.

Q: In a hot water system expansion / vent pipes are installed on the cylinder and boiler because they…

A: Given Data A MCQ given we have to choose correct option