A 0, 3 В O2 0, '1'– E E - (a) '1' (b)

Q: R. vout V1 MI NMOS vdd R2 C2 R. SINE(O 800mv) 10p (i) What is the total output voltage(dc+ac) of the…

A: We need to find out output voltage for given circuit

Q: For logic function it is necessary to find minimal form and to realize it → with contact scheme,…

A: The K-map of the logic circuit is given as Now the grouping of the K-map will be F=ABC+BD+AD

Q: Type of fuses and their discription

A: Solve the problem

Q: 17.1 What are the keys to a successful mixed-signal PCB layout?

A: Types of PCB  Single layer PCB Multi Layer PCB High frequency PCB Double layer PCB HDI layer PCB…

Q: 9. The armature of a relay working on 200 V circuit operates when the current reaches 0.24 A. It is…

A:

Q: 13. Refer to this figure. Calculate the value of VB.

A: The voltage at the base of the transistor can be calculated by using voltage divider bias.

Q: The bus bars of a power station are in two sections A and B separated by a reactor. Connected in…

A: It is given that:Based on the given information the single line diagram is drawn below:

Q: 7. What system characteristics are being considered in the final form of the design that must…

A: While designing of any equipment few standard parameters needs to be taken care such as Flexibility…

Q: 9. Two lamps of 20 and 40 candelas are 10 m apart. At what points on the straight line passing…

A:

Q: uSE A-Y impedance rans formation to find Io, I, ,, Is, Id, Is, V, V in the aruni t.

A: …

Q: B- D Figure 1- Boolean Circuit You are given the Boolean circuit in the figure above. 1) Convert…

A:

Q: B- Discuss the relationship between voltage breakdown and humidity, temperature and distance,…

A:

Q: Homework: Consider the circuit shown in Figure below with transistor parameters ß 120 and VA o. (a)…

A: The required parameters can be calculated by using DC analysis and AC analysis of the amplifier…

Q: Question 1 Impulse Response Determine vc(t), given that Vs (t) — 12 6 (t) V, R3 2000, С — 1тF R + Vs…

A:

Q: For main winding, Vm = 23 V Im 4 A %3D P = 60 w Vm Im Cos Øm =60 60 23x4 (os ¢m = (as Øm : 0.652

A:

Q: Identify each characteristic curve by the type of FET that it represents. Ip -VGS +VGs

A: For N channel JFET, the VGS voltage is negative and the saturation current IDs we obtain at Vgs.

Q: A 2.3kV, 3 phase Y-connected synchronous motor has a synchronous impedance of 0.1+j2 ohms per phase.…

A:

Q: Example 4.5 resistance of 100 2 and a full scale deflection of 10 mA into a multirange de voltmeter…

A: We need to find out resistance for given voltage range .

Q: 2. Two balanced three-phase loads are connected in parallel. Load 1 draws 20 kW at a lagging power…

A: Note :  We are authorized to answer one question at a time, since you have not mentioned which…

Q: 4. A DC voltage of 80 volts is applied to a circuit containing a resistance of 80 ohms in series…

A:

Q: A student is studying two subjects. He wants to pass in both of his subjects without studyng. Explan…

A:

Q: A corridor is lighted by 4 lamps spaced 10 m apart and suspended at a height of 5 m above the center…

A: Given  4. A corridor is lighted by 4 lamps spaced 10 m apart and suspended at a height of 5 m above…

Q: 1. A 400/800 ratio transformer has secondary winding resistance of 0.5 ohm. What is the total…

A:

Q: Q/ Mention an application an the topic 807 timization ?

A: Optimization is a process of producing good and productive results either in making products or…

Q: 2.38 Find Vs in the circuit in Fig. P2.38, if VâE = 18 V. A 3 kN B 2 kN Vs VBE 12 V E 1 k. D Figure…

A:

Q: Calculate the current through 48 Q resistor in the circuit shown. Assume the diodes to be of silicon…

A:

Q: 7. A system operates at 220 kVA and 11 kV. Using these quantities as base values, find the base…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: Example 4.5 resistance of 100 2 and a full scale deflection of 10 mA into a multirange de voltmeter…

A:

Q: Let us assume the "Triangular" signal is having amplitude X. Check the Average & RMS values are same…

A:

Q: Draw The Complete Root locus K CS+5) Gisi His)z (2+5) (1+S) S

A: The root locus can be plotted with the help of a few of the parameters and based on this the locus…

Q: Which statements correcty describe dead time and its use in practical svitching circuits configured…

A: Dead time is used to prevent the cross conduction current through the inverter leg because of the…

Q: If the base line-to-line voltage of a 3-phase system is 4kv and the base 3-phase MVA is 40 MVA, then…

A:

Q: You are working at an electric cable manufacturing plant during the summer. Your supervisor tells…

A: Given information about the coaxial cable is, Inner radius a=0.550 mm. Outer radius b=2.80 mm. We…

Q: The figure below shows five resistors and two batteries connected in a circuit. What are the…

A:

Q: Define the following: flip-flops state table state diagram excitation table characteristic table…

A: Flip flop: It is one bit storage element and it can be synchronised with clock signal. Some of the…

Q: b) The diode is to be used in the AND logic circuit shown in figure Q1b : VDD R VA VB 0 0 0 1 Vo…

A: Given: The diode is to be used in the AND logic circuit shown in the figure below: The inputs are…

Q: wha metal conduie7 a. 3/8 inch trade size b. 3/4 inch trade size c. 1/4 inch trade size d. 1/2 inch…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Analyze the given clocked sequential circuit (Expressions, State Table, State Diagram) Do DA BA BA…

A:

Q: 1-Write two examples about converting from polar form (r,0) to rectangular form (x,y) 2- Write two…

A:

Q: Calculate for the value of VL(peak). Please show your complete solution. Thank you.

A:

Q: Determine VDS for the amplifier in Figure 9-64. ID(on) = 18 mA at VGS = 10 %3D V,VGS(th) = 2.5 V,…

A: The solution is given below

Q: Example 4.5 resistance of 100 Q and a full seale deflection of 10 mA into a multirange de voltmeter…

A:

Q: What is the parameter that has been altered in FSK?

A: We need to tell about the parameters which altered in FSK

Q: uSE A-Y impedamce trans formation to find Io, I,,h, Iy, Id, If , V, V in the arunit.

A: Ra=R2.R3R1+R2+R3Rb=R1.R3R1+R2+R3Rc=R1.R2R1+R2+R3Z1=0.2065-j3.449=3.4552∠-86.573°Z2=0.0119-j0.5462=0.…

Q: Q5) Two 300KVA, 1000V, 50Hz alternators operating in parallel to supply a load of 500KW at UPF. 60%…

A: Generator: Any machine that transforms mechanical energy to electricity for transmission and…

Q: A uniform line charge of pe= (V2× 10-/6) C/m lies along the x axis and a uniform sheet of charge is…

A:

Q: If the base line-to-line voltage of a 3-phase system is 4kv and the base 3-phase MVA is 40 MVA, then…

A: Given, In a three phase system, Base line-to line voltage, VB=4 kV Base MVA, SB=40 MVA

Q: (Medium) For the closed loop control system shown below, its steady state error when subject a unit…

A: Steady State Error:  Steady-state error is defined as the difference between the desired value and…

Q: A Vcc V,o OVo RL

A: BJT: It is a semiconductor device that is used as a switching device. It has three terminal bases, a…

Q: 49. Explain carefully how the resistance test is performed on an alternator. 60. What is ineant by…

A: A generator is an electrical machine which converts mechanical energy to electrical energy. It is…