A 1-F capacitor is connected in series with a 6-ohm resistor. If the connection is energized from an 9-V DC source, determine the voltage (in volts) across the capacitor for a long time. The initial current is 100 mC.

A 1-F capacitor is connected in series with a 6-ohm resistor. If the connection is energized from an 9-V DC source, determine the voltage (in volts) across the capacitor for a long time. The initial current is 100 mC.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter24: Resistive-inductive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 1RQ: An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in...

See similar textbooks

Related questions

Q: A 3-phase, 200 MVA, 44 kV, 50 Hz synchronous generator is operating under no load and excited to giv...

A: Given, Power rating of the synchronous generator = 200 MVAVoltage rating of the generator = 44 kVXd'...

Q: A communication system uses 20 km of fiber that has a –3.1 dB/km loss characteristic.Find the output...

A: Fiber optic loss is typically expressed in terms of decibels (dB) and can be calculated as: LossdB=1...

Q: The interrupt vector for INT 16 is located at the hex physical address: 00000 00004 00016 00032 0004...

A: The interrupt vector INT 16 is located at the hex address 0x0040. The address of the various interru...

Q: Electromagnetic Theory

A: We need to transform base vector (i) a^x in cylindrical co-ordinates and find a^x.a^ϕ (ii) a^r in ...

Q: Please give a full explanation to the answer and each of the steps.

Q: What is the equation for the current Io in this circuit?

Q: A dc shunt motor runs at 900 rpm. from a 400 V supply when taking an armature currentof 25 A. Calcul...

Q: Using mesh analysis, find Ohm's law equations for V1, V2, V3, V4, V5

A: Using ohm's law in mesh 1,there is just one current I1 generating voltage V1 .Hence V1=I1×2Ω Using...

Q: V, I Y 1, 5 1

A: To determine the currents through all resistors by using Nodal Analysis.

Q: A 50 Hz 4 pole induction motor has a rotor inductance of 40 mH. Find the rotor reactance when motor ...

A: Number of poles, p=4 Speed of rotor, N=1300 rpm Inductance of rotor LR=40 mH=40×10-3H Frequency of r...

Q: A common emitter amplifier has a Avoc of -240 with re of 1ohm and RE of 100ohms. If the emitter's ...

A: e bypass capacitor shorts AC signals to the ground in a way that any AC noise that presents on a DC ...

Q: A 460 volt series motor runs at 50 rpm taking a current of 40 amperes. Calculate thespeed and percen...

A: The given motor can be shown in diagram format as

Q: Question 4. 20 2 Find steady-state expression for v, by using mesh-current method in the phasor doma...

Q: 14. If the switch would remain between positions A and B, is it likely the capacitorwill remain full...

A: For RC circuit connected with source also know as forced circuit, capacitor charges with the voltage...

Q: b) For the circuit shown in Figure3, given that Rc = 3 KO, R=1KN, V cc = 15 V, voltage %3D gain Av=1...

A: Given that it is NPN transistor with voltage gain and input voltage

Q: Indicate if the power thyristor will be on or off under the following conditions:

A: (a) The thyristor was reverse biased then a current pulse was injected into the gate. The thyristor ...

Q: A 220-volt shunt motor has an armature resistance of 0.32 ohm and a field resistance of110 ohms. At ...

A: Given Vs=220 VIa=6 ARa=0.32 Ω Calculating speed of the DC shunt motor when line current is 62 A ωm=V...

Q: Answer it I will upvote

Q: 3. The terminal voltage and current were measured for the device shown in Fig. (a). The results are ...

A: The circuit model for this device using an ideal voltage sources and a resistor, so ideal voltage sh...

Q: I would like to learn how to solve this question. If possible in a detailed way without any shortcu...

A: We are given a baseband signal x(t)=cos(10πt) which is sampled using an impulse train p(t) with a pe...

Q: a type of DC source where the characteristic output voltage has perfect unidirectional waveform and ...

A: A type of DC source where the characteristic output voltage has perfect unidirectional waveform and ...

Q: A unity feedback system has a loop transfer function K L(s) %3D s(s + 2)(s + 5)(s + 12)' a where K =...

A: The roots of the characteristic equation of a system are the system's closed-loop poles. They deter...

Q: 3. Design a CMOS compound gate that implements the following function: Y=A(B+C)D, where A, B, C, D a...

A: When both PMOS and NMOS are used to design a Boolean function , it is called CMOS compound gate desi...

Q: What is the device address used by the instruction OUT A4, AL?

Q: Choose the correct instruction that will read data in from an I/0 device. IN AL, 60 IN 60, AL OUT 60...

A: In an I/O device the command "IN" represents the input command Here IN AL,60 means that move a quant...

Q: 10 Ω The value of coupling coefficient (k) is adjusted so that the real and imaginary parts of Zab a...

A: the coupling coefficient is given by the below formula k =ML1L2 here, L1 = 25mH (given) and L2 = 1mH...

Q: Determine the maximum value of the matched filter if the input is 7(u(t)-u(t-3))

A: Determine the maximum value of the matched filter if the input is 7(u(t)-u(t-3))

Q: a) Obtain ABCD parameters using the nominal t model. b) Obtain sending voltage V, and the current I,...

Q: List 3 differences between how 3 phase induction motors and single phase induction motors work.

A: Induction motor is a widely used machine in the industry and for commercial purposes. based on the a...

Q: Given the values of VDQ and IDQ for this circuit, determine the required values of RD and RS

Q: 1. Using Nodal Analysis Method, evaluate the currents through the resistors of the circuit shown V, ...

Q: Different objects are moving on a conveyor belt. Let’s say, circular balls, square blocks and rectan...

A: The set counter value according to different sized objects’ detection is shown below:

Q: For the circuit given in figure 4, determine the following: What happens to the brightens of B, D an...

A: 1) What happens to the brightens of B, D and E when bulb C unscrewed? When bulb C is removed, Calcu...

Q: b) Obtain the output expression Y for the circuit given in Figure 2 (Write the output of each gate)....

Q: The bus admittance matrix of a power system is -j50 +j10 +j5 +j10 -j30 +j10 +j5 +j10 -j25 then the i...

A: To find the impedance of line between bus 1 and 3 from the admittance matrix of the Power system

Q: . Explain the environmental impacts of Hydropower plant?

Q: A printer is an example of a device that uses primarily transmission. simplex half duplex full duple...

A: A printer uses half-duplex transmission. In the half-duplex mode of transmission, the communication ...

Q: What are the two conditions necessary for a thyristor to begin to conduct?

Q: 2. Using Maxwell's Mesh Equation, find the current through branch AB in the circuit shown 102 30 V 1...

Q: Give output function, transition table and State diagram by analyzing the Sequential circuit shown i...

A: Given Diagram

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
Using a simple series circuit with a capacitor of capacitance C and a resistor, R connected across a battery pack with total voltage V, derive the equation governing the capacitor's voltage response (charging cycle).
Suppose that we have a 1000-pF parallel-plate capacitor with air dielectric charged to 1000 V. The capacitor terminals are open circuited. Find the stored energy. If the plates are moved farther apart so that d is doubled, determine the new voltage on the capacitor and the new stored energy. Where did the extra energy come from?
Find the total capacitance. Show complete solution and include the figures used to generate equations.
Calculate the theoretical voltages across the resistor (VR) and capacitor (VC) for 500 Hz and 1750 Hz using the 680Ω theoretical resistance, the observed capacitance, and the 5V source. Demonstrate the step-by-step process. Answer must be in Polar form.
What are the minimum and maximum values of capacitance that can be obtained by connecting four 2-μF capacitors in series and/or parallel? How should the capacitors be connected?
Suppose that we have two 100-μF capacitors. One is charged to an initial voltage of 50 V, and the other is charged to 100 V. If they are placed in series with the positive terminal of the first connected to the negative terminal of the second, determine the equivalent capacitance and its initial voltage. Now compute the total energy stored in the two capacitors. Compute the energy stored in the equivalent capacitance. Why is it less than the total energy stored in the original capacitors?
Derive the equivalent circuit for a parallel connection of ideal capacitors. Assume that the initial voltage across the paralleled capacitors is v(t0). (Hint: Sum the currents into the string of capacitors, recognizing that the parallel connection forces the voltage across each capacitor to be the same.)
The capacitor is discharged through a resistor with the resistance R = 10000 Ohm with a relaxation time of 10 ms. What is the capacitance of the capacitor? What is the charge of the capacitor after time 25 ms after the beginning of discharging if the initial charge was 20 nC?
Using a simple series circuit with an inductor with inductance L and a resistor, R connected across a battery pack with total voltage V derive the equation governing the inductor's current growth response