Answered: A 10 µF capacitor is connected in…

A 10 µF capacitor is connected in series with a 250 Q resistor across a 500 V, 60 Hz source. What is the value of power factor associated with this circuit? O a) 0.726 O b) 0.942 c) 0.684 d) Unity

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter23: Resistive-inductive-capacitive Series Circuits

Section: Chapter Questions

Problem 4PP: This circuit is connected to a 1000-Hz line. The resistor has a voltage drop of 185 V. the inductor...

See similar textbooks

Related questions

Q: Based on the figure below, choose the correct answer. y(t) 1 t-2 t-1 3 O t-21 O t- 2 >1 3 >t- 2 All…

Q: Given the information appearing in Figure 2, determine: glav a) Ie b) Rc Rc e) RB RB Figure 2 ovc =…

Q: How to interpret / read capacitor values or capacitance?

A: Concept :- A.Write down the first two digits of the capacitance. B.Use the third digit as a zero…

Q: 22. A circuit has a resonance frequency of 440HZ and a system Q of 30. Deter the bandwidth. O 13.2…

A: In this question we have given resonant frequency and quality factor...We have to find out…

Q: a)What is the value of downward current through inductor, ix(t) as a function of time? (not complex…

Q: If the applied voltage across a series RL circuit is 120V and the voltage across the resistor is…

A: The power factor can be calculated by using the power triangle or voltage triangle.

Q: 23. A circuit has a resonant frequency of 19 KHz and a bandwidth of 500 Hz. Determine the values of…

Q: Determine v, in the circuit (use superposition principle) 2 A

Q: A series R-L-C circuit is connected to a 150 V, 2 kHz source. The circuit contains: a 2.2 kQ…

Q: The base bias is commonly used in linear operation for its simplicity and B-independent feature.…

A: The stability factor S varieties from 1 to (1+β). Higher the stability factor S means higher…

Q: A sequential circuit with two D flip-flops A and B, two inputs, x and y; and one output z is…

Q: Listen An AC voltage represented by e= 170 sin377t volts is applied to a resistor resulting in a…

Q: 1.The Fourier series coefficients for the signal shown are

A: Given: Consider the following signal: To find: The Fourier series coefficients for the signal.

Q: The impedance of an R-C circuit is 250 Q. When a 100 VAC supply is applied, the current is: O a) 40…

Q: The collector current for the following stiff voltage-divider is: Vcc +10 V RC 1.0 kN 10 kN R2 5.6 k…

Q: Determine the state diagram for the D flip-flop equations given below: DA = AB' + X'A' + XA; DB =…

Q: A 3-phase induction motor has a 4-pole star-connected stator winding. The motor runs on a 50 Hz…

Q: Solve for VL and IL. R1 1 3002 D1 R2 V1 10V 1k2 20V 2 VL=Blank 1 V IL=Blank 2 mA

Q: Obtain the current that will pass through the 50 resistor by superposition theorem. Note: The 10V…

Q: Cheng From Y to A to Find CIJ for the Following Circuit. 7. Ans. I=3 Am P. 30v 3. maろ

Q: The voltage e = 240 sin(377t) volts is connected across a 20 ohms resistor. The current indicated by…

Q: The angular velocity of a 50 kHz sine wave is: O a) 2n x 105 rads/s O b) Tx 105 rads/s c) 5n x 104…

Q: A capacitor, a resistor and a 440V, 60 Hz supply are connected in series. The phase angle is 65.7°…

A: The solution is given below

Q: Explain the half adder and full adder truth tables

A: Brief description : In the above given question they are interested to know about full and half…

Q: Increasing the resistance of a series resonant R-L-C circuit will do which of the following? O a)…

Q: Problem 5: A V = 86-V source is connected in series with an R = 1.8-kΩ resistor and an L = 28-H…

Q: three-phase positive sequence Y-connected source supplies 15 kVA with a power factor of 0.75 lagging…

A: In this question parallel connected machines are given.....We have to find out magnitude of line…

Q: The light-dependent-resistor (LDR) R2 is 1M2 when it's covered and 5002 when exposed to light. Let's…

A: The circuit diagram is shown below, Here,β=100VBE(ON) = 0.7VVCE(sat) = 0.6VWhen covered, the LDR is…

Q: The transformation of this filter characteristic can be easily implemented using a single low pass…

A: The band stop filter circuit diagram is shown below,

Q: Given that the potential V = 2x²y3 + 4xyz2 Find E at (4,5,8). Give expression for pr c/mº. mv.

A: Given,Potential, V = 2x2y3+4xyz2 mVWe have to find electric field at point P4, 5, 8.

Q: Find the Laplace Transform of the following: 1. f(t)= cos? 3t

A: In this question, We need to determine the Laplace transform of the cos3 3t

Q: A base bias method is used in the following circuit. For Bpc = 100, the value of VCE is: +Vc. +15 V…

Q: For the following state table Next State Output Present State…

A: Draw the corresponding state diagram. Draw the state diagram corresponding to the reduced state…

Q: Choose the TRUE statement: A capacitor is rated according to its maximum allowable voltage and O a)…

A: Answer: a). A capacitor is rated according to its maximum allowable voltage and capacitance value.…

Q: Convert: 0.FF16 = _____________ 10

A: In this question we will convert hexadecimal to decimal.... Note :- as per our guideline , I will…

Q: Compute the current (express your answer in milli (103)) ANSWER:Blank 1

Q: Problem 3: Find the work done in moving a point charge Q = -20µC from the origin to (4,2,0) m in the…

Q: An overhead 3-phase transmission line delivers 4000 kW, 22 kV at 0.7 p.f. lagging. The length of the…

Q: For the circuit below, the de load line will intersect the x-axis at: +Vcc +15 V R 20 k2 Rc 1.8 kQ…

Q: uestion 15 Calculate VO- 10K 20K 3K 9+Vcc 3K 9+ Vcc 5V 8K 3V – Vcc Vo 2V 8K - Vcc

Q: Using Kirchhoff's Law, find the individual voltage of each resistors. R1 - R3 + + А 10k2 5.6kQ R2…

Q: 25 V 55 V + 3Ω 6Ω

Q: The voltage at the base of the transistor for the following stiff voltage-divider is: Vcc +10 V R1…

Q: In what ways may the Instrusion detection and prevention system be used to reduce the hazards of…

A: Intrusion detection and prevention system is used as no one can enter our system with malicious…

Q: Write about the uses and importance of twisted pair cable - crossover cable

A: Twisted pair cable :- These cables have two questions insulated conductors which are generally made…

Q: 7.32 For a 0.18-um CMOS fabrication process: Vm = 0.5 V, Vp = -0.5 V, u„Cox = 400 µA/V?, upCox 100…

A: Given For a 0.18-um CMOS fabrication process: V-0.5 V. Vp0.5 V. Car 400 μA/V², Car = 100 µA/V², V…

Q: ToR ths Given CircuiT Finro 2,(t

Q: Q2. 3. Determine the dot product of two vectors if the magnitude of the first vector is equal to 8v6…

Q: Q2. 5. Given vectors P = 4i - 2j - 5k : Q = -i + 3j - 6k : find QxP. Select one: O a. -3i -19j + 1ok…

Q: Solve for VL and IL. R1 ... 3 1 3002 D1 R2 V1 10V 1kQ 20V

A: In this circuit diagram, the zener diode voltage is 10 volts and it is in parallel with the load…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

A 10 µF capacitor is connected in series with a 250 Q resistor across a 500 V, 60 Hz
source. What is the value of power factor associated with this circuit?
O a) 0.726
O b) 0.942
O c) 0.684
O d) Unity

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 concept

VIEW

Step 2 calculation

VIEW

Step 3 final answer

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having values of 2.2 F, 280 F, and 470 pF are connected in parallel. What is the total capacitance?
This circuit is connected to a 1000-Hz line. The resistor has a voltage drop of 185 V. the inductor has a voltage drop of 740 V, and the capacitor has a voltage drop of 444 V. The circuit has an apparent power of 51.8 VA. ETITZVA51.8PFER185VIRRPEL740VILXLVARsLLEC444VICXCVARsCC
Fill in all the missing values. Refer to the formulas that follow. Resistance Capacitance Time constant Total time 150 k 100 F 350 k 35 s 350 pF 10 s 0.05 F 1.2 M 0.47 F 12F 0.05 s 86 k 1.5 s 120 k 470 pF 250 nF 100 ms 8 F 150 s 100 k 150 ms 33 k 4 F =RCR=CC=R Totaltime=5
Two capacitors having values of 80 F and 60 F are connected in series. What is the total capacitance?
The circuit is connected to a 60-Hz line. The apparent power in the circuit is 29.985 VA, and the power factor is 62.5%. The resistor has a voltage drop of 14.993 V, the inductor has an inductive reactance of 60 , and the capacitor has a capacitive reactance of 45 . ETITZVA29.985PF62.5%ER14.993VIRRPELILXL60VARsLLECICXC45VARsCC
Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
What is the minimum KVAR rating of each capacitor in Question 11? (Round off the value to the nearest KVAR.)
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
In an R-L parallel circuit, ET=240 volts, R=560 R = 560 2, and XL=330. Find reactive power.